A three-phase Y-connected four-pole winding is installed in 24 slots on a stator. There are 40 turns of wire in each slot of the windings. All coils in each phase are connected in series. The flux per pole in the machine is 0.060 Wb, and the speed of rotation of the magnetic field is 1800 r/min. (a) What is the frequency of the voltage produced in this winding? (b) What are the resulting phase and terminal voltages of this stator

Q: ring rotates around the y-axis in a magnetic field B=B0sinwt ax Wb/m2. The voltage induced in the…

A: We need to select correct option.

Q: For the magnetic circuit shown in the figure, the iron core with N = 500 turns -Magnetic…

A: According to question: The cross sectional area is calculated as ∵a=πD24⇒a=π1×10-224⇒a=7.854×10-5m2…

Q: A coil that con sists of 450 windings is wound around a bakelite rin g. The mean diameter of the…

A: We are authorized to answer only 1 question at a time since you have not mentioned which question…

Q: The maximum speed of an alternator working at 60 Hz is possible when the number of poles of the…

A: In this question , alternator operation frequency is given..We have to determine no of poles for…

Q: 4. A three-phase A-connected six-pole winding is installed in 36 slots on a stator. There are 150…

A: Introduction A three-phase delta-connected system is a type of electrical power distribution…

Q: The "Ohm's law" for the magnetic circuit states that the net magnetomotive force (mmf) equals the…

A: According to the equation of the Ohm’s law for the magnetic circuit:

Q: False True Q1 In closed series magnetic circuit, the flux concentration in these parts will be low…

A: For part 1 question, In a closed series magnetic circuit, the flux concentration in these parts will…

Q: A d.c. generator running at 25 rev/s, generates an e.m.f. of 150 V. Determine the percent- age…

A: Given data, Speed,  N1=25 rev/s = 25×60=1500 RPMN2=20 rev/s=20×60 = 1200 RPM EMF of generator E1=150…

Q: An iron core is most often used in an AC transformer to 1.provide a better coupling between the…

A: An AC transformer is a device used to transfer electrical energy between two or more circuits…

Q: A single-phase 111-V, 50-Hz supply is connected to a coil with 200 turns of a coil-core assembly as…

A: Given- Single-phase 111-V, 50-Hz supply, E=111 V, Frequency f=50 Hz, Number of turns N=200, To Find-…

Q: A dc 4 pole lap wound generator is running at 10o00 rpm having 1200 conductors and flux density is…

A: Given  Pole P=4 lap A= P=4 N=1000 rpm Z=1200  φ= 10mwb

Q: Iron losses in a DC machine are independent of variations in

A: The explanation is as follows.

Q: A DC generator with 8 pole, duplex lap winding excited with a flux of 3mWb/ pole. The number of…

A: Given: A DC generator with number of pole, P=8. Multiplexity of lap winding, m = 2 (duplex winding).…

Q: flux of 0.5 Weber flows through a core with a total reluctance of 60,000 ampere-turns/Weber. How…

A:

Q: We may attach more than 2 winding to a magnetic core to generate different levels of voltage and it…

A: A multi windings transformer can have more than one primary and more than one secondary windings.…

Q: 3. A group of electromagnets that create flux in a d-c generator (the field circuit) has an…

A:

Q: 4-Is the residual magnetism on the generator is necessary how can you cancel these residual…

A: The residual magnetism in the generator is necessary because it helps in the voltage build-up of the…

Q: The generated emf

A:

Q: There are 72 slots in a 3-phase, 8-pole, 50 Hz, star connected alternator. There are 2 conductors in…

A:

Q: In a 2 pole lap winding dc machine , the resistance of one conductor is 2Ω and total number of…

A: Given: A dc machine has, Total number of pole, P = 2. Resistance of one conductor, r = 2 Ω. Total…

Q: The physical construction of two pairs of magnetically coupled coils is shown. Assume that the…

A: (a) The magnetically coupled coils are shown below: As per the direction of the fluxes, there are…

Q: There are 144 slots in a 3-phase, 16-pole, 50 Hz., star connected alternator. There are 4 conductors…

A:

Q: A 3-phase, 6-pole, 60-Hz, Y-connected AC generator has a stator with 48 slots, each slot contains 20…

A:

Q: In a certain magnetic circuit, the core is represented two reluctances as shown below. Assume a…

A: The magnetic circuit diagram is shown below, Number of turns, N=640 turns.Current, I=2.2 A.

Q: The voltage induced in 8 poles lamp wound generator is 120 V with armature resistance = 0.3 2. What…

A:

Q: Which of the following statements are true? I-If an alternating current is applied to a winding, an…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: If a voltage with RMS values of 220 and freq of 60 Hz is applied to a coil with 250 turns, find…

A:

Q: For a magnetic circuit used in an electric machine, flux generated is 0.25mWb and reluctance is 3.9…

A: Given: A magnetic circuit used in an electric machine having, Flux generated, φ=0.25 mWb. Reluctance…

Q: magnetiec core the relative permeability for metal is 5000 have a gap is 0.5 cm and cross secation…

A:

Q: 7 a. Draw and explain magnetic Hysteresis curve. b. What is dot convention for magnetic circuits?…

A: Electrical machines can be either generator or motors. They can be either Ac machines or DC…

Q: Find whether the given statements are true or false, and do justify the following statementThe…

A: According to the question, we need to find whether the given statement is true or false."The…

Q: A 3-phase, Y-connected, AC generator has a stator with 120 slots, each slot contains 15 conductors.…

A: Principle of Machine: In any electrical machine either it's a DC machine or AC machine, the EMF in…

Q: A 3-phase, Y-connected, AC generator has a stator with 60 slots, each slot contains 120 conductors.…

A: Need to find the number of turns per phase

Q: A 4-pole DC generator runs at 650 rpm and generates an EMF of 200 V. The armature is wave wound and…

A: Given a DC generator with, Rated emf, E = 200 V Total number of pole, P = 4 Speed, N = 650 rpm Wave…

Q: A solenoid has a magnetic reluctance of 2.2 x 10-3. It has 300 turns and a core area of 5 sq. cm.…

A:

Q: A four-pole dc generator has a wave-wound armature containing 48 slots with eight conductors per…

A:

Q: u, = 2500, and aܕ ln a certain magnetic circuit, the core is represented two reluctances as shown…

A:

Q: Q9 / What are the function of brushes , pole and commutator in DC machine

A:

Q: A 3-phase, 6-pole, Y-connected, AC generator has a stator with 48 slots, each slot contains 60…

A: In this question we will find synchronous generator electrical and mechanical frequency in rad per…

Q: 4. A d.c. generator running at 25 rev/s generates an e.m.f. of 150 V. Determine the percentage…

A: It is given that:

Q: The flux per pole of a two-pole generator is 7.5x10^-5 wb. A coil of 600 turns rotates in this…

A: Given Data:-ϕ=7.5×10-5 wbZ=600 turnstime take from maximum  to one minimum =0.0187 sec

Q: A single-phase 111-V, 50-Hz supply is connected to a coil with 200 turns of a coil-core assembly as…

A: Given- A Single phase transformer with, Single phase supply voltage, e=111 V. Frequency, f=50 Hz.…

Stator and Rotor Magnetic Field

The stator and rotor magnetic field is the resulting magnetic field generated by a system of coils that are symmetrically aligned. They are supplied with polyphase currents. The magnetic field is generated by poly-phase (two or more phases) current or single-phase current. In the latter case, two field stator windings are supplied and two resulting electromagnetic fields are generated beyond the stage.