A power line carrying a sinusoidally varying current with frequency f-60Hz and peak value /0=55kAruns at a height of 7.0 m across a farmer's land (see the figure). The farmer constructs a verticallyoriented 2.0-m-high 13-turn rectangular wire coil below the power line. The farmer hopes to use theinduced voltage in this coil to power 110-Volt electrical equipment, which requires a sinusoidallyvarying voltage with frequency f= 60Hz and peak value VO = 160V What should the length / of thecoil be?Io = 55 KAf = 60 HzCoil7.0 m2.0 m

Given: Frequency is 60 Hz Peak value is 55 kA Height is 7 m Height of rectangular wire is 2 m number…

Answered: A power line carrying a sinusoidally…

Similar questions

a.) A conducting rod slides at a speed of 7.50 m/s along metal rails through a mag-netic field of 0.800 T, as shown. Find the emf induced in the rod. b) How strong is the force needed to keep the rod moving at the given speed, if the resis-tance of the circuit is a constant 1.50 Ω? The spacing between the rails is 0.500m
A coil with 115 loops and area 0.0120 m^2 rotates at 60.0 Hz through a B field of 0.125 T. What is the maximum EMF generated? (Hint: The angular frequency is NOT 60.0 Hz.) (Unit = V) EMF (V)
Problem 18: Part (a) At what frequency, ω, in revolutions per minute, must the coil be spun? ω = ______ rpm
A physics student observes that the current in a coil of conducting wire goes from i, = 0.200 A to i, = 1.50 A in a time interval of At = 0.350 s. Assuming the coil's inductance is L = 5.00 mH, what is the magnitude of the average induced emf (in mV) in the coil for this time interval?
A generator uses a coil that has 370 turns and a 0.49-T magnetic field. The frequency of this generator is 60.0 Hz, and its emf has an rms value of 120 V. Assuming that each turn of the coil is a square (an approximation), determine the length of the wire from which the coil is made. B N Number Units S
In a model AC generator, a 501 turn rectangular coil 8.0 cm by 24 cm rotates at 120 rev/min in a uniform magnetic field of 0.61 T. (a) What is the maximum emf induced in the coil? V (b) What is the instantaneous value of the emf in the coil at t = (π/32) s? Assume that the emf is zero at t = 0. V (c) What is the smallest value of t for which the emf will have its maximum value? S
The maximum value of the emf in the primary coil (Np = 1500) of a transformer is 195 V. (a) What is the maximum induced emf in the secondary coil (Ns = 350)? V (b) What is the ratio of the current in the primary coil to the current in the secondary coil? Ip Is =
An ac electrical generator is made by turning a flat coil in a uniform constant magnetic field of 0.225 T. The coil consists of 33 square windings and each winding is 40.0 cm on each side. It rotates at a steady rate of 745 rpm about an axis perpendicular to the magnetic field passing through the middle of the coil and parallel to two of its opposite sides. An 8.50-2 light bulb is connected across the generator. 1) Find the voltage amplitude for the light bulb. (Express your answer to two significant figures.) V Submit 2) Find the current amplitude for the light bulb. (Express your answer to two significant figures.) A Submit 3) At what average rate is heat generated in the light bulb? (Express your answer to two significant figures.) W Submit 4) How much energy is consumed by the light bulb every hour? (Express your answer to two significant figures.) kJ Submit
17. The magnetic flux through three different coils is changing as shown in Figure P21.17. For each situation, draw a corresponding graph showing quantitatively how the induced emf changes with time. FIGURE P21.17 $(T•m²) 0.4 0.2 0 0 2 4 (T • mỏ) 0.4 0 01234 p(T•mỏ) +0.2 A 1 2 3 t(s) -0.2 -t (s)