A Sample of soil was tested in the laboratory, and results of the laboratory tests were as follows: Liquid limit =42% Plastic limit =16% U.S. Sieve Size Percentage Passing No. 4 100 No. 10 93.2 No. 40 81.0 No. 200 60.2 Classify the soil sample by the AASHTO classification system.

Q: Considering the following measurements, calculate the quantity passing and % retained applicable for…

A:

Q: Do the following: a) Calculate the percent retained and percent passing each sieve, and graph the…

A:

Q: Following the sieve analysis and the specific gravity of "SAND 1", a hydrometer test was performed…

A: The hydrometer test is used to determine the distribution of soil particle sizes that are smaller…

Q: Mechanical analysis on four different samples designated as A, B, Cand D were carried out in a soil…

A:

Q: the given data shows a sieve analysis of a soil sample. classify the soil using aashto method. a.…

A: Given : Liquid limit, LL = 38% Plastic limit, PL = 29% Sieve No. Diameter (in mm) Percentage…

Q: Help me and show me the steps to Classify the soil by the AASHTO system.

A: The objective of the question is to classify the given soil sample using the AASHTO (American…

Q: Consider the grain size gradation curve for the soil shown in the image below and classify the soil…

A: Look at the % passing through sieve no 200=20<50%⇒COARSE GRAINED SOIL

Q: LL=25% PI=15% Cu=_____

A: From graph :D60=0.05mmD30=0.0026mmD10=0.0007mmFind uniformity coeff:Cu=D60D10=0.050.0007=71.4285Find…

Q: A laboratory test was conducted according to Method A of the ASTM D4318 to find the liquid limit of…

A: The wet mass of the soil sample with the mass of the can is measured, again the dry mass of the…

Q: Determine the following: Percent passing and Particle Size Distribution Curve Effective Size…

A:

Q: Question 1 Marks 15 The laboratory test data of Muscat soil is given below in the table below. Sieve…

A:

Q: The soil is classified as using the USCS method

A:

Q: Question 4 Listen The principal objection to the use of the microwave oven for water-content…

A:

Q: Q.12.32 Mechanical analysis on four different samples designated as A, B, Cand D were carried out in…

A:

Q: Sieve size (mm) Mass retained Sieve no. (grams) 3/8" 9.53 4.75 310 10 580 20 0.84 380 60 0.25 260…

A: The given data is: Sieve No. Sieve Size (mm) Mass Retained (grams)       3/8" 9.53 0       4…

Q: Mechanical analysis on four different samples designated as A, B, Cand D were carried out in a soil…

A:

Q: Classify the soil by AASHTO system.Justify your answer. provide fbd

A: AASHTO CLASSIFICATION:

Q: -) The following are the results of a sieve analysis: US. Sieve No. Mass of Soil Retained on each…

A: Sieve   Mass  % mass Cumulative % Cumulative % No Sieve size Retained Retained Retained Passing…

Q: A sample of soil was tested in the laboratory, and the test results were listed as shown in the…

A: As percent passing No. 200 (58.8%)is more than 36%, the soil is either A4,A5,A6 or A7 depending on…

Q: Classify soil A depicted in the table according to the AASHTO classification system. Sieve analysis-…

A:

Q: Yiren was given a soil sample which yields the following passing percentage for different sieves.…

A:

Q: The laboratory test data for a standard Proctor test are given below. Volume of Moisture content…

A:

Q: Classify the soil using AASHTO. The liquid limit and plastic limit are found to be 30 and 20,…

A: iLook at the %passing through No 200 sieve :=20%<35% so Granular material

Q: Example: If the moisture content of your prepared sample is 20% with an estimated 95% finer than the…

A:

Q: Soil sample and its corresponding properties: SOIL PROPERTIES SOIL SAMPLE % Clay fraction (<2 µm)…

A:

Q: Q.82 Mechanical analysis on four different samples designated as A, B, Cand D were carried out in a…

A:

Q: From your Atterberg limits tests on the -40 portion of these samples, you have obtained the…

A: Given,

Q: Mechanical analysis on four different samples designated as A, B, Cand Dwere carried out in a soil…

A:

Q: b. A-6(3) c. none d. A-6(4)

A: iLook at the % passing through No 200=60%&gt;35%so Clay-silt material

Q: B. Solve the following problems. Write your answer in a long bond paper. Avoid Erasures. 1. The…

A:

Q: What is the difference between Henry's Law constant and vapor pressure? What is an example of each?

A: The Henry's law constant is a proportionality constant which depends upon type of solvent solute and…

Q: a) Sieve analysis of sand sample gave the following results: Mass retained (gm) Sieve No. 6-8 73…

A: From the Given Data: do the sieve analysis procedure as below and plot the graph as Gradation vs…