A tank is filled with fluid under pressure and the pressure gauge fixed at the top indicates a pressure of 21 kPa. The curved surface of the top is quarter of a circular part of radius 2.6 m. calculate the magnitude (N) and direction (degree) of the resultant force on the curved surface. (p =950 kg/m³ for fluid)

A tank is filled with fluid under pressure and the pressure gauge fixed at the top indicates a pressure of 21 kPa. The curved surface of the top is quarter of a circular part of radius 2.6 m. calculate the magnitude (N) and direction (degree) of the resultant force on the curved surface. (p =950 kg/m³ for fluid)

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.121P: One side of the container has a 03-m square door that is hinged at its top edge. If the container is...

See similar textbooks

Similar questions

The hemispherical glass bowl is filled with water. Find the location y of the center of gravity of the filled bowl. Approximate the bowl as a thin shell of radius R=6.15in. Use 1=162lb/ft3 for glass and 2=62.4lb/ft3 for water.
One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
A tank is filled with fluid under pressure and the pressure gauge fixed at the top indicates a pressure of 21 kPa. The curved surface of the top is quarter of a circular part of radius 2.6 m. calculate the magnitude (N) and direction (degree) of the resultant force on the curved surface. (p =950 kg/m³ for fluid) IB
A tank is filled with fluid under prcssurc anti the prcssurc gauge fixcd at the top indicatcs a prcssurc of 21 kPa. The curved surfacc of the top is quarter of a circular part of radius 2.6 m. calculate the magnitude (N) and direction (degree) of the resultant force on the cun'ed surface. (p=950kg./m³for fluid)
In the Fig. is shown the cross-section of the tank full of water under pressure. The length of the tank is 2.5 m. An empty cylinder lies along the length of the tank on one of its corners as shown. Find the horizontal and vertical components of the force acting on the curved surface LMN of the cylinder
A U-tube differential manometer is connected to two pipes at A and B. Pipe A Contains oil of density 1400 Kg/m3 and pipe B is carrying fluid of density 850 Kg/m3. If the pressure at point A is 195 kN/m2. Find the pressure at point B for the following data h1=11 cm, h2=7.5 cm and h3=23.5 cm. The specific gravity of mercury is13.6?
An inverted differential manometer is connected to two pipes A and B which convey water. The fluid in manometer is oil of SG= 0.8. For the manometer reading shown in the figure, find the pressure difference between A and B. X 30 cm 20 30 OIL OF Sp. gr. 0.8 -X
A cylinder (diameter 4 m) of weight 50 kN is placed on the bottom of the tank as shown and oil and water is poured in left and right side of tank respectively. Magnitude of horizontal force at centre that should be applied on cylinder so that it does not roll is (for unit length) kN. 64m Oil S=0.7 1.2 m Water S=1 0.7m
h = 4 ft F 2 ft A hemispherical glass bubble is installed in the side of a tank as a viewing window with its center 4 ft below the surface of the water. What is the magnitude of the vertical component of the force on the glass in lbs? The specific weight of water is 62.4 lbf/ft3.
1. Hydrostatic Force on Plane Surface. An open rectangular tank is 7 m high and has a square base 5 m on a side. If the tank is half-filled with fresh water (density is 1000 kg/m'), determine (a) the total hydrostatic force on a vertical side, in kN and (b) the location of the center of pressure as measured from the liquid surface, in cm. Draw the side view of tank showing the hydrostatic force F and the distance, yp. Is I + Ad a. Magnitude: F = yh,A b.Direction: Perpendicular to the Area c. Location: y, === S.
A closed tank whose bottom is 18 inches in diameter is filled with three liquids: 4 inches of carbon tetrachloride (SG=1.59), 2 inches of water and 12 inches of syrup (SG=1.31). The air chamber in the tank is pressurized at 1296 psf. d. Apply the PANEL EQUATIONS to determine the magnitude, direction and location of the total hydrostatic force acting at the bottom of the tank.
The total pressure force of a square plate is 25 kN, placed vertically in water so that the center of the plate is 1.5 m below the free surface. Determine the size of the plate and the depth of center of pressure. The above square plate is taken out of the water which weighs 370.5 N in air and 180.3 N in water of specific gravity 0.99. Find the volume and specific gravity of the square plate. Draw a neat sketch.