Answered: A sinusoidal signal, with an amplitude… | bartleby

Related questions

Question

A sinusoidal signal, with an amplitude of 3.10 V is applied to a uniform quantizer
of midtread type with output values of 0, ± 1, ± 2, ± 3 V, as in Figure 1. Sketch the waveform of the resulting
quantizer output for one complete cycle of the input.
-4.0 -3,5
Output
(volts)
14.0
3.0
-0,5
0.5
-1.0!
115
12.5
Figure-1
3.5 4.0
TH
Input
(volts)

Expert Solution

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

1. Consider a commercial power laser diode with an emission wavelength of 730nm. The threshold current when diode is operated at 30°C is 20 mA. The typical operating voltage for this device is 2V. At I = 100 mA. The output optical power is 60 mW. (a) Calculate the External Quantum Efficiency (EQE), External Power Efficiency (PCE), slope efficiency (nslope) of the laser diode. (b) What is the current required for an output optical power of 100 mW? (Hint: use nslope)
If the radius of a calcium ion is 0.22 nm, how much energy does it take to singly ionize it? Give your answer in electron-volts (eV) with precision 0.1 eV. Give your answer to 2 significant digits.
2. An electron is confined to a nanowire 2 nm in length. Model this system as a 1-D particle-in-a-box, going from 0 to 2 nm. a. Compute the probability that the electron is in the range 0.95 ≤ x ≤ 1.05 nm for the states n = 1, 2, 3. b. Compute the probability that the electron is located within a distance of 0.05 nm of the left end of the wire for each of the states n = 1, 10, 100.
a. Calculate the energy of the following signal : g(t) = 10te -10r 0stso
Plz answer correctly asap
Assume that State A has an energy of -2 eV, while State B has an energy of -4eV. Of the choices from the attatched image, which is true (say, at room temperature)?
In a H-atom series, the shortest wavelength transition is registered at 821 nm. plsease explain the step by step (1) Identify the transition. (2) Calculate the energy of the above transition in J and eV. (3) What is this series? (4) Calculate the longest wavelength in the series?
Each part of the figure below shows oscilloscope displays of various rectifier output voltages. In each case, determine whether or not the rectifier is functioning properly and if it is not, determine the most likely failure(s). ^^^^^^ (a) Output of a half-wave unfiltered rectifier (b) Output of a full-wave unfiltered rectifier (c) Output of a full-wave filter (d) Output of same full- wave filter as part (c)