A solid shaft of 200 mm diameter has the same cross-sectional area as that of hollow shaft of same material with outside diameter is 300 mm. Both the shaft has got same shear stress. Find the ratio of power transmitted of sold to hollow shah at the same speed. 0.43 0.67 1.7 2335

Q: A Hollow power transmission shaft of length ‘L’ 1103 mm, outer diameter ‘D’ 73mm and inner diameter…

A: According to the given data D=73mm d=50mm We need to find The polar second moment of area of the…

Q: Problem 4

A:

Q: A hollow shaft with a length of 1103mm and outer diameter 73mm and inner diameter 50mm is required…

A:

Q: (a) The tubular rotor shaft of a wind turbine shown in Figure 3(a) is of 50 mm and 40 mm outer and…

A: Given data Outer Diameter of Tubular shaft = Do = 50 mm = 0.05 mInner Diameter of Tubular Shaft = Di…

Q: A hollow shaft with a length of 1103mm and outer diameter 73mm and inner diameter 50mm is required…

A: According to the given data D=73mm d=50mm We need to find The polar second moment of area of the…

Q: A Hollow power transmission shaft of length ‘L’ 1103 mm, outer diameter ‘D’ 73mm and inner diameter…

A: The length of the shaft,(L)=1103 mm. The outside diameter of the shaft,(do)=73 mm. The inside…

Q: A non-rotating shaft shown in the figure is machined from AISI 1020 CD steel. It is subjected to a…

A: The factor of safety. FBD: The free-body diagram is shown below.

Q: The bending stress at point A.

A: Given data Outer Diameter of Shaft = Do = 50 mm = 0.05 mInner Diameter of Shaft = Di = 40 mm = 0.04…

Q: A solid steel shaft transmits a twisting moment of 1372 Nm. The shaft is made up of mild steel…

A:

Q: a) Find the diameter of both shafts. b) If the modulus of rigidity of shaft (2) G is 77.2 GPa,…

A: for solution refer below images.

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.