Answered: A transformer has a reactive drop of 6%…

A transformer has a reactive drop of 6% and a resistive drop of 2.5%. Determine the lagging power factor at which the voltage regulation is maximum and the value of this regulation. [0.385 lag]

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.4MCQ: An ideal transformer has no real or reactive power loss. (a) True (b) False

See similar textbooks

Related questions

Q: Consider a transformer with a primary coil consisting of 1490 turns and a secondary coil of 1900…

A: Given in the question: Turns in the primary winding = N1 = 1490 Turns in the secondary winding, N2 =…

Q: How does change in frequency affect the operation of a given transformer? with a decrease in…

A: Transformer:

Q: Q1// What is the purpose of conducting experiments (o.c) and (s.c) on asingl- nhase transformer?

A: TRANSFORMER: The transformer transfers power from one circuit to another circuit without a change…

Q: Discuss the relationship between the operating frequency and the transformer size? Through your…

A: Considering the EMF equation of the transformer, E=4.44×f×Bm×N×A Here, E is emf, f is frequency, Bm…

Q: low shows the circuit diagram of the linear variable differential transformer (LVDT). Figure The…

A: LVDT (linear variable differential transformer ) is a passive inductive transducer which requires an…

Q: With base MVA of 150 and base voltage of 33. If the reactance of the transformer is 0.23 pu. The…

A: Base MVA S= 150MVA Base voltage VB = 33kV Reactance per unit = 0.23 Reactance?

Q: Q-3 A Cockcroft-Walton type voltage multiplier has ten stages with capacitances, all equal to 0.1…

A: Given, Cockroft walton generator with Vs=100kV n=10, I=5mA, C=0.1μF, f=60Hz 1)The percentage ripple…

Q: dabull (CME 446) 1 If F3=0.1 and Z3=45 Q, then the impedance of the next stage in the multi-section…

A: Given: Γ3=0.1Z3=45 Ω

Q: A single-phase transformer has a voltage ratio on open circuit of 7900/660 V. The primary and…

A: Transformer: It is a static device that is used to step up and step down the voltages.

Q: The primary of a certain transformer takes 1 A at a power factor of 0.4 when connected across a 230…

Q: 1) Calculate the maximum RMS current in p.u. that guarantees the equality of losses between the…

A: Given : KVA rating is 400 KVA PCP=6% Find the RMS value of current in PU For 12 pulse converter…

Q: A single phase 200/200 V ,55HZ transformer has an efficiency of 98% at full- load. Determine the…

A: for transformer output frequency = input frequency. and voltage regulation = no load voltage-full…

Q: primary of a certain transformer takes 1 a at a power factor of 0.4 when it is connected acrossa…

A: Primary current: It is a current that flows on the primary side of the transformer.

Q: For the given circuit below, a step down transformer gives an RMS voltage of 230 V/ 16.7-0- 16.7 V…

A: Given, RMS voltage = 230V/16.7-0-16.7 V load resistance = 2.2 kilo-ohm

Q: Determine the regulation of a transformer in which the percentage resistance drop is 1% and the…

Q: a. The primary of a certain transformer takes 1 A at a power factor of 0.4 when connected across a…

A: (a) Part (i) Consider the transformer is on open-circuit. Draw the circuit diagram of an equivalent…

Q: What is the relationship between primary induced emf( E1) and applied voltage (V1) of a Transformer?…

A: The relationship between primary induced emf( E1) and applied voltage (V1)

Q: Deduce the emf equation of a transformer. Prove that the emf induced in the windings of a…

Q: ing is proportional to the current in that winding because (a) Ohm's law applies to magnetic…

A: In a transformer the leakage flux of each winding is proportional to the current in that winding…

Q: 7. The primary of a single-phase transformer takes 1 A at power factor of 0.4 when connected to a…

A: In the question, Primary current Ip = 1A at 0.4PF logging with secondary side open. Secondary side…

Q: Draw the scheme of a single-phase transformer with two secondary windings and mark the main symbols…

A: Transformer: A transformer is a electrical equipment whose main purpose is to transfer electrical…

Q: The efficiency of a transformer at load 0.8 p.f. Lag is -- at load 0.8 p.f. Lead * equal less than…

A: When transformer work at lagging power factor the flux in secondary of transformer is demagnetizing…

Q: Q2/3-phase.E.W.C. R using center tap transformer supplies highly inductive load, find: 1. The…

Q: A 250/125 V, five kVA single-phase transformer has a primary resistance of 0.2 ohms and reactance of…

A: Introduction: Voltage regulation: The voltage regulation of a transformer is the percentage change…

Q: Design a flyback converter for an input of 24 V and output of 40 W at 40V. Specify the transformer…

Q: Some power devices have bidirectional current capability Select one: O a. True O b. False The…

A: Some of the power semiconductor Devices: Diode BJT, MOSFET,GTO SCR IGBT

Q: A 1,000/200 V transformer takes 0.3 at p.f. of 0.2 on open circuit. Find the magnetising, and iron…

Q: Efficiency at full-load and half the full-load at 0.8 p.f. lagging current. Equivalent reactance…

A: Open circuit reading given: VNL=220 VINL=4.2 APNL=148 W Equivalent diagram of open circuit can be…

Q: The primary ofa certain transformer takes 1 A at a power factor of 0.4 when connected across a 230…

Q: Q5. For the following center tapped transformer, show the waveform across each half of the secondary…

A: An device which convert alternating signal in to pulsating direct signal. The half wave rectifier…

Q: In a transformer that has 10 times more turns on the secondary side (side 2) than on the primary…

A: The above question is based on the EMF equation of a transformer.

Q: The full-load efficiency of transformer at 0.85 lagging p.f. is 97%. Its efficiency at full load…

A: The efficiency for a leading or lagging remains same.

Concept explainers

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.

Question

A transformer has a reactive drop of 6% and a resistive drop of 2.5%. Determine the lagging power factor at which the voltage regulation is maximum and the value of this regulation.
[0.385 lag]

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 6 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Consider an ideal transformer with N1=3000andN2=1000 turns. Let winding 1 be connected to a source whose voltage is e1(t)=100(1| t |)volts for 1t1ande1(t)=0 for | t |1 second. A2- farad capacitor is connected across winding 2. Sketch e1(t),e2(t),i1(t),andi2(t) versus time t.
An ideal transformer has no real or reactive power loss. (a) True (b) False
In a transformer that has 10 times more turns on the secondary side (side 2) than on the primary side (side 1), the magnitude of the voltage/EMF across the windings on the secondary side, E₂ will be... O a.... 10 times lower than the voltage/emf on the primary side, E₁. O b.... the same as the voltage/emf on the primary side. O c.... always zero regardless of the voltage on the primary side, E₁. O d.... 10 times higher than the voltage/emf on the primary side, E₁.
I need the answer at 20 minute
The primary ofa certain transformer takes 1 A at a power factor of 0.4 when connected across a 230 V, 50 Hz supply and the secondary is on open circuit. The number of turns on the primary is twice that on the secondary. A load taking 50 A at a lagging power factor of 0.8 is now connected across the secondary. Sketch, and explain briefly, the phasor diagram for this condition, neglecting voltage drops in the transformer. What is now the value of the primary current?
Efficiency at full-load and half the full-load at 0.8 p.f. lagging current. Equivalent reactance referred to primary & referred to secondary..........ohm , ..........ohm Equivalent resistance referred to primary & referred to secondary..........ohm , ..........ohm Regulation of transformer at 0.5 p.f. lagging current The magnetizing current and reactance component of no-load are.........amper , .........ohm The working current and resistance component of no-load are.........amper , .........ohm *
Topic- basic & const.
A 250/125 V, five kVA single-phase transformer has a primary resistance of 0.2 ohms and reactance of 0.75 ohms. The secondary resistance is 0.05 ohm and reactance of 0.2 ohms.a) Determine its regulation while supplying full load on 0.8 leading p.f.b) The secondary terminal voltage on full load and 0.8 leading p.f.Ans.: -0.4.88%; 131.1
With base MVA of 150 and base voltage of 33. If the reactance of the transformer is 0.23 pu. The parameter of the reactance of the transformer in the Neplan software is O 1.66 2.30 23 0.23 O Non of them
A voltage multiplier has 12 stages Capacitances, all equal to 0.08 μF. Thesupply transformer secondary voltage is 150 kV at a frequency of 100 Hz. Load current 0,006A.What is the percentage ripple, the regulation and the optimum number of stages for minimumregulation or voltage drop.
The full-load efficiency of transformer at 0.85 lagging p.f. is 97%. Its efficiency at full load 0.85 leading power factor will be *
Determine the regulation of a transformer in which thepercentage resistance drop is 1% and the percentagereactance drop is 5% when the power factor 0.8 leading.