A rectangular plot was measured with a 20 m chain and its size was established as 450 m x 250 m. Later on, it was found that the chain used for measuring the sides of plot was 15 cm too long. What is the true area of the plot?

A rectangular plot was measured with a 20 m chain and its size was established as 450 m x 250 m. Later on, it was found that the chain used for measuring the sides of plot was 15 cm too long. What is the true area of the plot?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: DEFINE WATER RESOURCES PLANNING (in your own understanding/150-200 words)

Q: What are reaction forces?

A: A reaction force opposes an intervention force by acting in the opposite direction. During sliding,…

Q: What are GPS receivers used for, and why are they included in mobile devices such as smartphones?

A: This question is related to the GPS and Satellite from Civil Engineering and Astronomy Engineering.…

Q: The whole question is all here.

A: Given, Compartment 1, P= 1674.59 W Compartment 2, P=267.935 W Compartment 3, P=66.983 W

Q: draw a diagram for three Cafeteria objects sharing the same opening and closing times?

A: The cefetaria diagram is given below,

Q: What are GPS receivers used for, and why are they included in mobile devices such as smartphones?

A: Given: GPS

Q: What are the places that attract tourists in your country? Is there any problem caused by tourism in…

A: Tourists expectations when visiting a particular place are related to several features of the chosen…

Q: 45 % and P Gravel is 55 %. answer the below questions: Amount Amount Sieve No. Retainded (g)…

A: Cumulative percentage retained for sand alone is shown in the table below.

Q: Why is it important to make accurate surveys of underground utilities?

A: The underground utility is the term used for infrastructure like pipes, sewers and cables etc.…

Q: please put the answer in paper

Q: What is thephysical facilities existing ventilators lights etc?

A: The most essential physical facilities to just be organized are as follows: Construction of a…

Q: How about reaction A

Q: Write in your one word three sentences of the term hydrology

A: Hydrology:- In Civil Engineering, the term hydrology is treated as the branch of engineering which…

Q: What is irrigation?

A: Given data Irrigation engineering To be discussed What is Irrigation

Q: Why EDM and satellite systems are commonly used?

A: EDM Ranging (Electronic Distance Measurement)Distance measurement in modern surveying is mostly done…

Q: What is the full form of NAVSTAR?

A: NAVSTAR is a network system of U.S . Their are 24 satellites which provide perfect position and…

Q: How are the Change orders usually initiated?

A: The change order is also referred as extra work, a change directive, or a variation order. It is a…

Q: EQUIPMENT: backhoe What are the descriptions of the type of equipment, operating environment,…

A: We have to discuss the given type of construction equipment BLACKHOE. Descriptions of the type of…

Q: Write introduction about 'Measurement range and Sensitivity' that show it's importance and it's…

A: Measuring Range:

Q: What, then, is the connection between solar panels and GPS?

A: GPS stands for Global Positioning System, which is a satellite-based navigation system that provides…

Q: Discuss Drilling Rigs

A: Drilling rigs:

Q: quoting

A: Quoting vehicle modification is the process in which the cost is determined which is being incurred…

Q: Below is the first set of activities (Phase I) in constructing a new house, the respective time…

Q: In the attached example, find the following. 1- All project paths 2- A The time required to complete…

Q: explain how electricity is generated through dam ?

A: One of the renewable sources of energy is hydroelectric power, where the power of flowing water is…

Q: HERE IS A CHART ON QUESTION REAL,MOHR PLEASE ANSWER

A: Solution: From calculation: for inclined plane stress: σ1=2.05 ksfσ3=-6.05 ksfτmax=-1.585 ksf From…

Q: So, how much do solar panels help global positioning systems?

A: Global Positioning System (GPS) is a satellite-based navigation system that allows users to…

Q: Name and explain two or more virtualization security issues among Drones and Autonomous Aerial…

A: Introduction- Drones and Autonomous Aerial Vehicles- An unmanned aircraft is a drone. Unmanned…

Q: Fixed time includes all of the following, EXCEPT one. Spot time Load time Dump time Break time

A: The eraser can dig, load, pull, and dispose of objects in the intermediate and even distances the…

Q: Part A Using the dolphin's diameter as its characteristic length, what is the Reynolds number as…

Q: why it’s important to have the number of trips

A: The trip generation is used to determine the types and number of trips originating and terminating…

Concept explainers

Asphalt Binders and Mixtures

Asphalt binders are subsidiary products procured during the refining process of petroleum while manufacturing gasoline, diesel, and similar petroleum products. Asphalt binders are obtained from the residue that remains after the distillation of petroleum, this residue is further subjected to steam distillation and oxidation to remove the traces of gas oil present in the residue. Certain additives or modifiers are also added to asphalt binders to alter them to suit different applications.

Question

I need the answer as soon as possible

A rectangular plot was measured with a 20 m chain and its size was established
as 450 m x 250 m. Later on, it was found that the chain used for measuring the sides of plot was 15 cm
too long. What is the true area of the plot?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

What are the transmission ways of airborne sound/noise in buildings? Explain four main transmission way of sound. (Beside your explanation use drawings)
What are Relevant Events?
What are your major takeaways for our topics Geotechnical Engineering. Write at least 5. Make it short and direct to the point.
Give the uses of Two-way Radios on the projects?
ASAPPP PLS BE DETAILED
(2) :Signs: Classification 1. Regulatory signs O 2. Warning signs O 3. Guide signs O Studs (Cat eyes) O 1+2+3 O
Define Unilateral Change Orders.
Communication barriers faced by engineers
Provide complete and organized solutions with necessary illustrations and diagrams. Use at least 3-decimal places for your calculations or solutions. Review your calculations and the principles used in dealing with the activity. Provide a summary or tabulations of your answers or results.
YOU GOT THE ANSWERS WRONG, PLEASE REATTEMPT THEM
How can the change order be prepared?
This is about higher order DE ANSWER ITEM #2 ONLY