A tank in a form of a right circular cone 2.5m in diameter at the bottom, 4m in diameter at the top and 4m high, is full of water a sharp edged orifice with C=0.85 is located at the bottom of the tank. What dimensions of the square orifice is required to empty the tank in 10.5mins.

A tank in a form of a right circular cone 2.5m in diameter at the bottom, 4m in diameter at the top and 4m high, is full of water a sharp edged orifice with C=0.85 is located at the bottom of the tank. What dimensions of the square orifice is required to empty the tank in 10.5mins.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A conical tank 4.5m on top and 4,7m tall has a 60mm diameter orifice at its bottom for its outlet. Assume C = 0.63. The tank is filled with 7000 liters of water. What is the depth of the water in the tank in meters? How long will it take to drain the content of the tank in minutes? show solution and diagram
Please solve #4 &5 Thankyou
What is the head that must be supplied by the pump to the water to pump 0.4 m³/s from the lower to the upper reservoir ? Hint: [The head loss in the pipes is given in the figure as a function of water velocity]. Elevation = 150m Water Elevation 100m h₁=45v²/2g d=15cm Water Pump h=22.5v²12g d=20cm Elevation 40m
Three liquids given the following properties are poured into the cylindrical container with a diameter of 3 meters and a height of 6 meters. First fluid poured: sg = 1.0 , V = 17.6715 m^3 Second fluid poured: sg = 0.81 , V = 10.6029 m^3 Third fluid poured: sg = 2.94 , V = 7.0686 m^3 Assuming that the container is closed after pouring the fluids and the stable state in the container is reached, determine the pressure at the height of 4-m from the bottom of the tank
There are two liquid tanks A and B connected to each other by a tube as shown in the figure.The base of A is 75 cm2 and the base of B is 30 cm2. The density of the oil is 0.8. How many kilograms of oil must be put in tank B so that the level difference between the water in the two branches is 15 cm? Which point supports more pressure, C or C'?
An orifice meter with a 5 cm diameter is used to measure the flow rate of liquid. Under a head of 4 m, the velocity of the liquid at vena contracta is 7.5 m/s. If the actual discharge through the pipe is 8 l/s, calculate the coefficients of velocity, discharge, and contraction. Answers should be : Cv= 0.85 Cd= 0.46 Cc= 0.54
Question Certain fluid parameters are provided The inner cylinder, with a diameter of 20 cm, remains stationary, while the outer cylinder, with a diameter of 21 cm, holds the liquid up to a height of 30 cm. There is a 1.0 cm gap between the bottom of the two cylinders. By rotating the outer cylinder at a speed of 200 revolutions per minute (r.p.m.), the torsion meter attached to the inner cylinder registers a torque of 6.0 N-m. a. Determine the toque on the bottom in terms of b. Determine the toque on the surface in terms of ..... c. Determine method the viscosity of a liquid (N-sec/m^2)(Ans up to 2 decimal) μ (Ans up to 4 decimal) ..u.(Ans up to 4 decimal) using the rotating cylinder
A vertical cylinder having a circular base of radius 'r' and a height of 12 m is filled with water at the rate of 1 m3/min. If the depth of water in the cylinder at the vertical position is 3 m, what would be the resulting depth when the cylinder is in the horizontal position? OA 0.30r O B. 0.40r OC.0.50r O D.0.60r
Ethanol with a density of 789 kg/m moves through a constricted pipe in steady, ideal flow. At the lower point shown in the figure below, the pressure is P, = 1.90 x 10“ Pa, and the pipe diameter is 7.00 cm. At another point y = 0.35 m higher, the pressure is P, = 1.10 x 104 Pa and the pipe diameter is 3.50 cm. P (a) Find the speed of flow (in m/s) in the lower section. m/s (b) Find the speed of flow (in m/s) in the upper section. m/s (c) Find the volume flow rate (in m/s) through the pipe. |m³/s
Find the volumetric flow rate of the oil in m3/s thank you!!
A tank in the shape of an inverted right circular cone is full of water. The water weighs 62.462.4 pounds per cubic foot. The height of the tank is 1010ftft and the radius of its top is 44ftft.
Civil engineering -Hydraulics