The primary of a certain transformer takes 1 A at a power factor of 0.4 when connected across a 230 V, 50 Hz supply and the secondary is on open circuit. The number of turns on the primary is twice that on the secondary. A load taking 50 A at a lagging power factor of 0.8 is now connected across the secondary. Sketch, and explain briefly, the phasor diagram for this condition, neglecting voltage drops in the transformer. What is now the value of the primary current?

Q: Design a lo power transformer to be used in a wind turbine for the following specifica tions: 1-…

A: To need to design a power transformer that is to be used in a wind turbine for the following…

Q: 1. A 2.4-kVA, 2400/240-V, 50-Hz, the step-down transformer has the following parameters: : RH =…

A: Rated kVA is  kVA.Induced EMF ratio is  V.The high voltage to low voltage winding turns ratio is…

Q: Consider the circuit in the figure below: a) What are the benefites of using the transformer in this…

A: Cut in voltage of silicon diode is 0.7V and cut in voltage of germanium diode is 0.3V. During…

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.