A reciprocal leveling is observed across a wide river and the reciprocal level readings were taken between points A and B as follows. With instrument set up near A, the rod readings on A are 2.283 and 2.285m. The reciprocal level reading on the opposite side of the river at point B are 3.620, 3.619, 3.623 and 3.625m. With the instrument set up near B, the rod readings on B are 4.479 and 4.477 m. and the rod readings on the opposite side of the river at point A, the rod readings are 3.145, 3.141, 3.146 and 3.144 m. a.) Compute the difference in elevation between A and B with the instrument set up near A. b.) What is the true difference in elevation between A and B. c.) If the elevation at A is 308 m., what is the elevation of B.

A reciprocal leveling is observed across a wide river and the reciprocal level readings were taken between points A and B as follows. With instrument set up near A, the rod readings on A are 2.283 and 2.285m. The reciprocal level reading on the opposite side of the river at point B are 3.620, 3.619, 3.623 and 3.625m. With the instrument set up near B, the rod readings on B are 4.479 and 4.477 m. and the rod readings on the opposite side of the river at point A, the rod readings are 3.145, 3.141, 3.146 and 3.144 m. a.) Compute the difference in elevation between A and B with the instrument set up near A. b.) What is the true difference in elevation between A and B. c.) If the elevation at A is 308 m., what is the elevation of B.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Date Monitored: October 9, 2020 Total Station Vertical Angle Reflector HI=1.360 Slope Distance…

Q: In a two peg test of a dumpy level using alternative method, the following observations were taken.…

Q: Example 5) For the purpose of realizing the work of the dirt dam, the survey was repeated, and the…

A: Given Data: Leveling station is 00+1. Level of leveling station is h=12.06 m.

Q: The following data were taken along a center line of a dam AB. The staff had been held in the 1st…

A: Required :- 1- Enter the given data in a level book form. 2- Find the reduced level of points using…

Q: Reciprocal levelling was done between two points A and B, the readings of which are as shown below:…

Q: Q: Using a digital laser level instrument, the following staff readings were observed via an open…

A: Here we have given a open loop and we will use rise and fall method to calculate the RL's of each…

Q: situation 2] Two surveying tapes were used in measuring the frontage of an open field. The resulting…

Q: 2. A reciprocal leveling is observed across a wide river and the reciprocal level readings were…

Q: In the two peg-test method of a dumpy level the following observations were taken. Instrument Near A…

A: Data for two-peg test method is given.

Q: Instrument near Staff readings A B RL. (m) 1.520 1.535 80.00 B 1.595 1.580

A: Solution:- R.L of point B is given as, Elevation difference between A and B H=hB-hA+hBι-hAι2…

Q: Two Pegs A and B were fixed on opposite banks of a 50 m wide river. The level was set up at A and…

A: Two pegs A and B were fixed on opposite banks of a 50 m wide river. The level was set up at A and…

Q: 3.19 Two pegs A and B were fixed on opposite banks of a 50 m wide river. The level was set up at A…

Q: 4. In the two-peg test of a dumpy level, the following observations are taken: with level setup at M…

Q: The readings given below were made with a tacheometric theodolite having a multiplying constant of…

Q: Calculate the RLS of A, B and C, and horizontal distances AB and BC. The tacheometer is fitted with…

A: Given, Tacheometer is fitted with an anallatic lens and multiplying constant (k) is 100 and for…

Q: Reciprocal levelling is done to test a dumpy level, along a chain line, at a common interval of 25m,…

A: Given DatReduced Levels (RLs) at first station = 97.535 mReadings (BS, IS, FS) = 3.200, 2.135,…

Q: In order to transfer reduced level across a canyon, a reciprocal leveling campaign was conducted.…

Q: 12. Complete the benchmark-leveling field notes shown in Figure B by computing and recording the HI…

A: Objective: To completer the given leveling notes and perform the arithmetic checks. Given: Sta.…

Q: Two field parties working on South Field Traverse each independently measured the length of one side…

Q: 2. A reciprocal leveling is observed across a wide river and the reciprocal level readings were…

Q: 13. In the two-peg test of a dumpy level, the following observation were taken: With level set up at…

Q: Reciprocal levelling is done to test a dumpy level, along a chain line, at a common interval of 15m,…

A: The readings from the dumpy level are given with 135m as the starting point with 15m intervals,…

Q: Problem 3. While leveling between two points Pand Qon opposite banks of a river, the level was first…

Q: In the two-peg test method of a dumpy level, the following observations were taken. Determine the…

A: First we will find difference in elevation.

Q: Define the attached problem ?

A: Consider the distance v/s time graph using the values The velocities of the P-waves through the…

Q: n leveling across a deep and wide river, reciprocal level readings were taken between two points, X…

Q: STA. B.S. F.S. 1 5.87 2 7.03 6.29 3 3.48 6.25 4 7.25 7.08 5 10.19 5.57 6 9.29 4.45 7 4.94 For…

A: Lets using Rise/Fall method B.S - F.S = Rise/Fall Positive difference mean rise Negative…

Q: A line was measured three times and yield the following results; 856.42, 856.69 and 856.12 m.…

A: Answer Probable error of the mean is given by Em = Esn Es = Probable error of a single measurement…

Q: The readings (2.312, 1.185, -2.365, 0.195, 0.885, 1.345, 0.905) were taken with a level. The…

A: point back bearing fore bearing height of instrument elevation of point remark 100 BM…

Concept explainers

Errors in surveying

An error in surveying is defined as the difference between two or more values of an identical quantity. However, the estimates are never accurate and there will always be a degree of variability regardless of the research tool or method used. These differences are known as errors that need to be reduced or eliminated to maintain certain levels of accuracy. Even if you carefully follow the prescribed test procedures, the considerations may contain errors.

Question

A reciprocal leveling is observed across a wide river and the reciprocal level readings were taken between points
A and B as follows. With instrument set up near A, the rod readings on A are 2.283 and 2.285m. The reciprocal
level reading on the opposite side of the river at point B are 3.620, 3.619, 3.623 and 3.625m. With the instrument
set up near B, the rod readings on B are 4.479 and 4.477 m. and the rod readings on the opposite side of the
river at point A, the rod readings are 3.145, 3.141, 3.146 and 3.144 m.
a.) Compute the difference in elevation between A and B with the instrument set up near A.
b.) What is the true difference in elevation between A and B.
c.) If the elevation at A is 308 m., what is the elevation of B.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

In a two peg test using a dumpy level, the following observations were taken: Instrument at C Instrument at D Rod reading on A 1.103 .568 Rod reading on B .991 .289 Point C is equidistant from A and B and D is 12m from A and 72 m from B. What is the true difference in elevation between A and B (in meters)? (answer in 3 decimal places) With the level in the same position at D to what rod reading on B should the line of sight be adjusted (in meters)? (answer in 4 decimal places) What is the corresponding rod reading on A for a horizontal line of sight with instrument still at D (in meters)? (answer in 4 decimal places)
In the two peg-test method of a dumpy level the following observations were taken. Instrument Near A Instrument Near B Rod Reading on A 1. 475 m 0. 918 m Rod Reading on B 1. 974 m 1. 254 m Determine the following: A. Difference in elevation between A and B. B. The correct reading on A with the instrument still set-up at B, if the line is not in adjustment. C. Error in the line of sight.
Solve correct method.!
In the two-peg test of a dumpy level, the following observations were taken. Rod reading at A Rod reading at B (m) (m) Instrument at pt. M 0.396 0.910 Instrument at pt. P 1.4 2.14 Point M is equidistant from both A and B, while point P is outside line AB, 2.5 meters from A and 79.27 m from B. *in the space provided, indicate: a. Find the difference in elevation between A and B. b. Adjust the correct readings when the instrument was at point P.
Question 49 In leveling across a river, reciprocal level readings were taken between two points A and B. From a set up near A: on A, 0.994 and 0.992 m; on B 2,076, 2.077, 2.078 and 2.077 m. At the set up near B: on H, 2.550 and 2.548m; on A, 1.462, 1.463, 1.464 and 1.463. From the observed data it can be determine that A. B is 1.085 m below A B. B is 1.085 m above A C. A is above B by 1.088 m D. A is below B by 1.084 m E. A and B are of the same elevation
2. The following are the observations made on the same angle: 47°26'13" 47°26'18" | 47°26'10" | 47°26'15" 47°26'16" 47°26'12" 47°26'09" | 47°26'15" 47°26'14" 47°26'18" Determine: c. The standard deviation
SITUATION VII. In a two-peg test of a dumpy level, the following observations were taken: Rod Reading on A Rod Reading on B Instrument A 1.428 2.034 Instrument B 0.935 1.441 14. What is the difference in elevation between A and B? a. 0.539 m b. 0.556 m c. 0.542 m d. 0.514 m
no.2
With Given, FBD and solution please. (3 decimal points for final answer)
SITUATION 5. In the two peg-test method of a dumpy level the following observation were taken. Instrument set up near A Instrument set up near B 1.505m 0.938m 1.449 Rod reading on A Rod reading on B 2.054m a. What is the difference in elevation between A and B b. If the line of sight is not in adjustment, determine the correct rod reading on A with the instrument still set up at B. C Determine the error in the line of sight. C C.
In the two peg-test methods of a dumpy level, the following observations were taken. Instrument set Instrument set up near A up near B Rod reading on A Rod reading 2.35 m 1.05 m on B 2.90 m 1.25 m [ Select ] Determine the error in the line of sight. [ Select ] If the line of sight is not in adjustment, determine the correct rod reading on A with the instrument still set up at В.
complete the different leveling notes by providing data to the unknown quantities. show solution