A pump delivers 4 m3/min of water from 110 kPa to 350 kPa. Both pipes’ gages are on the same level. The inlet and the outlet pipe diameters are 16 cm and 13 cm respectively. The inlet and outlet temperature are both 25 deg C and the mass density of water is 997 kg/m3. Calculate the pump work in kW.

Q: A drum type steam generator operate at 160 bars. 1260 kg of water goes down the downcomer 7.32 °C…

A: Given data as per question Pump efficiency =0.70 considering density of steam at 160 bar in…

Q: 2. A rectangular swimming pool is 10 meter deep, 15 meters wide and 20 meters long. If the pool is…

A: Pool dimensions -Deep - 10 meterWidth - 15 meterLength = 20 meter Level of water in pool is 1 m…

Q: A centrifugal pump compresses 3 000 L/min of water from 98 kPaa to 320 kPaa. The inlet and outlet…

A:

Q: Find the kinetic energy associated with car of mass 35 kg moving with velocity 10 m/s

A: Given data:-  Mass = 35 kg Velocity = 10 m/s Find kinetic energy .

Q: Find the kinetic energy stored in car of 30 kg moving with velocity 24 m/s

A: Given data : Mass of car=m Velocity of car=V   To find : Kinetic energy

Q: Q4: Find the force when 60 kg of blood is given upward of about 0.1s, in a velocity nearly 1 m/s.

A:

Q: Steam generators are a type of heat exchanges that are used in power plants to generate steam at…

A: Answer: (i) The steam flow rate is 11.9522 kg/sec and the inlet velocity of the steam is 4.2441…

Q: Water is pumped from a lake to a large storage tank that is on the top open to the atmosphere. The…

A: The given information in the problem is listed in the following attached image:

Q: PROBLEM 1: Assume 5 Ib/sec of fluid enter a steady-state, steady flow system with p1 = 100 psia, p2…

A: Givenm˙=5lb/s=5×0.4536 kg/s=2.268 kg/sp1=100psi=100×6.895 kPa=689.476kPaρ1=0.2lb/ft3=0.2×16.0185…

Q: 3. A vertical cylinder tank 3m x 4m receives water whose density of 990 kg/m³ at a rate of 300 GPM…

A: Given:Diameter of the cylinder, d=3 mHeight of the cylinder, h=4 mDensity of water, ρ=990 kg/m3Rate…

Q: PROBLEM 1: Estimate the kilowatt pump you would need to pump 450 Liter/min of liquid water at 20°C…

A:

Q: In a reciprocating air compressor, high pressure air in the cylinder pushes the piston against the…

A:

Q: Five cubic meter of nitrogen are heated at constant volume so that the pressure changes from 276…

A: Given data, Nitrogen is working fluid V = 5 m3 Process is constant  volume  P1 = 276 kpaa P2 = 1375…

Q: The vacuum at the steam inlet to a condenser was found to be 716 mm of Hg and the temperature of…

A: The vacuum efficiency is ηvacuum = 99.7%.

Q: 4. A pump pushes 1000 m³ of liquid water at 15°C up to a reservoir at 200 m higher elevation. The…

A: 4. Given data :

Q: Q2. A Pelton wheel has diameter of 4m and the average force of water against the blades is 13.13KN.…

A:

Q: turbine receives steam at a rate of 1.26 kg/s and its shaft power is 500 kW. The casing is…

A: This question is based on the concept of the First Law of Thermodynamics.

Q: PROBLEM 1 A hydroelectric power plant has the hydraulic turbine located 60 m below the elevation of…

A:

Q: An incompressible fluid flows through a nozzle at 5 kg/s. What is the final velocity if inlet…

A: Given data: m˙=5 kg/sv1=5 m/sA2=12A1 Need to determine the final velocity of the fluid.

Q: 1. A 20lbm box is on an air balloon. The balloon has diameter of 10m with air with density of 0.04…

A: Dear student, we are suppose to solve only one question. Please post other question as a separate…

Q: PROBLEM 1: Assume 5 Ib/sec of fluid enter a steady-state, steady flow system with p1 = 100 psia, p2…

A: Mass flow rate, m˙= 5 lb/sec P1= 100 psia ρ1= 0.2 lb/ft3 v1= 100 fps u1= 800 Btu/lb P2= 20 psia ρ2=…

Q: Refrigerant 134a is stored inside an uninsulated rigid tank (see figure below) and heated by an…

A:

Q: A fan is rated to deliver 680 m3/min at a static pressure of 304 cm of water when running at 219 rpm…

A: To find the power at the changed conditions

Q: n insulated diffuser accepts 0.2 kg/s of steam at 600 kPa, 325 °C. It is able to slow the flow down…

A: Given data is

Q: Q2. A Pelton wheel has diameter of 4m and the average force of water against the blades is 13.13KN.…

A:

Q: A water pump is designed to lift 180 gallons per minute to a height of 49 feet. The pump is 90%…

A: The flow rate is The height is The efficiency of pump is

Q: Q4: Determine the maximum height increase provided by a 7.46 KW pump with a 6-cm-diameter inlet and…

A: Given data:- Power rating of pump, P=7.46 kW Diameter at inlet, d1=6 cm Velocity at inlet, V1=10…

Q: 3.)A pump delivers 4 m³/min of water from 110 kPa to 350 kPa. Both pipe's gages are on the same le…

A: Given data as per question Q=4 m3/minP1=110 kPaP2=350 kPad1=16 cm=0.16 md2=13 cm=0.13 mρ=997 kg/m3

Q: A diffuser is integrated into a system. Superheated water vapor enters the diffuser at a temperature…

A: option (b) = 1.232 m2

Q: In unloading a grain from a hold of a ship, an elevator lifts the grain through a distance of 12 m.…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.