turbine receives steam at a rate of 1.26 kg/s and its shaft power is 500 kW. The casing is adiabatic. Find the drop in specific enthalpy between the inlet and exit of the turbine. a) assuming gravitational and kinetic terms to be negligible. b) assuming that the velocities at entrance and exit are 60 m/s and 360 m/s respectively and the inlet is 3 m higher than the exhaust. Take the local gravitational acceleration to be 9.81 m/s2

Q: Q6) An oil pump is drawing (25 kW) of electric power while pumping oil with (= 860 kg/m3) at a rate…

A:

Q: At the Niagara Falls generating station, the water drops 102 m from the intake pipes at the top of…

A: Given data Height (H) = 102 m Mass flow rate (m˙) = 1000 kg/s Efficiency of the turbine (η) = 75% =…

Q: If you had a fixed mass of hot air stored in a rigid container and decided to transfer heat from the…

A:

Q: Steam with specific enthalpy of 3278kj/kg goes through nozzle at station A velocity of 20m\s. If the…

A:

Q: Q6: piston cylinder contains I kg water at 200C with a constant load on the piston such that the…

A: The initial state conditions of water are p1=250 kPa, T1=20°C, and the exit state conditions of the…

Q: Water enters a pump as saturated liquid 50 kPa at a rate of 3.0 kg/s and exits with a pressure of 10…

A:

Q: nd k = 1.26. If 20 Btu are added to 5 lb of this gas at constant volume when the initial temperature…

A: Given: R=58.8 ft-lb/lb-0R k=1.26 Q=20 Btu m=5 lb Process- constant volume process Initital…

Q: 20 g copper at 40 degree celsius is dropped into a constant volume calorimeter containing 100 g…

A:

Q: Steam enters a continuous flow turbine at a pressure of 8 MPa and a temperature of 450 ℃ and reaches…

A: Certainly! Here are the given data from the question:Given Data:Inlet conditions:Pressure at inlet…

Q: If the mass flow rate of steam is 11 kg/s in steadystate turbine, find the shaft output (W) in kW P1…

A: Given:-  Mass flow rate (m) = 11 kg/s To Find:-  Shaft Output (W)

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.