A power station comprises two synchronous generators with 200 MW and 400 MW putput power capacity. The two generators operate in parallel and are connected to the grid network. Both generators have governor droop characteristics of 3% (no-load to full-load percentage speed drop). Assume a free governor action. a) If the supply frequency, determined by the grid, is 1.005 pu., calculate the total power supplied by the power station. b) The 400 MW machine is more efficient than the 200 MW machine. For the same total power as determined in part (a), calculate the percentage adjustment in the no-load speed to be made by the speeder motor on the two machines if the 400 MW machine is to operate at its full capacity while the 200 MW machine supplies the difference. Assume that the frequency of the grid supply to remain as in part (a).

A power station comprises two synchronous generators with 200 MW and 400 MW putput power capacity. The two generators operate in parallel and are connected to the grid network. Both generators have governor droop characteristics of 3% (no-load to full-load percentage speed drop). Assume a free governor action. a) If the supply frequency, determined by the grid, is 1.005 pu., calculate the total power supplied by the power station. b) The 400 MW machine is more efficient than the 200 MW machine. For the same total power as determined in part (a), calculate the percentage adjustment in the no-load speed to be made by the speeder motor on the two machines if the 400 MW machine is to operate at its full capacity while the 200 MW machine supplies the difference. Assume that the frequency of the grid supply to remain as in part (a).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A 100KVA, 6.6 kV 3 PHASE star connected cylindrical pole synchronous generator has 20-ohm as synchronous reactance and the armature resistance is negligible and the generator is working at the full load and unity power factor then find the value of the induced emf voltage(line to line). Answer fast
Four similar synchronous generators are sharing equally the feed to a load of 1 pu referred to the base value of the the synchronous generator, hence,. a) The per unit output of each generator is 0.25 b) The power factor of each generator is 0.25 c) The available info is insufficient to calculate the per unit impedance of the load d) None of these
A 10-kVA, 230-V, three-phase, delta-connected, the synchronous generator has a winding resistance of 0.2 ohms/phase and a synchronous reactance of 0.5 ohms/phase. Determine its voltage regulation when the power factor of the load is (a) 86.6% lagging, (b) 86.6% leading, and (c) unity.
A 600 KVA generator with X"a = 0.22 per unit is connected to a bus through a circuit breaker, as shown in the following figure. Connected through circuit breakers to the same bus are three synchronous motors rated 200 KVA, 2.5 KV, 1.0 power factor, with X"a = 0.15 per unit. The motors are operating at full load, unity power factor and rated voltage, with the load equally divided among the machines. (a) Find the rated symmetrical short-circuit current in Amperes, which must be interrupting breakers A and B for a fault at point P. Simplify the calculations by neglecting the Prefault current. M. GHA B
1) A 50 Hz, 3.75 MVA, 3.18 kV, three-phase synchronous generator with rated (nominal) currentof In = 682 A has open- and short-circuit characteristic listed in Table 1 and Table 2 respectively.Determine saturated and unsaturated synchronous reactance in per-unit and in Ohms and calulateshort circuit ratio (SCR). The generator is delivering rated power at 0.95 power factor leading atthe rated therminal voltage. Using given open-circuit characteristic approximately determine thefield current under rated loading.
Please answer all subparts....
Q.7 Symmetrical Fault Analysis A 50 Hz, 4 pole,400 MVA, 33 KV, alternator is delivering rated MVA at 0.8 power factor. Suddenly a fault occurs reducing in electric power output by 50% .Find the accelerating torque (in MN-m) in the alternator at the time of fault? Neglect losses and assume constant power input to the shaft.
Energy Question-1) Three identical synchronous generators were connected in parallel and the idle frequency values of each generator were set to 54 Hz. The frequency - power characteristic slopes of the first and second generators are 5.3 MW/Hz and the slope of the third generator is 3.9 MW/Hz. When these three identical synchronous generators feed a load together, the system frequency becomes f=51.7 Hz. According to this;a-) Calculate the active power value that the first generator will provide to the load.b-) Find the active power that the second generator will provide to the load.c-) Find the active power that the third generator will provide to the load.d-) Calculate the power of the load.(All values in options a, b, c, and d in this Question will be entered as two digits after the comma.) NOTE: If the information in the text and the photo is different, please solve the question using the information given in the photo. Help me please... Thank you so much.
Two Generators rated 200 MW and 400 MW are operating in parallel. The droop characteristics of their governor are 4 % and 5% respectively fro no load to full load. The speed changers are so set the governor operate at 50 Hz sharing the full load of 600 MW, in the ratio of their ratings. If the load reduces to 400 MW, how will it be shared among the generators and what will the system frequency be? Assume free governor system. The speed changers of the governors are reset so that the load of 400 MW is shared among the generators at 50 Hz in the ratio of their ratings. What are the no-load frequencies of the generators ?
Three (533 KW, 483, KW, 583 KW) 480 V diesel -driven 60 Hz synchronous generator, A, B and C are in parallel. and taking shares of a 183 KW, 283 KW,333 KW and the speed regulation of the three machines are 2.5% , 2%, and 2.7% respectively. System frequency is 60HZ. If a three phase 400KW resistance load and three phase induction motor draw 533 KVA at .8 pf added to the bus Determine a) The system real power b) The system frequency c) Real power carried by each machine GSR(speed regulation) GSR xf rated A f rated A P
Electrical machines
Please i want the answer son as possible