A power system consists of a synchronous generator and a synchronous motor connected via two transformers and a transmission line. Create a per-phase, per-unit equivalent circuit of this power system using a base apparent power of 100 MVA and a base line voltage of the generator G₁ of 13.8 kV. V₁ = 13.8 KV base Sbase 100 MVA G₁ Generator: • 100 MVA Zone 1 13.8 kV (0.1 + j0.9) pu T₁ YY Transformer 1: • 100 MVA ● 13.8/110 kV (0.1 + j0.05) pu Zone 2 L₁=(15+j75) Q T₂ YA Transformer 2: • 50 MVA • 120/14.4 kV Zone 3 (0.1 + j0.05) pu Load (motor): 50 MVA • 13.8 kV ● M₂Y . (0.1 +j1.1) pu

A power system consists of a synchronous generator and a synchronous motor connected via two transformers and a transmission line. Create a per-phase, per-unit equivalent circuit of this power system using a base apparent power of 100 MVA and a base line voltage of the generator G₁ of 13.8 kV. V₁ = 13.8 KV base Sbase 100 MVA G₁ Generator: • 100 MVA Zone 1 13.8 kV (0.1 + j0.9) pu T₁ YY Transformer 1: • 100 MVA ● 13.8/110 kV (0.1 + j0.05) pu Zone 2 L₁=(15+j75) Q T₂ YA Transformer 2: • 50 MVA • 120/14.4 kV Zone 3 (0.1 + j0.05) pu Load (motor): 50 MVA • 13.8 kV ● M₂Y . (0.1 +j1.1) pu

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Figure 3 shows the one-line diagram of a three-bus power system with generation at bus X. The magnitude of voltage at bus X is adjusted to 1.05 per unit. The scheduled loads at buses Y & Z are as on the diagram. Line impedances are marked in per unit on a 100 MVA base. i. Determine the bus voltages. Calculate branch current and power flow after 1 iteration for branch X-Y, X-Z and Y-Z. You must show all equations formulated and used in the calculations.
Desian aproblem for wye delta transform adions Determinc the eauivalend resistance between the terminals A andA B.
c) Calculate the phase voltages of the following zero, positive, and negative sequences of phase “a" given as follows: Vao = 20045° V Vai = 2052 – 30° V Vaz = 1534196° V
2. Determine the Ripple factor, Kr VA wt 2 2
In the following power system M ilio YA T₂ L47 YA 5 ΔΥ synchronous generators G₁,G₂ and synchronous motor M all have the same per-unit impedances Xo=0.05, X₁=X₂=0.7 The three transformers T₁, T₂, T3 are identical with X=0.1pu. Finally, the three transmission lines L47, L57, L67 are identical with per-unit impedances X₁=0.2, X₁=X₂=0.1 Pre-fault all voltages are 1 pu. Then the a phase at bus 6 faults to ground (through zero impedance). What is the magnitude of the per-unit fault current? उह 4 7 L 67 L 57 Y
For the system as shown in the following figure, convert the components to same base voltage and apparent power, by choosing 100 kVA as the base kVA and 2000 V as the base voltage for the generators. Redraw the single line diagram with the new per unit values. 15 KVA 2000 V Z=j0.3 pu 25 KVA 2000 V Z=j0.15 pu G1 G2 35 KVA 2000/8000 V Z=j0.2 pu Z=30+j100 Z=60+j120 pu O pu leee 35 KVA 8000/2000 V Z=j0.3 pu 35 kVA 2000/8000 V Z=j0.25 pu G3 10 KVA 2000V Z=j0.35 pu M 30 KVA 2000 V
a syn A: A sylienfonotus generator of 100 MVA, 22 kV, and 0.25 pu transient reactance supplies a motor of 50 MVA, 22 kV, and 0.2 pu transient reactance. The motor is drawing 40 MW at 0.8 power factor leading and terminal voltage of 21.9 kV. The line connecting them has a reactance of 0.05 pu on a base of 100 MVA. Find the transient currents in the generator, the motor, and the fault when a 3-ph fault occurs at the motor terminals. Take SB = 100 MVA, VB = 22 kV, and use the internal voltages %3D %3D of the machines method.
A three-phase alternator generating unbalanced voltages is connected to an unbalanced load through a 3-phase transmission line as shown in figure. The neutral of the alternator and the star point of the load are solidly grounded. The phase voltages of the alternator are Ea = 1020º, Eb = 102-90°, Ec = 10/120⁰ E E E The positive sequence component of the load current is (A) 1.3102-107⁰ A (B) 0.3322-120° A (C) 0.9962-120º A (D) 3.5104-81⁰ A +) + j1.002 0000 j1.002 0000 j1.0Ω vovo j1.0Ω 0000 j2.002 voor j3.002 oooo
6. A generating station has the following daily load cycle : 10–12 Time (hours) 0–6 6–10 12–16 16–20 20–24 Load (MW) 20 25 30 25 35 20 Draw the load curve and find (i) maximum demand, (ii) units generated per day, (i) average load, (tv) load factor, II
Suppose you have a three-phase generator that provides 120 Vac per phase and works at a frequency of 60 Hz, this generator can be connected in both delta and star. Also consider the following 6 load impedances, which will be connected at the same time to the generator as follows: ZA, ZB and Zc are connected in star, while Zp, Zg and Zp are connected in delta. j20 j3n Za j20 ZA j30 j3n -j20 j 30 -j20 Zo -j20 ZE j30 -j2n j 3n. ZF Assume the generator is star-connected with neutral, calculate total system power, total power factor, and current in neutral.
5. A generating station has the following daily load cycle: Time in 0 to 6 6 to 10 10 to 12 to 16 to 20 to Hours 12 16 20 24 Load 50 60 70 60 80 50 (MW) Draw the load curve and Estimate: i. Maximum Load ii. Units generated per day iii. Average Load iv. Load Factor