9:35WEBTOONCourse HomeAProvide Feedback|||ValueUnitsRequest Answer94% اللهP PearsonConstantsO?Copyright © 2022 Pearson Education Inc. All rights reserved.Terms of Use | Privacy Policy. | Permissions |Contact Us |Next >

Given : Angular velocity , w = 2.6 rev/s Time , t = 0.20 s Mass, M = 0.90 Kg Length, L = 0.95 m…

A softball player swings a bat, accelerating it from rest to 2.6 rev/s in a time of 0.20 s. Approximate the bat as a 0.90-kg uniform rod of length 0.95 m, and compute the torque the player applies to one end of it. Express your answer to two significant figures and include the appropriate units. T = μA Value Units ?

A softball player swings a bat, accelerating it from rest to 2.6 rev/s in a time of 0.20 s. Approximate the bat as a 0.90-kg uniform rod of length 0.95 m, and compute the torque the player applies to one end of it. Express your answer to two significant figures and include the appropriate units. T = μA Value Units ?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The uniform 22-kg plate is released from rest at the position shown. (Figure 1) Figure A x 0.5 m- 1 of 1 0.5 m > Part A Determine its initial angular acceleration. Express your answer in radians per second squared to three significant figures. Enter positive value if the angular acceleration is clockwise and negative value if the angular acceleration is counterclockwise. a = Submit Part B 195| ΑΣΦ. 41 Request Answer vec ? rad/s² Review Determine the x and y components of reaction at the pin A using scalar notation. Express your answers in newtons to three significant figures separated by a comma.
The two blocks in (Figure 1) are connected by a massless rope that passes over a pulley. The pulley is 16 cm in diameter and has a mass of 2.7 kg. As the pulley turns, friction at the axle exerts a torque of magnitude 0.75 Nm. If the blocks are released from rest, how long does it take the 4.0 kg block to reach the floor?
Suppose you exert a force of 172 N tangential to a 0.295 m radius 75.0 kg grindstone (a solid disk). (Give your answers to at least 2 decimal places.) (a) What torque (in N · m) is exerted? (Enter the magnitude.) N. m (b) What is the angular acceleration (in rad/s2) assuming negligible opposing friction? (Enter the magnitude.) |rad/s? (c) What is the angular acceleration (in rad/s?) if there is an opposing frictional force of 22.6 N exerted 1.75 cm from the axis? (Enter the magnitude.) |rad/s?
To study torque experimentally, you apply a force to a beam. One end of the beam is attached to a pivot that allows the beam to rotate freely. The pivot is taken as the origin or your coordinate system. You apply a force of F = Fx i + Fy j + Fz k at a point r = rx i + ry j + rz k on the beam. Part a) Calculate the magnitude of the torque, in newton meters, when the components of the position and force vectors have the values rx = 3.71 m, ry = 0.075 m, rz = 0.085 m, Fx = 1.2 N, Fy = -7.6 N, Fz = 1.2 N. Part b) If the moment of inertia of the beam with respect to the pivot is I = 72 kg˙m^2, calculate the magnitude of the angular acceleration of the beam about the pivot, in radians per second squared.
Plz use g = 9.8 m/s2 to find if needed
A bar on a hinge starts from rest and rotates with an angular acceleration a = 13 + 7t, where a is in rad/s? and t is in seconds. Determine the angle in radians through which the bar turns in the first 4.53 s. 226 Your response is within 10% of the correct value. This may be due to roundoff error, or you could have a mistake in your calculation. Carry out all intermediate results to at least four- digit accuracy to minimize roundoff error, rad
A bicycle wheel starts to accelerate from wo = 27rad/s. If the wheel goes through 462 revolutions in 32 seconds, determine the final angular velocity of the wheel. Express your answer in units of rad/s using zero decimal places. Answer:
In a downtown office building, you notice each of the four sections of a rotating door has a mass of 90 kg. What is the width, in meters, of each section of the door if a force of 62 N applied to the outer edge of a section produces an angular acceleration of 0.490 rad/s²? 3 WO W
Suppose you exert a force of 192 N tangential to a 0.255 m radius 75.0 kg grindstone (a solid disk). (Give your answers to at least 2 decimal places.) (a)What torque (in N · m) is exerted? (Enter the magnitude.) (b) What is the angular acceleration (in rad/s2) assuming negligible opposing friction? (Enter the magnitude.) (c) What is the angular acceleration (in rad/s2) if there is an opposing frictional force of 21.6 N exerted 2.50 cm from the axis? (Enter the magnitude.)
If you hold your arm outstretched with your palm upward, the force to keep your arm from falling comes from your deltoid muscle. Assume that the arm with hand has mass 4.25 kg and the distances and angles shown. What is the magnitude of the torque must the deltoid muscle provide to keep the arm in this position, in N·m? Use g = 10.0 m/s2. Your answer needs to have 3 significant figures, including the negative sign in your answer if needed. Do not include the positive sign if the answer is positive. No unit is needed in your answer, it is already given in the question statement.
A circular disk with a radius of 0.38 m is subject to 2 tangentially applied forces. The disc is fixed such that it will rotate about its center. Both forces produce a torque in the same direction. F1 = 3.6 N applied at the outer edge of the disc. F2 = 4.3 N applied at a distance of 0.28 from the center of the disc. What is the net torque on the disc?
PLEASE SEND THE ANSWER IN 10 MINUTES !!! Find the magnitude of the net torque on the wheel in Figure below about the axle through O, taking a=13cm, b=41cm. The magnitude of the applied forces are F1=11N, F2=20N, and F3=11N. Provide your answer in units of m⋅N and round off your answer to 2 decimal places.