A thin-walled cylinder has an internal diameter of 1200 mm and has walls 1.2 mm thick. It is subjected to an internal pressure of 0.7 N/mm² and a torque, about its longitudinal axis, of 500 kNm. Determine the principal stresses at a point in the wall of the cylinder and also the maximum shear stress.

A thin-walled cylinder has an internal diameter of 1200 mm and has walls 1.2 mm thick. It is subjected to an internal pressure of 0.7 N/mm² and a torque, about its longitudinal axis, of 500 kNm. Determine the principal stresses at a point in the wall of the cylinder and also the maximum shear stress.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Determine the principal stresses at points A and B of the cylinder. Consider: L = 70 mm; d = 20 mm; F = 12 kN; P = 15 kN; T = 800 Nm.
A 30 mm square is drawn on the rim of a large steel pressure vessel. The biaxial stress situation in the square after the pressure is applied is as shown in the figure. Determine the change in length of the BC edge in (mm).
Determine (a) the principal stresses and (b) the maximum in-plane shear stress and average normal stress. Specify the orientation of the element in each case.
A cantilevered beam is loaded as shown. The cross section at the wall is shown, with points of interest A (at the top), B (at the center), and C (midway between A and B). 200 mm where F= 1.4 kN F B 50 mm 50 mm Cross section at wall NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part.
7m 4 m 4m 4 m 4m 150 kN 100KN 120KN Determine the normal stress in member BC if the section is circular having an outside diameter of 70mm w/ a thickness of 5mm and indicate if the member is in Compression or Tension.
Gas stored in a cylindrical tank of inner radius 8mm wall thickness 50 mm. Gauge pressure 4 MPa. Determine the maximum shear stress in the wall?
For a steel rod with a circular cross section with a diameter of D = 20 mm, the following is required: 1. Draw a diagram of the longitudinal force 2. Draw a diagram of normal stresses 3. Determine the total elongation of the rod if Е = 2∙10^5 MPa When calculating, take: а = 2 m, b =1.2 m, F=10 кN - The point of application of force! The work must be done on one sheet of A4 paper, which must show: - Using the method of sections to determine the longitudinal forces in the rod. - Draw a diagram of longitudinal forces N - Determination of normal stresses based on the constructed plot of longitudinal forces. - Draw diagram a normal stresses - Determination of the full extension of the rod
A hollow shaft with an outside diameter of 3.1 in. and an inside diameter of 2.8 in. is subjected to both a torque of T = 525 lb-ft and an axial tension load of P = 6840 lb, as shown. (a) Determine the principal stresses (0p1> 0p2) and the maximum shear stress Tmax at point H on the surface of the shaft. (b) Show the stresses of part (a) and their directions in an appropriate sketch. Answers: %p1= i 1 op2= Tmax psi. psi. psi.
Please full solution with the drawing. Big and clear handwriting