A DC generator has eight poles, wound as lap then rewound as a wave, calculate the electrical motive force generated in each case if you know that the number of conductors in the armature slots is 240. The magnetic flux of each pole 0.04 Wb. It runs at 1200 rpm

A DC generator has eight poles, wound as lap then rewound as a wave, calculate the electrical motive force generated in each case if you know that the number of conductors in the armature slots is 240. The magnetic flux of each pole 0.04 Wb. It runs at 1200 rpm

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter3: Magnetic Starters

Section: Chapter Questions

Problem 18SQ

See similar textbooks

Related questions

Q: Determine the total flux

A: Given data l = 300 mm = 300 * 10-3 m N = 360 turns i = 1.75 A d = 20 mm μo = 1100

Q: 1.Consider the magnetic core below.All dimensions are shown on the figure. The core is made up of…

Q: Iron losses in a DC machine are independent of variations in

A: The explanation is as follows.

Q: Find the pull exerted on the plunger of an electromagnet when the total flux is 381 uWb. The…

Q: Calculate the MMF when the magnetic flux is 5Wb and the reluctance is 3A/Wb. O a. 15AT O b. 10N C.…

A: Given, Flux, ϕ=5 Wb Reluctance, R=3 A/Wb

Q: A coil of wire with an average length of 20 cm moves through a magnetic field. The flux is cut with…

A: The solution is given below

Q: 3. A group of electromagnets that create flux in a d-c generator (the field circuit) has an…

Q: How many parallel paths does the armature of the generator have?

Q: A three-phase Δ-connected six-pole winding is installed in 36 slots on a stator. There are 150 turns…

Q: The generated emf

Q: A three-phase Y-connected four-pole winding is installed in 24 slots on a stator. There are 40 turns…

Q: A 3-phase, 6-pole, 60-Hz, Y-connected AC generator has a stator with 48 slots, each slot contains 20…

Q: The voltage induced in 8 poles lamp wound generator is 120 V with armature resistance = 0.3 2. What…

Q: A magnetic ring has reluctance of 1.675 x 106 AT weber. The flux to be produced by the coil is 800 x…

A: Given a magnetic ring has, Reluctance = 1.675×106 ATweber Flux = 800×10-6 weber.

Q: four pole machines generates 250V when operated at 1500 rpm. If the flux per pole is 1.85 x 106…

Q: Draw the electrical circuit analog for the magnetic circuit shown below. Pay special attention to…

A: According to right hand thumb rule find the polarity of the mmf sources . Then find the analog…

Q: A dc machine has hysteresis loss of 300 W and an eddy current loss of 200 W when running at 1200…

A: Hysteresis loss Wh=300 W eddy current loss We=200 W The speed is N=1200 rpm Total core loss…

Q: A 3-phase, 4-pole, 400-Hz, Y-connected AC generator has a stator with 48 slots, each slot contains…

A: In this question we will find speed of rotation of stator magnetic field in RPM...

Q: The flux per pole of a two-pole generator is 7.5x10^-5 wb. A coil of 600 turns rotates in this…

A: Given Data:-ϕ=7.5×10-5 wbZ=600 turnstime take from maximum to one minimum =0.0187 sec

Q: The reluctance of a non-magnetic circuit is 14 units. How much flux will be set up if surrounded by…

A: In this question, The reluctance of a non-magnetic circuit is 14 units. How much flux will be set…

Q: electromotive force created by a direct current generator is proportional to Flux/pole…

A: We need to tell about generated emf . We know direct formula for emf .

Q: A four pole, 1200 rpm DC lap wound generator has 1520 conductors. If the flux per poles is 0.01 Wb.…

A: Given: DC lap wound generator having P=4N=1200Z=1520ϕ=0.01 Wb

Q: A three-phase four-pole winding is installed in 12 slots on a stator. There are 40 turns of wire in…

A: Principle of Machine: In any electrical machine, either it's a DC machine or AC machine, the EMF in…

Q: 34. A three-phase, Y-connected, four-pole winding is installed in 24 slots on a stator. There are 40…

Q: A magnetic circuit with a cross-sectional area of 20 cm? is to be operated at 50 Hz from a 120 V rms…

A: Given values are - AreaA=20cm2=20×10-4m2f=50HzVRMS=120VoltBm=1.8T

Q: 3. What generates the rotating magnetic field on the stator?

A: The rotating magnetic field on the stator us produced by:

Q: The length of a magnetic circuit in a moving iron instrument is 300mm. The coil around the soft-iron…

A: Given data length of a magnetic circuit in a moving iron instrument l = 300mm = 0.3 m Turns = 360 I…

Q: A DC generator has eight poles, wound as lap then rewound as a wave, calculate the electrical motive…

Q: The strength of the rotating magnetic field in a three phase induction motor is equal to times the…

A: rotating magnetic field of the induction motor rotates at a synchronous speed.

Q: A dc machine has 4-pole, wave wound armature with 46 slots and 16 conductors per slot. If induced…

Q: Q2. A 4-pole, wave-wound armature has 72 slots with two coil-sides per slot, each coil has four…

A: DC machine Find the induced emf? Given parameters

Q: =. A 4-pole, lap-wound armature has 144 slots with two coil sides per slot, each coil having two…

A: Given, Number of poles, P=4 Lap wound, A=P=4 Slots, S=144 with 2 coil sides per slot and each coil…

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

A DC generator has eight poles, wound as lap then rewound as a wave, calculate the electrical motive force
generated in each case if you know that the number of conductors in the armature slots is 240. The magnetic
flux of each pole 0.04 Wb. It runs at 1200 rpm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The voltage induced in 8 poles lamp wound generator is 120 V with armature resistance = 0.3 2. What will be the terminal voltage at a load = 3.6 A when the machine is rewound as a wave?
The strength of the rotating magnetic field in a three phase induction motor is equal to times the flux produce ...... ....... in one of the phase windings. 1.25 1 O 1.5
A separately excited DC generator has six poles and is running at 1150 rpm. The armature has 120 slots with 8 conductors per slot and is connected as wave winding. The generated voltage in each conductor is 1.5 V and each conductor can carry a full load current of 4 A. What is the output power?
A four pole machines generates 250V when operated at 1500 rpm. If the flux per pole is 1.85 x 106 maxwell, the number of armature slots is 45 and the armature winding has two parallel paths. If the speed of the generator is reduced to 1350 rpm, what would be the generated voltage. To what value of flux per pole should the excitation be adjusted if the generated voltage is to remain the same at 250V
4. A 4-pole, lap-wound armature has 144 slots with two coil sides per slot, each coil having two turns. If the flux per pole is 20 mWb and the armature rotates at 700 rpm, what is the induced voltage?
3. A group of electromagnets that create flux in a d-c generator (the field circuit) has an inductance of 18 henrys. If the 3.4 amp excitation is interrupted in 0.08 sec by the opening of the field switch, what average voltage is induced in the winding?
Question 4 To minimize the time where the voltage produced by a coil in the armature of a dc generator is zero, we minimize the A air gap B pole gap Question 5 A 6-pole dc generator with a simplex wave winding has parallel paths in its armature winding. Round your answer to 0 decimal places. Add your answer
3. What generates the rotating magnetic field on the stator? interaction with the field on the rotor O Applied single phase AC power A fixed magnet on the rotor Applied three phase AC power
Maximum torque is realized when an armature winding is with the magnetic field O at 90° O inline or at 0° at 45° O turning
please help
Iron losses in a DC machine are independent of variations in ) load voltage speed O All of these
The shunt DC generator gives almost O Constant current O None of these O Constant voltage O Constant current and voltage