A tensile test was conducted on a mild steel bar. The following data was obtained from the test: Data: (i) Diameter of the steel bar = 3cm (ii) Gauge Length of the bar = 20cm (iii) load at elastic limite = 250kN (iv) Extension at a load of 150 kN = 0.21mm (v) Maximum Load = 380kN (vi) Total extension = 60mm (vii) Diameter of the rod at the failure = 2.25cm Determine: (a) The Young's modulus

A tensile test was conducted on a mild steel bar. The following data was obtained from the test: Data: (i) Diameter of the steel bar = 3cm (ii) Gauge Length of the bar = 20cm (iii) load at elastic limite = 250kN (iv) Extension at a load of 150 kN = 0.21mm (v) Maximum Load = 380kN (vi) Total extension = 60mm (vii) Diameter of the rod at the failure = 2.25cm Determine: (a) The Young's modulus

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Show step by step solution
A high-strength steel band saw, 29 mm wide, runs over pulleys 900 mm in diameter. What minimum thickness of the steel band can be used without exceeding a flexural stress of 290? Assume E = 210 GPa. Answer must be in mm.
I need the answer quickly
Shown is a composite plate joined together by rivets. The components consist of two tension bar plates that is ¾ X 4 inch and riveted together by two splice plates which is 0.8 X 6 inch. Each rivet has a diameter of 25.4 mm. Considering that the allowable stress for the tension bar plates and splice plates is σ=20.0 ksi, the allowable shear stress for the rivets is σ=25.0 ksi and the allowable bearing stress on the rivets and splice plates is σ=25.0 ksi. What will be the maximum permissible load P such that none of the allowable stresses will be exceeded?
A) Determine the lateral strain B) Determine the axial strain C) determine the poisson’ts ratio V. COMPLETE SOLUTION. THANKS!
pre stressed conc. solution pls answer
Pls answer as indian code practice
technically, its one question but with multiple parts
Read the question carefully and give me both right solutions with clear explanation. Don't copy from other websites solution