A steel bar, with a rectangular cross section, has a butt-welded joint, as shown below, and will be used to carry an axial tensile load of 750 kN. If the normal and shear stresses on the plane of the weld must be limited to 80 MPa and 50 MPa, respectively, determine the minimum thickness t required for the bar.

A steel bar, with a rectangular cross section, has a butt-welded joint, as shown below, and will be used to carry an axial tensile load of 750 kN. If the normal and shear stresses on the plane of the weld must be limited to 80 MPa and 50 MPa, respectively, determine the minimum thickness t required for the bar.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Te - Effective throat thickness well in mm = 6 sin45° Consider the following drawing in which plate 1 is welded onto plate 2 as shown for tensile and shear loading. The plates are fillet welded with a weld thickness of 6 mm as shown for a length of 150 mm. The plates have an ultimate strength of 275 MPa and the welding was done with F70 welding electrodes, which possesses an ultimate strength of 483 MPa. Consider a partial factor of safety of 1.7 for the welded joint and determine the design strength of the weld joint, both in tension (Tdw) and in shear (Vdw) due to the forces acting on it. a) Determine the design strength of the following weld in tension ( ) due to vertical forces. b) Determine the design strength of the weld in shear ( ) due to horizontal forces. Attached pic is shear equation for calculation Tension equation for calculation is: Tdw = FyLwte /Ymw
Please answer, thankyou
1cm t1 (cm) P 3,2 cm t2 (cm) t1 (cm) 1 cm 20 cm Ь (ст) P = 20t %3D Dp=1,6 cm
the answers are pmax=195kN and the angle is 57.8. can you explain?
A 50 inches diameter storage tank is used to store air at an internal pressure of 625 psi with a FS = 4.5 based on ultimate strength. If the welded joints have a joint strength efficiency of 80% and the steel used to create the tank hasan equivalent strength similar to C1118,a. find a suitable plate thickness of the tank. Compare the stresses for both diametral section and longitudinal sectionb. Using the thickness solved in (a), determine the pressure to cause actual failure to the vessel
QUESTION 2 1.2 A thin cylindrical pressure vessel has the following specifications Internal pressure 5.33 MPa Metal thickness 20 mm Maximum allowable stress 120 MPa Efficiency of the longitudinal joint Efficiency of the circumferential joint 80 % 50 % 1.21 Determine the maximum internal diameter which the cylinder may have. 1.2.2 The actual values of the hoop and longitudinal stresses. For the soolbar, press ALT=P10 (PC) or ALT-FN-F10 (Mac). B IUS Paragraph Ara !! 140x AITZAN LAINA
Is the stress twice as great as the longitudinal stress? How?
A 40mm thick steel bar that is fabricated by welding two parts together is shown below. Being concerned for the strength of the weld, you need to find the state of stress (normal stress and shear stress) in the plane of the weld for an applied load of 400kN. Draw your result on a stress element. 57° 400 kN 400 kN 100 mm