A resistor and inductor are connected in parallel to a 400 Hz line. The inductor has a voltage drop of 136 volts across it. What is the voltage drop across the resistor?

Q: Use the method of source transformation to find the voltage V in the circuit below. RI = 402 ЗА 6Ω…

A:

Q: a)For the inductive element of Figure 1 , the current in phasor form is B) the voltage in phasor…

A: The solution can be achieved as follows.

Q: 1.1 For two inductors in parallel aiding as in Fig.1, show that the equivalent inductance is Leq…

A: Given: Required: Equivalent inductance of two inductors in parallel aiding connection.

Q: 13 240 V 60 Hz 200 Determine the inductance value if the source current is 13 A ww-

A:

Q: Determine the values of resistance R and inductance L

A: We need to determine the values of R and L.

Q: A coil having an inductance of 200 mH is magnetically coupled to another coil having an inductance…

A: Inductance of coils are given Coeficient of coupling between coils k = 0.65.

Q: 5uF capacitor is connected across an emf of 50    Volts maximum value and frequency of 1000 cycles.…

A:

Q: Ques BOV Hre maxim come acuos What wil be valtage ứn capdetance un

A:

Q: Use Thevenin Equivalence to find the value of the load resistance RL to achieve maximum power…

A: As per maximum power transfer theorem, maximum power transfer to the load resistor (RL), if load…

Q: Why not use inductance in DC circuits

A: The explanation is as follows.

Q: the non-inductive resistance of kelvin double bridge are set at 1000 each, the standard resistance…

A: Kelvin double bridge it's used to measure low resistance.  Resistance R= 1000 ohm Standard…

Q: How does the internal resistance of the multimeter (in voltage setting) affect the…

A: Given: Effect of Internal resistance of the multi-meter on capacitor

Q: I'm reading about the electronics in touch screen. It says when i touch the panel it distorts the…

A: According to the question, we need to explain the working of the touch screen.

Q: Find Reg between points a and b. 3.6 k2 1.8 k2 1.8 kN 10.8 k2 21.6 k2 36 kN 36 kN 9 kN 36 kN

A: This is a very simple question based on network analysis. Equivalent resistance is to be determined.…

Q: What is the value of the induced voltage of the self-inductance when the rate of current is from 200…

A: First, find the rate of change of current, didt=20μ-200μ5u=-36 A/s Let the self-inductance of the…

Q: A thin metallic foil is placed between the plates of a flat capacitor parallel to them. How does…

A: Capacity of flat capacitor when A thin metallic foil is placed between the plates :  Although it is…

Q: What benefits are there the electrical industry to install capacitors in inductive circuits

A: benefits are there the electrical industry to install capacitors in inductive circuits?

Q: How much is the inductance of a coil that induces 500 V when thje current changes at the rate of 5…

A: Given, Induced voltage, V= 500 V Current changes at the rate of 5 mA in 2 μs So,…

Q: A five-Ohm resistor is in series with a 0.001-Henry inductor and is supplied from a 10-V DC source.…

A:

Q: A capacitor of 1µF is charged to 100 volts and then disconnected from the power supply. A second but…

A: First calculate initial charge on the capacitor.  Now using initial charge calculate voltage across…

Q: 9. What is the result of increasing the frequency of the applied voltage to a capacitor? A.…

A: In this question we need choose a correct option.

Q: Why does the current increased if the frequency is adjusted higher in Pure Capacitor while current…

A:

Q: and what will happen to the current if the frequency is adjusted lower in pure inductance…

A:

Q: A utility company plans to connected a total of 20uF of capacitance to a 7,200 volt line. To make…

A:

Q: How temperature effect conductivity? Explain with the help of following equation. m e'n7'

A: Ans) Conductive decreases as the temperature increases.

Q: The waveform displayed on an oscilloscope is as shown in Figure The 'time/cm' switch is set to 2…

A: CRO waveform

Q: Explain why an inductor is a short circuit to DC.

A:

Q: Can Ohm's Law be applied to inductance?

A:

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.