A generator uses a coil that has 110 turns and a 0.31-T magnetic field. The frequency of this generator is 60.0 Hz, and its emf has an rms value of 120 V. Assuming that each turn of the coil is a square (an approximation), determine the length of the wire from which the coil is made. Number i N Units B S

A generator uses a coil that has 110 turns and a 0.31-T magnetic field. The frequency of this generator is 60.0 Hz, and its emf has an rms value of 120 V. Assuming that each turn of the coil is a square (an approximation), determine the length of the wire from which the coil is made. Number i N Units B S

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A 227-turn circular coil of radius 24 cm is perpendicular to a uniform magnetic field of 0.55 T. During a 0.75 s time interval, this field increases to 1.7 T. If the resistance of the coil is 11.5 ohm, calculate the average emf and current that flows in the coil during this interval. The average emf, Emf = 47.23 V Units V The average current, i = 5.5 x Units A
The figure below displays a circular loop of conducting wire in a uniform magnetic field pointing into the page. The radius of the loop is 10.0 cm and the magnitude of the field is 0.160 T. You grab points A and B and pull them in opposite directions, stretching the loop until its area is nearly zero, taking a time of 0.170 s to do so. What is the magnitude of the average induced emf in the loop (in mV) during this time? * х * X x х A x * * x K mV X x * x. B * * *
A 500 turn coil with a 0.250 m² area is spun in the Earth's 5.00 × 10-³ T magnetic field, producing a 12.0 kV maximum emf. At what frequency, f, in rpm, must the coil be spun?
B4
Give your answer in SI units and to three significant figures. D Question 1 Two lenses are placed a distance of 20.0 cm apart. The leftmost lens is a converging lens with a focal length of 6 cm while the seconds lens is a diverging lends with a focal length of 10. If an object is placed 2 cm to the left of the converging lens, determine the magnification of the two lenses combined.
c. What is the resistance of the coil given that the diameter of the wire is 2.00 mm? (Recall, resistance of wire is given by R = ρL/A, where ρ is the resistivity of the metal, L is the length of the wire, and A is the cross-sectional area.)
A generator uses a coil that has 370 turns and a 0.49-T magnetic field. The frequency of this generator is 60.0 Hz, and its emf has an rms value of 120 V. Assuming that each turn of the coil is a square (an approximation), determine the length of the wire from which the coil is made. B N Number Units S
The Roman cubitus is an ancient unit of measure equivalent to about 0.445 m. Convert the 2.09-m height of a basketball forward to cubiti.
Two coils are placed close together in a physics lab to demonstrate Faraday's law of induction. A current of 8.00 A in one is switched off in 2.00 ms, inducing a 3.00 V emf in the other. What is their mutual inductance (in mH)? mH Additional Materials Reading
A coil with 35 turns sits in a magnetic field. The cross-sectional area of the coil is 5.1 cm2. If the magnetic field uniformly reduces from 1.0×101 T to 1.5 T in 6.5 seconds, what is the magnitude of the induced emf in that coil?
An electric generator contains a coil of 110 turns of wire, each forming a rectangular loop 39.3 cm by 43.0 cm. The coil is placed entirely in a uniform magnetic field with magnitude B = 5.03 T and initially perpendicular to the coil's plane. What is in volts the maximum value of the emf produced when the loop is spun at 1300 rev/min about an axis perpendicular to the magnetic field? Number i Units