If the load draws a current of 2727 A, in phase, from a generator, which of the following statement is true? O A. The reactive power is flowing from generator to the load and the real power is flowing from the load to the generator. O B. Since the current is in phase with the generator voltage, both the real and reactive power is flowing from the generator to the load. O .Since the current is leading the generator, both the real and reactive power is flowing from the load to the generator. O D. The real power is flowing from generator to the load and the reactive power is flowing from the load to the generator. O E. None of the other choices are correct

If the load draws a current of 2727 A, in phase, from a generator, which of the following statement is true? O A. The reactive power is flowing from generator to the load and the real power is flowing from the load to the generator. O B. Since the current is in phase with the generator voltage, both the real and reactive power is flowing from the generator to the load. O .Since the current is leading the generator, both the real and reactive power is flowing from the load to the generator. O D. The real power is flowing from generator to the load and the reactive power is flowing from the load to the generator. O E. None of the other choices are correct

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Related questions

Q: Which of the following is more likely to cause problems with motors? a) positive sequence harmonics,…

A: Which of the following is more likely to cause problems with motors? Negative sequence harmonics,…

Q: please help how to know if they are given terminal voltage or phase voltate. what is the difference…

A: a) 1200 rpm, 125.66 rad/sb) Ea= 12.113 kV, Efficiency n= 90.78%c) 10kV since connected to infinite…

Q: 4.1Two synchronous generators need to be connected in parallel to supply a load of 10 MW. The first…

A: The solution is given below

Q: A 80 MVA synchronous generator has Xs = j8Ω. The generator is supplying its rated power to an…

A: Given synchronous generator :80 MVA Xs = j8 Ω. bus voltage :33KV and power factor : 0.9

Q: A 50 Hz three-phase Y-connected 4 pole synchronous generator is rated at 15 kVA, 400 V…

Q: A synchronous generator has 4 poles and a synchronous reactance of 5 ohms. The operating frequency…

A: Given Data:A star-connected synchronous generator with,Number of poles Synchronous reactance…

Q: In a system, there are two generators operating in parallel. One generator, of rating 250 MVA, has…

A: Given data:Required information:

Q: Three identical steam-turbine generators G1, G2, and G3 are operating in parallel. Each generator…

A: Given data,Each generator rating-7.2KV, 21 MVA, 50Hz, 0.85 PF lagging, 4-Poles,…

Q: Three identical steam-turbine generators G1, G2, and G3z are operating in parallel. Each generator…

A: Given Three generators are in parallel Power frequency slope are SP1=4.2 MW/HzSP2=4.5 MW/HzSp3=4.4…

Q: A common base of 100 MVA and 25 KV is selected. What is the current base (Ig) Select one: O a. 4 KA…

A: To find the current base (IB)

Question

If the load draws a current of 2727 A, in phase, from a generator, which of the following statement is true?
O A. The reactive power is flowing from generator to the load and the real power is flowing from the load to the generator.
O B. Since the current is in phase with the generator voltage, both the real and reactive power is flowing from the generator to the load.
O .Since the current is leading the generator, both the real and reactive power is flowing from the load to the generator.
O D. The real power is flowing from generator to the load and the reactive power is flowing from the load to the generator.
O E. None of the other choices are correct

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Multiple Order System and Steady State Error

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A generator at no-load operates 61 Hz, slope 1MW/Hz. Load 1= 1.0 MW and load 2=0.8MW are connected. Find the frequency before and after adding the load 2. (Using House Diagram)A. 60 Hz & 59 Hz C. 60 Hz & 59.2 HzB. 60 Hz & 59.1 Hz D. 60 Hz & 59.3 Hz
please help how to know if they are given terminal voltage or phase voltate. what is the difference between both and the answer would change?
b) Two synchronous generators, G2 and G2, are connected parallelly supplying a load. Generator G1 has a no-load frequency of 50.5 Hz and a slope of 300 MW/Hz. Generator G2 has a no-load frequency of 50.2 Hz and a slope of 500 MW/Hz. The load consumes 250 MW real power. (1) At what frequency does this system operate, and how much power is supplied by each of the two generators? (ii) An additional 100 MW load is added to this power system. What is the new system frequency, and how much power do G1 and G2 supply? (iii) The governor set point of G2 is changed to control system frequency back to 50 Hz. Determine the G2 governor set point.
A synchronous generator runs at 250 rpm and generates at 50-Hz. There are 216 slots, each containing 5 conductors arranged in a full-pitched winding for 3-phase star connection. All the conductors of each phase are in series and the flux per pole at no-load sinusoidally distributed over the pole pitch is 30 mWb. Find the emf induced in each phase winding and the terminal voltage.
A power station consists of two synchronous generators A & B of ratings 250 MVA and 500MVA with inertia 1.6 pu and 1.0 pu respectively on their own base MVA ratings. The equivalent pu inertia constant for the system on 100 MVA common base is:- (a) 2.6 (b) 0.615 (c) 1.625 (d) 9.0
D2. When a generator's full-load output voltage is the same as its no-load output voltage it is said to be a) under-compounded b) flat-compounded c) over-compounded d) none of the above D3. The output of an overcompounded DC generator can be lowered by use of a a) rheostat connected in series with the series field b) rheostat connected in parallel with the series field c) rheostat connected in parallel with the shunt field d) none of the above D4. When might it be desirable to use an overcompounded generator? a) never b) always c) to compensate for line loss d) when you need a higher no-load voltage than your full-load voltage
Two shunt generators are connected in parallel to supply a 30KW load. Generator A has a no-load voltage of 420V and a voltage of 380V when the load is 75A while Generator B has a no-load voltage of 460V and a voltage of 400V at a load of 60A. Determine the common operating voltage and the power supplied by each generator.
While the instantaneous electric power delivered by a single-phase generator under balanced steady-state conditions is a function of time havi ng two components of a constant and a double-frequency sinusoid, the total instantaneous electric power delivered by a three-phase generator under balanced steady-state conditions is a constant. (a) True (b) False
2A. What is another term for "shunt"? a) in series b) in parallel c) compounded d) none of the above 2B. Which of the following is/are a basic type of DC generator connection? a) series b) shunt c) compound d) all of the above
4.1Two synchronous generators need to be connected in parallel to supply a load of 10 MW. The first generator supplies three times the amount of the second generator. If the load is supplied at 50 Hz and both generators have a power drooping slope of 1.25 MW per Hz.a. Determine the set-point frequency of the first generator b. Determine the set-point frequency of the second ge
Which of the following is more likely to cause problems with motors? a) positive sequence harmonics, b) negative sequence harmonics, c) either a or b, d) neither a nor b in a inductive circuit, does the inductance have any effect on the flow of steady current? a) yes , b) no The rotating part of the revolving-field design alternator is called the rotor. a)true, b) false
Three identical steam-turbine generators G1, G2, and G3 are operating in parallel. Each generator is: 7.2 KV, 21 MVA, 50 Hz, 0.85 PF lagging, 4-poles, Y-connected, with synchronous reactance of 2 Q and an armature resistance of 0.05 Q. Each of generators G1 , G2, and G3 has a characteristic power-frequency slope of 5.2 MW/Hz , 4.5 MW/Hz, and 4.9 MW/Hz, respectively The no-load frequency of each generator is set to 52.4 Hz. The load increases with no changes in the settings of the no-load frequencies, until a generator reaches its maximum rated power first. At what system frequency does this limit occur? Select one: O a. fsys = 48.97 Hz O b. fsys = 48.25 Hz c. fsys = 49.22 Hz O d. None