The readings given below were made with a tacheometric theodolite having a multiplying constant of 100 and no additive constant. The reduced level at station A was 100.0 m and the height of the instrument axis 1.35 m above the ground. Calculate the slope in % between B and C if R.L. of station B = 124 m; R.L. of station C = 55 m; horizontal distance from A to B = 94 m; and horizontal distance from A to C = 137 m. Station A Bearing (0) 48 138 Note: Variables given in Question 6, 7, 8, 9 and 10 are NOT the same. Carefully check the given data for each question. To B C

The readings given below were made with a tacheometric theodolite having a multiplying constant of 100 and no additive constant. The reduced level at station A was 100.0 m and the height of the instrument axis 1.35 m above the ground. Calculate the slope in % between B and C if R.L. of station B = 124 m; R.L. of station C = 55 m; horizontal distance from A to B = 94 m; and horizontal distance from A to C = 137 m. Station A Bearing (0) 48 138 Note: Variables given in Question 6, 7, 8, 9 and 10 are NOT the same. Carefully check the given data for each question. To B C

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

In a differential leveling two points A and B were observed from an instrument set up midway between these two points. The observed rod readings on A and B were recorded to be 3.25m and 1.10m respectively. The distance between these two points is 123.45m. Assuming uniformity of slope from A to B determine the slope of AB. Select the correct response: O +1.88% +1.74% O -1.74% O -1.88% Compute the approximate area in hectares of a rectangular shaped tract of land whose sides measures 20.50mm by 31.25mm on a map drawn to a scale of 1: 8,000. Select the correct response: O3.23 has O 4.10 has. O 2.18 has. O 1.82 has. On a map of the City of Dasmarinas drawn to a scale of 1:12,000 the map distance from city hall to the town market is 28cm, in another map drawn to a scale of 1: 15,000, the map distance from the city hall to the nearest department store is 24cm, in another map drawn to scale 1;10000, the map distance from the city hall to the nearest police outpost is 15cm, and in another map…
During a tacheometric survey, a tacheometer is situated at point C and the stadia intercepts at points A and B were observed as 0.270 and 0.180 m respectively. The angle ACB was observed as 60° 30' 45". Determine the horizontal distance AB and take the stadia multiplication constant as 100 and the stadia addition constant as 0.10 m.
The surveying team used 30 m tape in measuring an inclined distance. The measured length on the slope was recorded to be 459.20m long. The difference in elevation between the initial point and the end point was found to be 1.25m. The 30 m tape is of standard length at a temperature of 10°C and a pull of 50N. During measurement the temperature reading was 15°C and tape was supported at both ends with an applied pull of 75 N. The cross-sectional area of the tape is 6.50 mm² and the modulus of elasticity is 200 GPa. The tape has a mass of 0.0075 kg/m. Determine the true horizontal distance. K=0.0000116 m/°C
The surveying team used 30 m tape in measuring an inclined distance. The measured length on the slope was recorded to be 450.00m long. The difference in elevation between the initial point and the end point was found to be 1.25m. The 30 m tape is of standard length at a temperature of 10°C and a pull of 50N. During measurement the temperature reading was 15°C and tape was supported at both ends with an applied pull of 75 N. The cross-sectional area of the tape is 6.50 mm² and the modulus of elasticity is 200 GPa. The tape has a mass of 0.075 kg/m. K=0.0000116 m/°C. Determine the combined correction (temperature, pull and sag) per tape length to be applied
Ineed answer for this please
12. Complete the benchmark-leveling field notes shown in Figure B by computing and recording the HI and elevation for each TP and benchmark. Do the arithmetic check. BS BM 10 1.567 TP 1 1.345 TP 2 1.136 TP 3 0.987 TP 4 0.876 BM 20 Sum= Sta. HI FS Elev. 200.00 3.579 2.760 2.575 2.055 1.579
A. Determine the TRUE DIFFERENCE in elevation between A and B B. Determine the ERROR in the rod reading at B with instrument still at P
In the two-peg test of a dummy level, the following observations are taken. On point A On point B INSTRUMENT SET UP at M 2.682 1.239 INSTRUMENT SET UP at P 1.876 0.565 Point M is equidistance from both A and B with 92 meters, while P is 2.50m away from A along the extension of line AB. Requirements: Determine the true difference in elevation between point A and B. With the level still set up at P, determine the rod reading on A and B to which the line of sight should be adjusted. If the instrument needs to be adjusted, determine the following false difference in elevation inclination of the line of sight and the error in the reading of far rod A and B instrument set up at P.
7. A horizontal collimation test is performed on an automatic level. With the instrument setup at point 1, the rod reading at A was 5.630 ft, and to B was 5.900 ft. After moving and leveling the instrument at point 2, the rod reading to A was determined to be 5.310 ft and to B 5.560 ft. As shown in the following figure, the distance between the points was 100 ft. What is the collimation error of the instrument, and the corrected reading to A from point 2? Rg Line of sight Horizontal 26 2 First setup RA Line of sight Horizontal A 1 Second setup 100 ft 100 ft 100 ft
Good day! I need your help in answering this activity in surveying and if possible, can you provide an illustration too? Thank you!
Q2.The vertical angle reading measured from station A to station B,C,D are as shown in the Following Table: -Instrument station Face right 274 9.45' 10" 266 ° 32' 36" 262 ° 41' 18" station Face left 85 14 10" A C 93 ° 27' 14" 97 o 18'50" If the height of the theodolite instrument on the point A=1.5m and its elevation =30m..Calculate the elevations of points B, C, &D if the horizontal distance between points B,C,D, 50m ,100m 150m.respectively. CS Scanned with CamScanner
In a two-peg test of a dumpy level, the following observations were taken. Rod Reading Instrument at c Instrument at D Station A 0.296 m 1.574 m Station B 0.910 m 2.400 m Point C is equidistant from A and B, while D is 20m from A and 130m from B. Determine: a. The difference in elevation between A and B (in meters) b. The error when the instrument is at Point C (in meters) c. The error in Station A when the instrument is at Point D (in meters)