Answered: A small rectangular loop of wire is… | bartleby

Related questions

Question

100%

A small rectangular loop of wire is located close to a long straight wire initially carrying a current I = 120 A (see figure below). Find the average emf induced in the loop if the current in the wire reverses direction in a time interval of 1/164 s.

Magnitude ________

Direction ________

I
1.0 mm
10 cm
10 сm

Expert Solution

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A)What is the magnitude of the pushing force? F=_________ b) How much power does the pushing force supply to the wire? Express your answer with the appropriate units. P=___________ c) What is the magnitude of the induced current? Express your answer with the appropriate units. I=_____________
The motor in a toy car operates on 6.00 V, developing a 4.70 V back emf at normal speed. If it draws 3.00 A at normal speed, what current (in A) does it draw when starting? ____________ A
A loop of wire has a self-inductance of 5.5 mH. You pass a current of 9.0 Amps though the loop, and then drop the current to 0 at a contastant rate over 3.5 seconds. What is the EMF generated?
Instructions 50 cm 10 cm 8.0 A R = 1.0 × 10-3 N A small circular loop of wire of radius 5 cm and resistance 1E-3 Q is centered inside a large circular loop of wire of radius 50 cm. The larger loop, which initially carries a current of 8 A, is cut and its current is reduced to zero over a time interval of 1E-6 s. Our goal will be to find the average current in the smaller loop during this time interval. (The magnetic field of the larger loop is approximately constant over the smaller loop.)
Instructions 50 cm 10 cm 8.0 A R = 1.0 × 10-3 N A small circular loop of wire of radius 5 cm and resistance 1E-3 Q is centered inside a large circular loop of wire of radius 50 cm. The larger loop, which initially carries a current of 8 A, is cut and its current is reduced to zero over a time interval of 1E-6 s. Our goal will be to find the average current in the smaller loop during this time interval. (The magnetic field of the larger loop is approximately constant over the smaller loop.)
= In the figure below, the rolling axle, 1.50 m long, is pushed along horizontal rails at a constant speed v = 11.00 m/s. A resistor R 0.4000 2 is connected to the rails at points a and b, which are directly opposite each other. The wheels make good electrical contact with the rails, so the axle, rails, and resistor form a closed-loop circuit. The only significant resistance in the circuit is R. A uniform magnetic field B = 0.0700 T is vertically downwards. 100 (a) Find the induced current I in the resistor. A (b) What horizontal force F is required to keep the axle rolling at constant speed? N (c) Which end of the resistor, a or b, is at the higher electric potential? O Point a is at a higher potential. Point b is at a higher potential. Point a and Point b are at equal potentials. (d) After the axle rolls past the resistor, does the current in R reverse direction? Yes No Explain your answer.
Instructions 50 cm 10 cm 8.0 A R = 1.0 × 10-3 N A small circular loop of wire of radius 5 cm and resistance 1E-3 Q is centered inside a large circular loop of wire of radius 50 cm. The larger loop, which initially carries a current of 8 A, is cut and its current is reduced to zero over a time interval of 1E-6 s. Our goal will be to find the average current in the smaller loop during this time interval. (The magnetic field of the larger loop is approximately constant over the smaller loop.)