The primary ofa certain transformer takes 1 A at a power factor of 0.4 when connected across a 230 V, 50 Hz supply and the secondary is on open circuit. The number of turns on the primary is twice that on the secondary. A load taking 50 A at a lagging power factor of 0.8 is now connected across the secondary. Sketch, and explain briefly, the phasor diagram for this condition, neglecting voltage drops in the transformer. What is now the value of the primary current?

Q: Design a lo power transformer to be used in a wind turbine for the following specifica tions: 1-…

A: To need to design a power transformer that is to be used in a wind turbine for the following…

Q: A single phase transformer has turns ratio of 4. The resistance and reactance of the primary winding…

A:

Q: A 50 Hz, Scott connected transformer supplies an unbalanced two phase load at ( 400 V) per phase.…

A:

Q: 1. A 2.4-kVA, 2400/240-V, 50-Hz, the step-down transformer has the following parameters: : RH =…

A: Rated kVA is  kVA.Induced EMF ratio is  V.The high voltage to low voltage winding turns ratio is…

Q: The circuit diagram of a wye wye transformer is shown below. It has a neutral to ground resistor in…

A: A wye-wye transformer, also known as a star-star transformer, is a type of three-phase transformer…

Q: 1. An ideal transformer with a 450 turn primary connected to a 600 V, 60 Hz supply line needs to…

A: Number of turns in primary N1=450. Primary voltage V1=600 V. Secondary voltage V2=240 V. Load…

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.