Required informationA tank contains 1 m³of water at 20°C and has a drawn-capillary outlet tube at the bottom as shownin the figure below. The diameter of the tube is 3.7 cm.1 mThe flow rate is1 m³L= 80 cmFind the flow rate if the fluid is SAE 10 oil. For SAE 10 oil at 20°C, take p = 870 kg/m³ and μ = 0.104 kg/m-s. For drawntubing, take & 0.0015 mm.m³/h

Answered: Image /qna-images/answer/be6be731-b5c5-4529-8d79-0d04fdda36bb.jpg

A tank contains 1 m³ of water at 20°C and has a drawn-capillary outlet tube at the bottom as shown in the figure below. The diameter of the tube is 3.7 cm. 1m 1 m³ L = 80 cm Find the flow rate if the fluid is SAE 10 oil. For SAE 10 oil at 20°C, take p = 870 kg/m3 and μ = 0.104 kg/m-s. For drawn tubing, take & 0.0015 mm.

A tank contains 1 m³ of water at 20°C and has a drawn-capillary outlet tube at the bottom as shown in the figure below. The diameter of the tube is 3.7 cm. 1m 1 m³ L = 80 cm Find the flow rate if the fluid is SAE 10 oil. For SAE 10 oil at 20°C, take p = 870 kg/m3 and μ = 0.104 kg/m-s. For drawn tubing, take & 0.0015 mm.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Consider a pipe on a horizontal plane: based on Bernoulli's equation A. none of the above B. the inlet velocity will be less than the outlet velocity C. the inlet velocity will be greater than the outlet velocity D. the elevation of the inlet will be greater than that of the outlet
Air having density p = 0.981 kg/m³ is flowing in a wind tunnel. A differential manometer connected to a pitot tube is used to measure the dynamic pressure of the air at the pitot tube location. The liquid in the manometer is oil having a specific gravity of 0.826, and the manometer reading is 76.2 mm. The wind tunnel is on the CU campus in Denver where g = 9.796 m/s?. a) Find the dynamic pressure of the air (answer: 615.8 Pa). b) Find the speed of the air at the pitot tube location (answer: 35.4 m/s). Air p = 0.981 kg/m³ h = 76.2 mm Oil, SG = 0.826
Water (w = 62.43, w = 23.6 x 10-6 lbs) flows through the 7-in. diameter pipe below with an average velocity of 6 ft/s. Find the change in pressure over 37 ft of pipe. Provide your answer in lb The pipe has roughness of 4x10-¹ ft. D L
What’s the answer for this please ?
A joining elbow on horizontal plane is shown in the figure. The fluid is water and assumed to be ideal. Pipe 2 is open to the atmosphere. The flow velocity of pipe 2 is given as Uz = [2+ (k/10)] m/s, and pressure at pipe 3 is p3 = 1.6 + k/ 4 kPa. (k=5) a) Calculate the flow velocity at pipe 3 (u3 = ?) b) Calculate the discharge and flow velocity of pipe 1 (Q = ?, ui = ?). c) Calculate the pressure at pipe 1 (p. = ?). d) Calculate the x and y components of the net force acting on the joining elbow by the fluid. Draw the force vector. Atmosfer dz-25 cm d;=40 cm d;=25 cm 3 300
The large reservoir in the following figure provides water for the indicated tank with a flow rate of 10 L/s. Check that the machine is installed and a pump or a turbine, and determine its power, if the yield is 75%. Suppose ideal fluid. Data: γH20 = 104N/m3 ; ATubes = 10mc2 ; g = 10m/s2 .
The square-section duct in atmospheric conditions is exposed to outside air flow as seen in the figure. The temperature of the air is T air= 5°C, the velocity is V air= 10m/s. Find the exit temperature of the water entering the channel at a flow rate of ṁwater=0.01 kg/s and a temperature of T water,g=50°C. Geometric dimensions are given on the figure.
a circular opening of diameter 300 mm impinges on a rigid wall as shown in the figure. Neglect all minor losses and assume the water level in the tank to remain constant. The net horizontal force experienced by the wall is kN. Density of water is 1000 kg/m3. Acceleration due to gravity g= 10 m/s. %3D Stationary rigid wall 6.2 m Jet Circular opening of diameter 300 mm
= = Air flows radially outward between the two parallel circular plates shown in the figure below. The pressure at the outer radius, Ro 5 cm, is atmospheric. Find the pressure at the inner radius R¿ 0.5 cm, if the air density is constant, the air flow is inviscid, the volume flow rate is 4.0 L/s, and the plate spacing is h = 0.125 cm. h Po= Patm = 101.3 kPa T = 20°C 777 R₁ Ra
Oil at 60 degrees celsius and 140 bars is flowing through a pressure relief valve at 0.01 m3/s. What is the downstream temperature? Show your work.
Only a&b