Below is the first set of activities (Phase I) in constructing a new house, the respective time required to finish each activity, and the precedence relations. Activity A Description Clear site Predecessor Duration (in wks) 1 В Bring utilities to the site Excavate Pour Foundation Outside Plumbing Frame House 2 A 1 D 2 E В.С 6 F D 8 G Do electric wiring Lay Floor Lay Roof Inside Plumbing F 3 G 2 F E,H 5 (a) Construct the AON network. (b) Using AOA network, find the critical path/s and the project completion time. Summarize the results in a CPM Table. (c) What event is represented by node 2? Note: labeling starts at 0.

Below is the first set of activities (Phase I) in constructing a new house, the respective time required to finish each activity, and the precedence relations. Activity A Description Clear site Predecessor Duration (in wks) 1 В Bring utilities to the site Excavate Pour Foundation Outside Plumbing Frame House 2 A 1 D 2 E В.С 6 F D 8 G Do electric wiring Lay Floor Lay Roof Inside Plumbing F 3 G 2 F E,H 5 (a) Construct the AON network. (b) Using AOA network, find the critical path/s and the project completion time. Summarize the results in a CPM Table. (c) What event is represented by node 2? Note: labeling starts at 0.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: When selecting construction equipment used to build a building, the contractor should always do the…

Q: Assignment # 3. For the following schedule, draw the arrow diagra (AOA), perform the CPM…

A: Given schedule and asked to draw the activity on Arrow diagram (AOA) and mark critical path.It is…

Q: 12. Compute the values of ES, EF, LS, LF, FF, and TF for the activities in the following network. 1…

Q: Draw the original network and calculate the CPM values, then check the effect of these updates and…

Q: The weights of the two boxes are W₁ = 50 lb and W₂ = 50 lb. The coefficients of friction between the…

Q: Draw Arrow Diagram (Activity-on-Arrow, AOA). Activity Depends on Activity Depends on В, С, Е F, G A…

Q: Prepare a Precedence Diagram for the following construction plan Activity Duration Preceding…

A: Following Figure shows the Activity Times of the Precedence Network

Q: Activity durations for a 5km piping project are listed below. The minimum time buffer between…

Q: Describe about the well point assembling.

A: Let’s first understand what is well point: A series of closely spaced small diameter of water…

Q: Kindly solve this question under Measurement and Specifications for Civil Engineers.

A: Based on the information provided and the Contract Specifications, here's the takeoff for the…

Concept explainers

Site Plan Requirements

A site plan (also known as a plot plan) is a diagram or process to show the proposed improvements on an existing property. A site plan is important, as it provides information regarding the landscape features of a given plot of land. Zoning is done or can be understood with the help of a site plan.

Question

Below is the first set of activities (Phase I) in constructing a new house, the respective
time required to finish each activity, and the precedence relations.
Activity
A
Description
Clear site
Predecessor Duration (in wks)
1
В
Bring utilities to the site
Excavate
Pour Foundation
Outside Plumbing
Frame House
2
A
1
D
2
E
В.С
6
F
D
8
G
Do electric wiring
Lay Floor
Lay Roof
Inside Plumbing
F
3
G
2
F
E,H
5
(a) Construct the AON network.
(b) Using AOA network, find the critical path/s and the project completion time.
Summarize the results in a CPM Table.
(c) What event is represented by node 2? Note: labeling starts at 0.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

For the given construction project: 1. Draw the Precedence Diagram 2. Calculate the forward and backward passes 3. Highlight the Critical Path No. Activity Duration Predecssors Relationship Lag 1 Mobilize 1 2 Clearing & Grubbing 3 Layout Fence Alignment 1 2 4 Deliver Posts to Site 3 SS 1 5 Auger Post Holes 7 4 SS 2 6 Set Posts in Holes 7 SS 7 Backfill and Plumb Posts 10 6. SS 1 8 Install Boards for Fence 5 7 FF 1 9 Deliver Boards for Fence 3 8 SF 7 10 Paint Boards 12 8 SS 11 Plant Shrubs Along Fence 7 10 SS 8 12 Final Inspection 1 8, 10*, 11 |(10*)/2 13 Demobilize 1 12 3.
“Solve for the support reactions and draw and label the SFD and BMD
10. From the following table, draw the precedence network, perform the CPM calculations, and complete the table entries, assuming interruptible activities. Activity A ABCO с Duration IPA Type Rel Lag ES 3 3526 5 2 6 LAABC А B с SS FF 3 EF LS LF TF FF "If the relationship type is not mentioned, it is finish to start (FS). If no lag is mentioned, it is zero.
18 ns search A+ 3 F3 to Mobilize 07 4 0 6 08 $ 05 Dur=1 Activity Duration What is the Early Finish of Buy Material? FF TF LF с F5 % ci do Remove old Cabinets Dur=9 5 CU !! Buy Materials Dur = 5 ներ պրոցե Ð F6 CAINIL 6 W F7 v lo & 7 F8 * 8 F9 F10 ( 9 76°F L ဆုံး
F3 C The document typically marking the beginning of a project is called a O Substantial start Notice to proceed 4 $ Request for information Substantial completion 1.8 F4 R F [ C || V F5 % 5 T G F6 ‹ CO 6 B W ✈ F7 Y H & 7 F8 U N * 00 8 J F9 M 019 9 F10 K 76°F Light rain ☀- O F11 9 $0
Use the data in the table below to draw the precedence network and perform the following leveling exercise. leveling pdf included.
A simple house project can be structured as follows (9 work packages total): • Design: Ground plans + External design • Structure: Excavation + Foundation + Roof + Frame • Services: Electricity + Plumbing + HVAC Create the Work Breakdown Structure (WBS) of the project described above, using a tree structure. Use the following numbering system: • ‘1’ for the top level (House Project) • ‘1.1’ onwards for the second level • ‘1.1.1’ onwards for the third level
Develop a programming budget estimate for a 100,000 square-foot warehouse, assuming a square-foot cost factor of $60 per square foot. The site will be about 200,000 square feet with a site development cost of $3 per square foot. Use the following allowances to prepare your budget estimate: - Owner-furnished FFE: $1,000,000 - Owner soft costs: $800,000 - Programming fees: $50,000 - Geotechnical Investigation: $390,000
Question 48 schedule is a schedule in which the resources for a project are assigned to activities so the activities can be closely monitored. O resource-loaded O time-loaded A look-ahead O preliminary amazon Bcer F12 Scr Lk Artêtdéf PrtSclimpréc SysRg/Syst. F4 F5 F6 F7 F8 F9 F10 F11 Bre VA
fill in the graph and color critical path red. Check to see if it is all correct or if changes need to be done. Abbrevations are ES: early activity start LS: Late Activity Start Duration TF: Total Float EF: Early Activity Finish LF: Late Activity Finish
bint Pr X y Term ProjectCx y SURP 816: Phy X E TEC 3739 Gro x M V Lab Example E Foundation HV x Phase 2 Repor X A asulearn.appstate.edu/mod/quiz/attempt.php?attempt=3358733&cmid%3D2173348 as learn A ULC C3739-101_MATERIALS AND STRUCTURES III (SPRING 2022) ard/ My courses / Spring 2022 / TEC3739101-12999202210 (SPRING 2022) / HOMEWORK / Foundation HW - Part III (Due date: 04/04/2 n1 Please round to the nearest One (i.e., 1). No Comma! The results of a plate-load test in a sand soil are shown below. The size of the plate is 0.275m x 0.275m. If a square column foundation (5m x 5m) that should carry a load of 5000kN, what is the estimated settlement of the ed out of foundation? Load/unit area Settlement Load/unit area (kN/m?) (KN/m?) (mm) 800 200 400 600 200 6 300 10 400 13 500 20 20 600 29 30 40 50 60 70 Answer = mm MacBook Air Settlement (mm)
Develop a programming budget estimate for a 100,000 square-foot warehouse, assuming a square-foot cost factor of $60 per square foot. The site will be about 200,000 square feet with a site development cost of $3 per square foot. Use the following allowances to prepare your budget estimate: - Owner-furnished FFE: $1,000,000 - Owner soft costs: $800,000 - Programming fees: $50,000 - Geotechnical Investigation: $390,000