A transformer connected to a 120V .C A source (effective value) must provide 13,000 V (effective value) for a noon ad. To prevent the risk of shock, a fuse is inserted into the primary circuit; the fuse must fuse if the effective current exceed the value of 8.50 mA in secondary. (a) What is the ratio between the number of spirals and the number of secondary turns of this transformer? (b) What is the power supplied to the transformer when the effective current in the secondary is 8.50 mA? (c) What should be the maximum current of the fuse inserted in the primary circuit?

Q: Question 2 A single phase 50 Hz core type transformer has rectangular cores 30 × 20 cm. and the…

A: The objective of the question is to find the number of turns per limb on the high and low voltage…

Q: A 200/100 V, 50 Hz transformer is to be excited at 40 Hz from the 100 V side. For the exciting…

A: Excitation current = E/X

Q: Question 10 Not yet answered Marked out of The results from the DC test of a single phase…

A: Given the result from dc test of single phase transformer, DC Volatge, Vdc=14 V.DC Current, Idc=1.5…

Q: Question 5 An ideal transformer is one which has Not yet answered No losses and magnetic leakage…

A:

Q: Answer by true or false * True False while conducting short- circuit on transformer the low voltage…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Below is a time current curve (TCC), showing the damage curve of a transformer. Draw (roughly),…

A: TCC- Time Current Curve is a plot shows the overcurrent device's interruption time which is based on…

Q: I need the answer quickly

A: Step 1   Solving for given transformer A, aA=6600440aA=15 Given low voltage side is short circuited,…

Q: The transformation ratio based on the induced voltages is: 919.8 91.98 9.198 10

A:

Q: Flag this question for future reference What is the test that can be conducted in the laboratory to…

A: In this question we have to determine in which test transformer impedance drops are dependent on…

Q: 2300V to 230V step down transforme ave the following resistances and induc Re' =0.093 ohm Re" =…

A:

Q: Question 2: A transformer has 420 turns of the primary winding and 90 turns of the secondary…

A: Given data, The value of number of turns in primary winding is N1 = 420 The value of number of…

Q: A 3-phase 100OKVA, 11000/416 transformer is delta-connected on the primary and star connected on the…

A: A transformer is an electrical machine which is used in AC circuit to either step up or step down…

Q: Certain transformer has full-load copper losses of 500 W. What is value of copper loss at half load:…

A: Given data: Pc1=500 W

Q: losses =los ses 1. Maximum efficiency of transformer is when 2 At maximum effciency load current l2=…

A:

Q: The various types of errors in dynamometer wattmeters are A./Error due to Eddy currents B./Error…

A: The solution is given

Q: Determine the PIV, turns ratio, the maximum output voltage as well draw the output wave form of the…

A:

Q: Under what circumstances the power transformer will act as a source of harmonic? Rated load contion…

A: Correct option is saturation condition we know that motors and transformers become source of…

Q: Figure Q1 shows a transformer core that has the primary winding (Np) of 500 second winding (N,) of…

A: Introduction: A transformer is a device that steps up or steps down the level of voltage without…

Q: Refer to Figure I on Worksheet I, to answer numbers 18 through 27 based on the fact that it is a…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Three-phase, 50 Hz 34500/10500 T/S ​​connected transformer single-phase visible on the side of the…

A: There is confusion in the transformer connection T/S it would be D/S that is delta-star. Hence,…

Q: 2,99 A 200/100 V, 50 Hz transformer is to be excited at 40 Hz from the 100 V side. For the exciting…

A: According to the question we have to find the value of applied voltage.

Q: What is the condition for the maximum efficiency of the transformer?

A: A transformer is an electrical machine that is used in an AC circuit to either step up or step down…

Q: For problem 1-3, consider Figure 1. 2:1 120 Vrms ooooo rellle D. 84.9 V 2. The dc voltage at the…

A: We need to analyse the given half wave rectifier circuit

Q: Question: 120 V AC 60 Hz 10:1 00000 0000000 ao do Ok 0.7V 41. C HI. 41. The diagram on the left is a…

A:

Q: Determine the sources of harmonics produce in a provided power system circuit shown in Figure 6.…

A: Given Data:A transformer-fed, single phase, full wave, diode bridge rectifier with,A filter…

Q: B- the eddy current losses of 400V, 50 Hz transformer is 1600W and the total iron losses i 2500W.…

A: Transformer Transformer is a static electrical device which transfers power from one circuit to…

Q: A 3-phase 10OOKVA, 11000/416 transformer is delta-connected on the primary and star connected on the…

A: A transformer is an electrical machine which is used in AC circuit to either step up or step down…

Q: If the turn ratio of a step-down transformer is 30:1 and the no-load primary current is 1.25 A, the…

A: Given:  Transformer primary turns, n1= 30 Transformer secondary turns, n2= 1 No load primary current…

Q: what is the purpose of using Isolation Transformer (Pulse Transformer)

A: Transformer which produces electrical pulses with high velocity, as well as stable amplitude, is…

Q: 1. Why the iron losses are constant & copper losses are variable in the transformer?

A: TRANSFORMER: The transformer transfers power from one circuit to another circuit without a change…

Q: Write a conclusion to the different circuit.

A: Three different circuits are 1) Half wave rectifier 2) center tapped rectifier 3) bridge rectifier…

Q: Transferred surge current method is used to find a. Fault in the transformer insulation b. Fault in…

A: Given  Transferred surge current method

Q: If a transformer is to be taken out for maintenance, as an engineer, outline the switching sequence…

A: Switching sequence – To turn on or off a bus bar, equipment, power plant requires expertise and…

Q: A voltage transformer in Figure 8 has 1,500 turns of wire on its primary winding and 500 turns of…

A: The number of turns on the primary side, The number of turns on the secondary side, The voltage…

Q: What way the two electrical circuits are linked in transformer to change the values of alternating…

A:

Q: choose in the given losses changes with the load in the transformer? Option 1: None of these Option…

A: Consider that the losses in the transformer are the core loss and the copper loss.

Q: A 100/500 V, 1 KVA, 50 Hz transformer was put through open and short-circuit tests to find its…

A: Given: A 100/500 V, 1 KVA, 50 Hz transformer was put through open and short-circuit tests to find…

Q: Fae number of parallel paths and the number of series conductrs required for a given kW reting are…

A: Number of parallel path and number of series conductor are required to?

Q: QUESTION 4 A real transformer has 1500 turns on the primary and 2000 turns on the secondary. Rp =…

A:

Q: Due to the increase in load, what change you saw in the transformer’s output power and the…

A: Electrical machines can be either generator or motors and transformers. They can be either Ac…

Q: QUESTION 5 A real transformer is connected to a 120V RMS supply voltage on the primary and a…

A: The solution is given below

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.