A pure nitrogen carrier has flows parallel to the 0.6 m^2 surface of a liquid acetone in an open tank. The acetone temperature is maintained at 290 K. If the average mass transfer coefficient kc for the mass transfer of acetone into the nitrogen stream is 0.0324 m/s, determine the total  rate of acetone release in units of kg.mol/s

Q: For the carburizing process of the titanium plate, the temperature of which needs to be heated to a…

A: To determine the below conditions, we will use the error function. This is denoted by "erf". This is…

Q: A cylindrical tube connects two large gas tanks (Tank-1 and 2). Both tanks contain mixture of carbon…

A: Given: The partial pressure of the first tank, The partial pressure of the second tank, The length…

Q: A situation arises where steady state equimolar counter diffusion is occurring in a section of…

A: The molecular diffusivity of the given system for equimolar counter diffusion is to be calculated.

Q: Normal butanol (A) is diffusing through air (B) Estimate the diffusivity for the T = 20° P = 15 atm

A: Given details, Butanol(A) is diffusing through air(B) at Temperature, T=200C=20+273 =293 K…

Q: - Problem 1: The syringe shown in the figure below contains cell culture medium (p = 1.02 g/cm³). If…

A: Volumetric flow rate- a volumetric flow rate is the amount of a gas or liquid that moves over a…

Q: It is required to transport a hydrocarbon as a two-phase mixture of liquid and vapour along a…

A: It is given that a two-phase mixture of hydrocarbon is being transported in a smooth-walled…

Q: A semi-permeable, immovable membrane separates two compartments of equal volumes V . Initially NA…

A: The process can be shown as Given  The membrane is impermeable to gas B but permeable to  gas A(…

Q: In a solid-liquid extraction process operated according to the principle of continuous reverse…

A: A mixture of solids, hexane and oil is to be extracted with the help of pure hexane in a…

Q: 1. Capillary waves can form on a liquid free surface as a result of surface tension. The wave speed…

A: It is given that wave speed depends on surface tension, wavelength, and densityto find relation b/w…

Q: A gas absorption tower of diameter 2 m contains ceramic Raschig rings randomly packed to a height m.…

A:

Q: 50 l/hr of fruit juice at 290 K is fed to a falling film evaporator. The juice flows down the…

A: It is given that:volumetric flow rate of inlet fruit juice,,concentration of water in inlet,…

Q: A large tank of water containing 800 ppm salt is connected to a tank distilled water through a…

A:

Q: This question is designed to help you understand the constant mass expansion (CME) experiment for an…

A: Thank you,Please rate my response.

Q: Oxygen gas is most soluble in water under which set of conditions? A. Low temperature, low…

A: Oxygen gas is most soluble in water at high pressure and low temperature       Option C is correct

Q: Anthocyanins are being extracted from a bed of blueberries (15 cm in depth). The berries are in a…

A: Given : Depth of the bed of blueberries Length of the tray Width of the tray Velocity of the solvent…

Q: Acetone at 70°C (viscosity = 0.00042PA-s, density = 1000kg/m) is passed through a zeolite membrane…

A: In membranes, the flux is the permeate amount passed through membrane in unit time. This is…

Q: In a solid - liquid extraction process operated according to the principle of continuous reverse…

A: A mixture of solids, hexane and oil is to be extracted with the help of pure hexane in a…

Q: A cylindrical tube connects two large gas tanks (Tank-1 and 2). Both tanks contain mixture of carbon…

A: Given Data  The cylindrical tube connects two large tanks (Tank 1 and 2). The tanks contain CO2 and…

Q: 14. A bubbly mixture of gas and liquid flows up a vertical glass tube with an internal diameter of…

A:

Q: и Q.2) A gas being transfer across a stagnant air layer at a total pressure of 150 kN/m2, at one…

A: Step 1:   Step 2:Step 3: Step 4:

Q: A company producing detergents uses industrial minerals such as phosphate salts and silica in their…

A: Given: diameter of the clay particles=50 μm=5*10-6difference between the densjties(ρp-ρL)=2400…