A single-phase transformer, with primary turns of 500, is delivering full-load of 80 kW at a lagging power factor of 0.8 from a 220 V, 50 Hz supply. The current delivered to the load is 227 A. iv. Determine the current drawn from the supply. v. Assume the core and copper losses are 800 W and 3200 W respectively. Detemine the input power and efficiency of the transformer.

Q: A 100 kVA, 50 Hz, 440/11000 V, single phase transformer has an efficiency of 98,5% when supplying…

A: The objective of the question is to find the core losses and copper losses of a single phase…

Q: 4.27 A 10-kVA, 4160/240-V, single-phase transformer has a per-unit resistance of 0.01 and a per-unit…

A:

Q: Equivalent circuit diagram and electromotive force phasor for the idle operation of a step-up phase…

A: A transformer is a static device, it consist of two winding interlinked by common magnetic circuit…

Q: If the supply frequency of the transformer increases, the secondary output voltage of a transformer.…

A:

Q: Q. 36 Drive EMF equation of transformer and explain Primary winding, Secondary winding and…

A: Transformer - A transformer is a device that is used to transmit electrical energy. The transmission…

Q: Draw and explain the efficiency characteristics of transformer and regulation characteristics of…

A:

Q: Write the specification of transformer and voltage regulator

A: Transformer: At constant frequency, The device that converts electrical energy from one ac circuit…

Q: For an AC transformer, higher is the secondary leakage 1.higher is the secondary induced e.m.f…

A:

Q: 1. In a transformer, which options are correct: A. Works on Faraday’ law and Ampere’s law B. DC…

A:

Q: Q5:Choose the correct answer from the given alternatives (answer five only) 1.In an ideal…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: From the short circuit test and open circuit test in #19 and #20, the equivalent circuit of a…

A:

Q: If the open circuit voltage is 227V and the full load voltage is 207V, then the percentage…

A:

Q: A 600 kVA transformer has a primary winding resistance of 0.62 and a secondary winding resistance of…

A: We need to find a efficiency of transformer at full load with power factor 0.8 and on half loaded…

Q: An 11,000/230-V, 150-kVA, 50-Hz, 1-phase transformer has a core loss of 1.4 kW and full-load Cu loss…

A:

Q: Explain the origin of negative voltage regulation in a transformer. Derive the equation of no-load…

A: We will answer both subparts. It is asked to explain the origin of negative voltage regulation in a…

Q: A single phase transformer has a voltage transformation ratio of 0.4. The resistance and reactance…

A:

Q: We have a transformer designed to operate at 60 Hz. The voltage ratings are 4800 V rms and 240 V rms…

A: Given: A transformer is designed to operate at a frequency: f1=60 Hz New frequency is f2=120 Hz…

Q: equivalent winding (a) resistance,(b) reactance and (c) impedance referred to the high voltage side.

A:

Q: A 3-phase transformer, ratio 33/6.6-kV, A/Y, 1-MVA has a primary resistance of 8.5 ohms per phase…

A: 3 phase,E1=33kv,E2=6.6kv,Rating of transformer=1MVA,Primary resistance=8.5ohms,Secondary…

Q: Difference between sc and oc test in transformer...

A: The transformer's impedance must be known in order to determine its voltage control and efficiency.…

Q: The cross-sectional area of a transformer limb is 80 cm2 and the volume of the transformer core is…

A: Given parameters are: The cross-sectional area of a transformer limb,Ac=80cm2=80×10-4m2 The volume…

Q: 7. The primary and secondary induced e.m.fs. El and E2 in a two-winding transformer are…

A:

Q: SKVA, 50Hz, single phase transformer, the primary voltage of the transformer is 110V. Reqand X is…

A: Given data, Voltage (Vp)=220 VResistance(Req)=026ΩImpedance(Xeq)=0.4ΩVoltage…

Q: At 50Hz operation, a single phase transformer has hysterestic loss of 200 W, and Eddy current loss…

A: Given- Frequency f=50 Hz, Hysteretic loss ph= 200 W, Eddy current loss Pe= 100 W. To Find- The core…

Q: ) A single-phase transformer, with primary turns of 500, is delivering full-load of 80 kW at a…

A: We are authorized to answer three sub part at  a time, since you have not mentioned which question…

Q: A Wye-Delta transformer is connected to a 66 kV input three-phase transmission line. Each…

A:

Q: a 5kva, 757v/ 420V, single-phase transformer has the percentage regulation drops 4%. determine the…

A: KVA rating is given  S = 5 KVA. Primary voltage with no load E1=757 V. Secondary voltage with no…

Q: Solve for the efficiency at three-eight load at 0.85 power factor of a 10-kVA single phase…

A: As per our guidelines, we are supposed to answer only one question. Kindly repost the question as a…

Q: 3 kVA, 50HZ, Single phase transformer, the primary voltage of the transformer is 110V. Req and Xeql…

A: Voltage regulation: It is the  change in percentage of output voltage from the no load to full load.…

Q: A 11000/230 V, 150-kVA, 1-phase, 50-Hz transformer has core loss of 1.4 kW and full load copper loss…

A: The solution is given below

Q: Q2/ Fill in the blanks: 1- The two windings of a transformer is ........ linked. 2- If a transformer…

A: In this question we will write transformer related questions.....

Q: A short transmission line connects a step-up transformer on the source side with a series impedance…

A: The circuit diagram is shown below,

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.