A tank contains 6OL of water contaminated with Mercury at a concentration of 0.03 mg/L. Clean water is pumped into the tank at the rate of 2 L/min and water is pumped out of the tank at 1 L/min. What will the concentration of mercury be when the tank contains 80L of water?

A tank contains 6OL of water contaminated with Mercury at a concentration of 0.03 mg/L. Clean water is pumped into the tank at the rate of 2 L/min and water is pumped out of the tank at 1 L/min. What will the concentration of mercury be when the tank contains 80L of water?

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter13: The Chemistry Of Solutes And Solutions

Section13.6: Expressing Solution Composition

Problem 13.9CE

See similar textbooks

Related questions

Q: Answer questions 1 and 2 according to the data given. Data: Weight of cream is 326 ka. Table shows…

A: Given,The weight of the cream We will use the weighted average formula, for the fat percentage of…

Q: 1. Which 2 isomers would react fastest in an SN2 reaction? 2. Which 4 isomers could participate in…

Q: D Question 7 This reaction, 2 NH3(g) N₂(g) + 3 H₂(g), is an exothermic reaction that is at…

A: According to Le chatelier's principle "whenever any change is introduced in reaction, the reaction…

Q: Which of the ff. turbidity measurements is the most accurate? Angelo Secchi Disk Method Jackson…

A: Answer All given method for turbidity measurement are correct

Q: 24picometer to meter

A: The conversion of 24 picometer to meter is shown as follows, 1m = 10-12 The conversion factor to…

Q: An aqueous solution at 25.0 °C contains |H30*| = 0.09613 M. What is the pOH of the solution?

A: Given that: [H3O+] = 0.09613M pH tells the information about free H3O+ ion in a solution. pH =…

Q: 2. Draw the products for the following Diels-Alder Reactions. Make sure to depict the…

A: Diels-Alder reaction is the cycloaddition reaction between diene and dienophile. It is an type of…

Q: Br Br Br Me „Me Br Me Br Me Br Me Me A В D E F Ме Me Br Me Br Br Br Br -Br Me Me G H J K L

A: Electrophiles are electron loving species. Nucleophiles are nucleus loving species. Bimolecular…

Q: If V = 125ml at 755 mm Hg, find V (ml) at 780 mm Hg (temp, n = count)

A: At constant temperature T and no . of moles n , the ideal gas equation becomes: P1V1 = P2V2

Q: answer must be in cm/sec 4. An iron sphere of density 7.874 g/cm3 is falling at a steady speed in…

Q: 17. 4.73 x 10' centimeters (cm) to inches (in.) 1. %! %3D %3D 18. 370 grams (g) to pounds (Ibs.)

Q: What would be found in an IR of this compound?

A: IR spectroscopy is mainly used for the identification of the functional group present in the…

Q: The primary standard substance must be less equivalent weight (or molecular Wt. ) False True

A: Primary standard substance are used to standardized the secondary materials or solutions which is…

Q: 1) Question: It is desired to prepare 1 liter of sulfuric acid solution in 6 norms. How many ml of…

A: Given: The mass percentage of H2SO4 is 98%. The normality of 1 liter of sulfuric acid solution is 6…

Q: At 25 °C, a titration of 15.00 mL of a 0.0200 M AGNO, solution with a 0.0100 M NaI solution is…

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for…

Q: Use the References to access important values if needed for this question. mL hydrochloric acid 9…

Q: CH3 он excess Naoci Tempo

A: Alcohols are oxidized into carbonyl compounds by reacting with nitroxyl radical…

Q: Balance the following chemical equation (if necessary): C;H1,0(1) + O2(g) → H2O(g) + CO2(g)

A: The reaction given is, => C5H10O (l) + O2 (g) → CO2 (g) + H2O (g)

Q: A new method for glucose determination in serum (Method A) is to be compared to the established…

Q: An order is given to administer methylprednisolone, an anti-inflammatory drug, by IV at a rate of 44…

A: Flow rate here means the volume of the drug that flows per minute. It is calculated in the following…

Q: fat sample with combination of acids contain standard hydrochloric acid for blank and sample with…

A: Saponification : The process in which fats, oils, or lipids are converted into saop and alcohol by…

Q: Explain in detail how you would make the solution from the previous question (50.00 mL a 300 ug/dL…

A: We have to prepare 50.00 mL of a 300 μg/dL solution from a 1500 μg/dL stock solution. So, here the…

Q: Determine the concentrations of K,SO,, K+, and SO, in a solution prepared by dissolving 2.03 x 10 g…

Q: What is the molarity of a concentrated solution of sulfuric acid with a specific gravity of 1.84 and…

A: Molarity is defined as the number of moles of solute per litre of solution. Molarity = Number of…

Q: penicillin V potassium is to be administered to a child weighing 47 lb. the dosage rate is 15 mg per…

A: Molar concentrations is defined as mass of solute divided by volume of solution.

Q: Incorrect

A: We will calculate percentage ionisation

Q: Br Br „Me Me Br Me Br Me Br Me Ме A В D F Me Br Me Ме Br Br Br Br -Br Me Me G J 1. Which 2 isomers…

A: Secondary leaving group are those leaving group which is connected with the secondary carbon atom…

Q: kg/cm^3

Q: Concentrated Standard Solution: 3.0168 weighed mass (NH4)2SO4-FESO4-6H2O g in L of solution 99.70…

Q: What is the correct equation for percent difference? о теasured-+ассеpted] |measured-accepted|/2 х…

A: Percent difference between two number can be calculated by difference between two number divided by…

Question

answer should be in g/ml

4.
A tank contains 60L of water contaminated with Mercury at a concentration of
0.03 mg/L. Clean water is pumped into the tank at the rate of 2 L/min and water is
pumped out of the tank at 1 L/min. What will the concentration of mercury be when
the tank contains 80L of water?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Fluoridation of city water supplies has been practiced in the United States for several decades. It is done by continuously adding sodium fluoride to water as it comes from a reservoir. Assume you live in a medium-sized city of 150,000 people and that 660 L (170 gal) of water is used per person per day. What mass of sodium fluoride (in kilograms) must be added to the water supply each year (365 days) to have the required fluoride concentration of 1 ppm (part per million)that is, 1 kilogram of fluoride per 1 million kilograms of water? (Sodium fluoride is 45.0% fluoride, and water has a density of 1.00 g/cm3.)
What mass of a 4.00% NaOH solution by mass contains 15.0 g of NaOH?
Silver ions can be found in some of the city water piped into homes. The average concentration of silver ions in city water is 0.028 ppm. (a) How many milligrams of silver ions would you ingest daily if you drank eight glasses (eight oz/glass) of city water daily? (b) How many liters of city water are required to recover 1.00 g of silver chemically?
The mercury content of a stream was believed to be above the minimum considered safe —1 part per billion (ppb) by weight. An analysis indicated that the concentration was 0.68 parts per billion. What quantity of mercury in grams was present in 15.0 L of the water, the density of which is 0.998 g/ml? ( 1ppbHg=1ngHg1gwater)
n oil spill spreads out on the surface of water, rather than dissolving in the water. Explain why.