A tank with a capacity of 74 liters, initially contains 20 kilograms of salt dissolved in 50 liters of water. Another solution, containing 3 kilograms of dissolved salt per liter, runs into the tank at 4 liters every minute and that the mixture (kept uniform by stirring) runs out of the tank at the rate of 1 liter per minute. What is the concentration of the solution in the tank at point of overflow? Intermediate values should be rounded only to two decimal places. Round off the final answer to two decimal places.

Q: A chemist prepares a solution of silver nitrate (AGNO,) by measuring out 20. g of silver nitrate…

A:

Q: A student prepares a 1.1 mM aqueous solution of acetic acid (CH₂CO₂H). Calculate the fraction of…

A:

Q: Suppose 3.32 g of sodium chloride is dissolved in 100. mL of a 0.60 Maqueous solution of potassium…

A:

Q: A student mixes 8.0 mL of 4.0 M acefone solution with 9,0 ml of 6.0 M HCI solution and then adde 166…

A: a mole of a species(n) = Volume of the species(V) x Molarity of the species(M).                  n =…

Q: A reaction is made up in the following way: 19 mL of 4.2 M acetone + 11 mL of 1.1 M HCI + 18 mL of…

A:

Q: 2. A student was given five known solutions and asked to study their interactions. The solutions…

A: Given:  Five solution solutions are given.

Q: Use the lab introduction to answer the following question. When answering this problem, report the…

A: Volume of beverage powder sample mixture = 3.78 L Volume of sample taken for dilution (V1) = 10 mL…

Q: In clinical applications, the unit parts per million (ppm) is used to express very small…

A: Given three solutions. We have to calculate the concentration of the solutions in parts per million…

Q: A company is making table salt by using a dryer to remove water from wet salt crystals. Wet salt…

A: In one hour, wet salt crystals fed to the dryer = 4900 pounds

Q: A beverage drink mix sample is prepared by mixing a packet of beverage powder in a gallon (3.78 L)…

A:

Q: A 25.0 mL aqueous stock solution of 3.7 M NaF is diluted to a final concentration of 1.8 M. What is…

A:

Q: A chemist must prepare 400. ml. of 6.00 µM aqueous mercury(1) chloride (Hg,C1,) working solution.…

A: we have to calculate the volume of stock solution needed

Q: A chemist must prepare 850. ml. of 10.0 mM aqueous potassium permanganate (KMnO,) working solution.…

A: Given -> Final volume of solution = 850 ml = V2 Final concentration= 10.0 mM = 10.0 × 10-3 M = M2…

Q: 32.2 mg NaCl in 108.9 mLmL of solution         Express the molarity in moles per liter to three…

A:

Q: In a river with a constant flow rate, the factory releases wastewater containing NaCl at a…

A:

Q: One of the volunteers suggests hiring an on-site water treatment company to remove the arsenic from…

A:

Q: If the CaCl₂ was available not as a solid, but rather as a 0.40 molar solution, how many mL of that…

A: Molarity (M) is a concentration term for a solution. The molarity of a solution is defined as the…

Q: How many liters of 0.250 M NaOH solution can be prepared from 10.0 g of NaOH?

A:

Q: 5.00 mL of stock solution is diluted to 25.00 mL, producing solution ALPHA. 10.00 mL of solution…

A: Dilution factor refers to the ratio of initial volume of the concentrated solution to the final…

Q: I Review Constants Periodic Table Suppose that you want to find the equation for a line that passes…

A: In the first part we have given two points (0,3) and (4,9) through which the line passes and we have…

Q: AI Review | Constants | Perie Calculate the final concentration of each of the following. Part B You…

A: The answer to the following question is-

Q: A chemist must prepare 875. ml. of 335. M aqueous copper(II) fluoride (Cul) working solution. She'll…

A:

Q: The mass in milligrams of oxygen (molar mass= 16 g/mol) in 1920 cm³ of 1.76X10-3 M solution of…

A:

Q: a 50.0 mL sample of aqueous sodium chloride was analyzed according to the experimental procedure in…

A: To solve this problem first we have to calculate the mass of  NaCl solution and mass of solid NaCl…

Q: An aqueous solution has a Molarity of 1.632 M. The density of the solution is (1.210x10^0) g/mL and…

A:

Q: What volume of water must be added to 32.7 mL of sulfuric acid solution in order to reduce its…

A: Given : intitial volume = 32.7 mL    Tip : M1×V1 = M2 × V2

Q: 4m33.2×10−4⁢m in

A: As we know,  1m = 10-3 mm 33.2 ×10-4 m = 33.2 ×10-4 ×10-3   = 3.32 ×10-6 mm

Q: A chemist prepares a solution of silver(I) nitrate (AGNO,) by measuring out 107. µmol of silver(1)…

A: Given data contains, Moles of silver nitrate is 107 μmol=107 μmol×1 mmole1000 μmol=0.107 mmol Volume…

Q: A chemist prepares a solution of copper(II) fluoride (CuF;) by measuring out 1.31 mg of copper(11)…

A: Mass of copper (ii) fluoride = 1.31 mg Volume of solution= 250.0mLConcentration of CuF2 in mol/L =?

Analytical Tools

Analytical tools or analysis tools help one to get into a conclusion or results from the data collected. Analytical tools can be applied for simple data sets and also in the case of big data analytics.