A reinforced concrete tied column carries an axial dead load of 600kN and a live load of 800KN. PROBLEM 7.1: = 414MPa. Assume f = 27.6MPa and fy a. b. Determine the smallest dimension of the column section. Which of the following gives the number of 25mmØ bars. Ans: b= 265.159 mm Ans: 12 pcs

Q: Differentiate between the following:…

A: slab - its the flat plate element in the building having some thickness to resist the moment and…

Q: match the following

A: Solution:- given following image is,

Q: While the concrete is still plastic, the accumulated water due to bleeding can be used to mix…

A: Answer  (a) increase (b)  enhances (d) improves are correct option.

Q: If a contractor proposes to increase concrete cover beyond contractual specification (i.e. 40mm to…

A: A contractor is a person or company which takes the tender of work to be completed in a specified…

Q: 1. ONLY ATTACH PHOTOS NEEDED. a. ATTACH THE PHOTOS SHOWING HOVW THE SOUNDNESS OF CEMENT TEST IS DON…

A:

Q: Why is plenumrated cabling required above ceiling tiles?

A:

Q: Give 100 types of concrete failure

A: Carbonation and chloride contamination of the concrete are the two most typical reasons of failure.…

Q: Select the appropriate flooring materials for various applications?

A: For providing the finishing of the floor, the material is used is called flooring material.  It is…

Q: Define the difference in application between open stirrups and closed stirrups in concrete beams?

A: Basically function of the stirrups is to  Resist shear stress developed in the beam  Hold the main…

Q: What type of building systems are CLT panels used for?

A:

Q: What justifies the need for plenumrated cabling above ceiling tiles

A: plenum-rated cables are those cables whose outer coating is fire resistant, which helps in…

Q: Based on preliminary estimates and the architect’s design, a team member has developed the…

A: The given figure is shown below:

Q: Explain the function of metal reinforcement and how the metal reinforcement treatment process

A:

Q: What are the plywood exposure durability classifications? Give an example of where each could be…

A: Plywood is manufactured in four durability classification namely exterior, exposure 1, exposure 2…

Q: Propose the materials for the given problems/scenarios and support your answer.   Types of Brick to…

A: Brick initially referred to a molded clay-based residential unit, and it is often used to relate to…

Q: Determine the optimal roofing material and create a list of three (3) critical features to consider…

A: When it comes to selecting the optimal roofing material, the consideration of appearance,…

Q: What are Different types of kerbs  ?

A: The kerbs are the vertical slope which is provided along the edge of pavement or shoulder so as to…

Q: Define purpose of adding cooling pipes or even using cold water for concrete in concreting…

A: All these measures aim at reducing the placing temperature and reducing thermal cracks induced…

Q: What justifies the need for plenumrated cabling above ceiling tiles?

A: Ceiling tiles are the false ceiling which used for architectural purposes. The space…

Q: What's the advantage of Composite structures?

A:

Q: Describe fire-protection procedures for structural steel members required by building codes?

A: The fire-protection procedures for structural steel members required by building codes are:

Q: Identify the level of exposure defined: Indoor or outdoor service in which concrete is not exposed…

A: Answer Level of Exposure for Indoor or outdoor service in which concrete is not exposed to freezing…

Q: Explain the Best chemicals used for waterproofing concrete?

A: Water has permeable properties; so no building is safe from the permeability of water in the short…

Q: The T shaped cross section shown below is reinforced with 4 of 32 mm bars with fc'= 20.7 MPa and fy…

A:

Q: Assuming the following information • Parapet is 12550 mm long Blocking is 1x2 dimensional lumber…

A: Solution:- Given data:- Length of parapet = 12550 mm Blocking is 1 x 2 dimensional lumber   To…

Q: What are the various materials used to make fiberglass shingles?

A: Fiberglass Shingles :  1. Fiberglass shingles are made of a woven fiberglass base mat, covered with…

Q: PLACE YOUR ANSWERS HERE. I x,0 = 10 " 1" I y,0 = r x,0 = 4"X6"X ½" ry.o = 12" 4"X 8"X 1" 1" 10 "

A:

Q: 1. Show how actual strength compared with design strength by plotting the published column strength…

A: Solution: Column curve: Column or strut is a compression member, the effective length of which…

Q: If i were to create a full pumice stone bath mat, what materials should be used?

A: Developing a complete pumice stone bath mat requires a thorough examination of technical factors and…

Q: What considerations should be made when inspecting building structural steel connections for safety…

A: When inspecting building structural steel connections for safety and durability, several key…

Q: Define the following i) SMRF Structures ii) IMRF Structures

A: 1. The SMRF structures and IMRF structures are types of moment-resisting frames use to resist the…

Q: Identify the influence of fly ash, GGBS and silica fume on fresh concrete.

A: To enhance the qualities of concrete, additional cementitious ingredients such as fly ash, ggbs, and…

Q: 1: When a wood stud wall is placed on concrete or 2: Fire Protection /Fire Rating of Door & Windows…

A: (1) The stud wall is generally placed on a bottom plate of 2 x 4 wood studs. The actual dimension of…

Q: Please provide the enough information and definition of these construction terms:  Reinforced…

A: As per our guideline we are supposed to give  only first three answer of this question because this…

Q: General Specification for Civil Engineering Works (1992 Edition) Clause 15.09 specifies that tying…

A: Answer Plain steel tying wire mainly used for the reinforcement adjacent to class F4 and F5 finish

Q: How are concrete floors given a colored surface?

A: Answer A concrete Floor is the alternative floor of marble, stone, or tile floor. The concrete floor…

Q: Differentiate the wood shake and wood shingles?

A: Wood shake and wood shingles are wood roofing material. wood shingles are sawn on both side whereas…

Q: General contractor General specification Gravitational acceleration

A: 1. General Contractor A General Contractor is the actually defined as an individual or a company…

Q: Problem 6: Find a real-world reinforced concrete failure. Was it a strength or service limit state…

A: We need to discuss real world reinforced concrete failure and if design code were changed after that…

Q: Explain LEED Considerations under Concrete Sustainability.

A: The most popular green building rating system in the world is LEED (Leadership in Energy and…

Beams

In structural engineering, a beam is a component made of a variety of materials (including steel alloys, and wood) that can resist loads applied laterally to the beam axis. Members, elements, rafters, shafts, and purlins are all terms used to describe beams.