A tall cylinder contains 25 cm of water. Oil is carefully poured into the cylinder, where it floats on top of the water, until the total liquid depth is 40 cm. What is the gauge pressure at the bottom of the cylinder?
Q: A fluid with a viscosity of 2.0 x 10-3 Pa s has a velocity of 1.48 m/s through a 12 m long pipe with…
A: Viscosity of the fluid η=2.0×10-3 Pa s Velocity of the fluid v=1.48 m/s Length of the pipe L=0.085 m…
Q: A rounded container has a layer of 10cm of water at the bottom and a layer of 20cm of ethyl alcohol…
A:
Q: A U-shaped tube is closed at one end p, the other end is open to the atmosphere. There 12. is a…
A: Answer: 125791 dyn/cm^2
Q: If the buoyant force was found to be 1.0 N on the submerged cylinder. What is the volume of the…
A:
Q: A solid wooden sphere has its radius of 25.0 cm and it is immersed in mercury only 15.0% of volume…
A:
Q: (Figure 1) shows a container with a cross section area of 15 cm² in which a layer of water floats on…
A:
Q: A liquid of density 900 kg/m3 is flowing through a horizontal pipe which has variable size. At one…
A: density of liquid (d) = 900 kgm3speed of liquid at first position (v1) = 5 msPressure at the first…
Q: Water and then oil (which don't mix) are poured into a U-shaped tube, open at both ends. They come…
A:
Q: Water (density 1000 kg/m³) flows through a closed, frictionless pipe. At point A, the diameter of…
A: Given information: The diameter of the pipe at point A, dA=9.0 cm=0.09 m The velocity of water at…
Q: A liquid is flowing through a horizontal pipe whose radius is 0.0224 m. The pipe bends straight…
A: Given: Horizontal pipe radii, r1=0.0224 m Pipe bent height, h=8.8 m Another horizontal pipe radii,…
Q: A container is filled to a depth of 15.0 cm with water. On top of the water floats a 31.0-cm-thick…
A:
Q: 49. Hanamichi Sakuragi has a height of 190 cm. He is about to make a shot in the 3-point line which…
A:
Q: A cube of unknown material is 0.200 m on each side and has a mass of 17.6 kg. It is suspended in a…
A:
Q: Water is stored in a pressurised container at a height ??= 11.2 m. It then moves through a…
A:
Q: A manometer with two closed ends contain some gases inside. The pressure inside the bulb A is PA =…
A:
Q: Water (density = 1 000 kg m3) runs at 10 m/s through a long tube with a radius 0.050 m. The long…
A:
Q: To suck lemonade of density 1000 kg/m3 up a straw to a maximum height of 85 mm, what is the minimum…
A: The density of lemonade is given as The maximum height is
Q: The weight of a rectangular block of low-density material is 15.5 N. With a thin string, the center…
A:
Q: 6. A liquid is flowing through a horizontal pipe whose radius is 2.08 × 10-2 m. The pipe bends…
A:
Q: A 5.8 cm diameter horizontal pipe gradually narrows to 2.9 cm . When water flows through this pipe…
A:
Q: A round pipe of varying diameter carries petroleum from a wellhead to a refinery. At the wellhead,…
A: We need to find the volume flow rate and also the diameter of pipe at the refinery.
Q: A vertical pipe, closed at the bottom end, is filled to a depth of 1.00 m with water and then an…
A:
Q: The liquid in a horizontal pipe of diameter d1 before a constriction is at pressure P1 and flowing…
A: In the question, it is given thatREMMBER THAT SINCE THERE IS NO HEIGHT CONCEPT FOR BOTH ENDS WE HAVE…
Q: Chapter 14, Problem 059 Water is moving with a speed of 6.4 m/s through a pipe with a…
A: Given information:
Q: A sphere completely submerged in water is tethered to the bottom with a string. The tension in the…
A: The sphere is completely submerged in water.Tension in string is ; here is the sphere's…
Q: A woman is lying down with her arms horizontal. Along her upper arm, her brachial artery stretches…
A: Given: The speed of the blood is v=9 cm/s. The length of the brachial artery is l=20 cm. The…
Q: A round pipe of varying diameter carries petroleum from a wellhead to a refinery. At the wellhead,…
A:
Q: A container is filled to a depth of 15.0 cm with water. On top of the water floats a 32.0-cm-thick…
A: Let P0 be the absolute pressure at some reference point, Patm be the atmospheric pressure.…
Q: A water cannon 2.15 m long and with a cross-sectional area of 11.0 cm2 is aimed straight up and…
A: Length of water cannon = 2.15 m A1 = 11 cm2v1 = 8.8 m/s A2 = 46 cm2Using equation of continuity…
Q: Water with a density of 1 x 103 kg/m³ flows through a horizontal pipe. The pipe cross-section tapers…
A: The density of the water is ρ=1×103 kg/m3. The cross section area of the pipe tapers from A1=0.008…
A tall cylinder contains 25 cm of water. Oil is carefully poured into the cylinder, where it floats on top of the water, until the total liquid depth is 40 cm. What is the gauge pressure at the bottom of the cylinder?
Trending now
This is a popular solution!
Step by step
Solved in 2 steps
- Air at 105 kPa and 37°C flows upward through a 6-cm-diameter inclined duct at a rate of 65 L/s. The duct diameter is then reduced to 4 cm through a reducer. The pressure change across the reducer is measured by a water manometer. The elevation difference between the two points on the pipe where the two arms of the manometer are attached is 0.20 m. Determine the differential height between the fluid levels of the two arms of the manometer.An ideal fluid is flowing with a speed of 12 cm/s through a pipe of diameter 5 cm. The pipe splits into three smaller pipes, each with a diameter of 2 cm. What is the speed of the fluid in the smaller pipes?water flows through a section of pipe at a speed of 9.72 m/s. the water that flows into a 6.47 m higher section of pipe or flows at a speed of 1.45 m/s. what is the difference in the pressure between the two section of pipes? Report 3 significant digits.
- A container is filled to a depth of 20.0 cm with water. On top of the water floats a 32.0-cm-thick layer of oil with specific gravity 0.700. What is the absolute pressure at the bottom of the container?A horizontal pipe carries a smoothly flowing liquid of density of 1290 kg/m³. At Locations 1 and 2 along the pipe, the diameters are dj = 6.79 cm and d2 = 2.79 cm, respectively. Is the flow speed at Location 2 higher or lower than the flow speed at Location 1? d Location 1 Location 2 d2 O higher cannot tell from the data lower The flow speed at Location 1 is 1.87 m/s. What is the pressure difference AP between Location 2 and Location 1 (including its sign)? Ignore viscosity. AP = РаA pipe with a constant 5.00 cm diameter carries water flowing at 4.00 m/s down a 10.0-m hill. The gauge pressure in the pipe at the top of the hill is 20.0 kPa. What is the gauge pressure in the pipe at the bottom of the hill?
- A fluid with density 1200 kg/m flows through this pipe. As the first location, A, the fluid travels at 7.5 m/s and at the second location, B, the fluid travels at 11 m/s. What is the difference in pressure between the two points? O-1.9 x 10 Pa +3.8 x 103 Pa -2.5 x 104 Pa -3.9 x 10 Pa O +5.0 x 104 Paa stiff, 15-cm-long tube with an inner diameter of 3.5 mm is attached to a small hole in the side of a tall beaker. the tube sticks out horizontally. the beaker is filled with 20⁰c water to a level 50 cm above the hole, and it is continually topped off to it maintain that level. What is volume flow rate through the tube? The viscosity of water is 1.0×10^-3 Pa×s.A cylindrical disk of wood weighing 50.0 N and having a diameter of 25.0 cm floats on a liquid of density p= 0.750 g/cm3 . The cylinder of liquid is 60.0 cm high and has a diameter that is the same as that of the wood. What is the gauge pressure halfway down the liquid?
- The entrance opening of a horizontal pipe has a radius of 6 cm and water is flowing at .35 m/s. The pressure at opening is 18.5 n/m2 and changes to 23.0 N/m2 at the exit. What is the area of the exit opening?Water enters a pipe with a diameter of 2.0 cm at a speed of 15.0 m/s. At what velocity will it come out the other end if the pipe has narrowed to a diameter of 1.5 cm? If the narrow end of the pipe is 1.0 m above the wide end, and the water enters the pipe under a pressure of 5.0 atm, what would be the water pressure when exiting the narrow end?Water flows with a constant speed through a pipe of constant cross-sectional area in the ground floor (y1=0m) of a house. The pipe rises (y2=5.0m) to reach a shower head on the second floor. The pressure at ground level is 140kPa. a) what is the pressure at the shower head? b) what is the maximum height that water from the ground level could reach?