A student performed a titration to determine the exact concentration of NaOH(aq). The titration was performed against a standard 0.1000 M HCl(aq) solution. Phenolphthalein indicator was used. The following end-point volumes were recorded by the student in units mL: Trial Number Volume 1 25.06 2 25.15 3 25.02 4 25.17 5 25.07 Calculate the 95% confidence limit. Assume that there is no outlier. Provide your answer to the correct number of decimal places, without units, and without the ± sign. Use the T-table shown below.

A student performed a titration to determine the exact concentration of NaOH(aq). The titration was performed against a standard 0.1000 M HCl(aq) solution. Phenolphthalein indicator was used. The following end-point volumes were recorded by the student in units mL: Trial Number Volume 1 25.06 2 25.15 3 25.02 4 25.17 5 25.07 Calculate the 95% confidence limit. Assume that there is no outlier. Provide your answer to the correct number of decimal places, without units, and without the ± sign. Use the T-table shown below.

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter3: Statistical Tests With Excel

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A solution of HCl was titrated against sodium carbonate. What is the average normality of acid in the given data? (MW Na₂CO3 = 106) T2 0.3479 0.3562 0.3042 Weight (g) Initial V (ml) 0.80 1.60 35.20 36.70 39.80 Final V (mL) Vol HCl used (mL) 35.10 39.40 N of HCl (eq/L) 0.1954 0.1870 Average N of HCl (eq/L)
You are preparing a 100.0 mL standard solution needed for titration analysis. The NaOH (40 g/mol) pellets are measured to be 0.5341 g in a balance with acceptable uncertainty of +0.001 g. Mass of the pellets is recorded after taring the container. The pellets are put in a beaker and added with 50 ml distilled water measured by a graduated cylinder. The solution is then quantitatively transferred to a 100-mL volumetric flask with uncertainty of ±0.08 mL and diluted to a 100-mL mark. What is the concentration (M) of the solution and estimate its uncertainty by propagation? Assumption: There is no uncertainty in molar mass. Express your answer as C+/- u M.
7) The homogeneity of the chloride level in a water sample from a lake was tested by an analyst. Below are the concentration in parts per million (ppm) of Cl: 27.32, 27.22, 27.21, 27.24, 27.20 i. Determine the mean and median. ii. Calculate the confidence limit at 90%. iii. Identify a possible outlier and use the Q-test to determine whether it can be retained or rejected at 90% confidence level
The molarity of a solution is determined by four separate titrations or replicates, where the obtained data was 0.4120, 0.4920, 0.3920, and 0.4320 M. Calculate the standard error of the mean for the above data. O 0.00185 O 0.02160 O 0.43200 O 0.04320 O 0.01080
00 mL of a diprotic acid primary standard solution was accurately prepared to a concentration of 0.1431 M. Three samples of this primary standard solution were used as samples in a titration to standardize an aqueous solution of sodium hydroxide, NaOH, which would be used as a titrant. Using the following table of data for the titration of the primary standard acid with NaOH, calculate the average concentration of NaOH. Trial # Volume of primary standard Initial titrant volume Final titrant volume 1 10.00 mL 8.21 mL 27.22 mL 2 10.00 mL 27.22 mL 46.23 mL 3 10.00 mL 30.28 mL 49.29 mL 0.1506 M 0.0753 M 0.0376 M 0.1431 M 0.0526 M
A clinical chemist obtained the following data for the alcohol content of a sample of blood: % C,H OH: o.084, 0.089, and o.079. Calculate the 95% confi- dence interval for the mean assuming that (a) the three results obtained are the only indication of the precision of the method and that (b), from previous
A controversy broke out as a dead body was found in a bar on Cornelia Street. The media revealed that minutes before the person died, he described his drink as something stronger than other drinks in the bar. You were the analyst tasked to verify the cause of death. Preliminary qualitative tests showed the possible presence of cyanide in the victim's death. Thus, you tried to quantitatively detect cyanide ions in the victim's drink using spectrophotometric analysis. Standard solutions were of different CN- concentrations were made as shown in Table 2. A 25.0mL aliquot of each standard solution was added with Fe(NO3)3 to form the colored complex, [Fe(CN)6]³ (aq). Each standard solution was then diluted to a total volume of 50.0 mL. The absorbances of the diluted standard solutions were recorded using 1.00-cm cells and at Amax = 725 nm and found in Table 2. Table 2. Raw absorbance measurements for each standard solution of CN-. [CN-] prior to dilution, M Abs@725nm 0.002 0.000 0.040 0.160…
A sample (50 mL) of a bottled water was added to a 100 mL volumetric flask and then diluted to the mark. From this stock solution, 50 mL was taken, added to a 100 mL volumetric flask and diluted to the mark. Final concentration of the serial dilution: 587.7161ppm. 1. what is the concentration in the original bottle (ppm)
Sodium carbonate is a reagent that may be used to standardize acids in the same way that you have used KHP in this experiment. In such a standardization it was found that a 0.498-g sample of sodium carbonate required 24.8 mLmL mL of a sulfuric acid solution to reach the end point for the reaction. Na2CO3(aq)+H2SO4(aq)→H2O(l)+CO2(g)+Na2SO4(aq)Na2CO3(aq)+H2SO4(aq)→H2O(l)+CO2(g)+Na2SO4(aq) What is the molarity of the H2SO4H2SO4?
During a routine check of the fluoride content of Gotham City's water supply, the given results were obtained from replicate analyses of a single sample: 0.815 mg/L, 0.789 mg/L, 0.811 mg/L, 0.789 mg/L, and 0.815 mg/L. Determine the mean and 90% confidence interval for the average fluoride concentration in this sample. Report the mean and the confidence interval using the "real rules" for significant figures. mean: 0.804 90% confidence interval: 2.32 x10-4 Incorrect mg/L mg/L
A 15.00 g sample containing mixed alkali and other inert components was dissolved and diluted to 300 mL with water. A 20 mL aliquot was titrated with 5.02 mL of 0.5352 M HCl to reach PHP endpoint. Another 20 mL aliquot was titrated to the BCG endpoint, using up 18.87 mL of titrant in the process. Note: Answer in two decimal places only. If there is no answer, type in 0.00. Use the molar masses 105.989 ?/??l ??2cO3 and 84.007 g/mol NaHCO3 indicated. The volume of titrant needed to neutralize NaOH is _________ mL.The volume of titrant needed to neutralize Na2CO3 is _____________ mL.The volume of titrant needed to neutralize NaHCO3 is _____________ mL. The mass of NaOH is ___________ g.The mass of Na2CO3 is __________ g.The mass of NaHCO3 is __________ g. The percent weight of NaOH is __________ %.The percent weight of Na2CO3 is __________ %.The percent weight of NaHCO3 is __________ %.
3.1524 g HCI (FW 36.46) was diluted with 45 mL water and titrated with 1.0149 M NAOH (FW 40) using methyl red as indicator. 28.02 mL of NAOH was required to neutralize the HCI. Calculate the percentage w/w of HC. Record your answer in decimal notation to 2 decimal places. Answer = % w/w %3D