An AC generator consists of a 20.0-cm by 10.0-cm rectangular conducting frame with 300 turns rotating in a uniform magnetic field of strength 6.0 T that is produced by the pole faces of a magnet. (See the diagram below.) What is the maximum voltage generated in the conducting frame if the frame rotates at 60 Hz? Magnetic Poles Magnetic Flux N Slip-rings Wire Loop (the conductor) Carbon Axic Brushes

An AC generator consists of a 20.0-cm by 10.0-cm rectangular conducting frame with 300 turns rotating in a uniform magnetic field of strength 6.0 T that is produced by the pole faces of a magnet. (See the diagram below.) What is the maximum voltage generated in the conducting frame if the frame rotates at 60 Hz? Magnetic Poles Magnetic Flux N Slip-rings Wire Loop (the conductor) Carbon Axic Brushes

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter11: Magnetic Forces And Fields

Section: Chapter Questions

Problem 98AP: Unreasonable results To construct a non-mechanical water meter, a 0.500-T magnetic field is placed...

See similar textbooks

Related questions

Q: The coil in a 60-Hz ac generator has an area of 3.0 x 10^-2m^2 and is rotated in a 0.12 T magnetic…

Q: QUESTION 6 Figure 3 shows a conducting bar PQ that can slide freely over two conducting rails. The…

Q: An AC generator has 80 rectangular loops on its armature. Each loop is 15 cm long and 9 cm wide. The…

A: The expression for the maximum output voltage,

Q: A 30-turns coil has a diameter of 14 cm. The coil is placed in spatially uniform magnetic field of…

A: Given that,Number of turns (N) = 30Diameter ofcoil (D) = 0.14 (m)Magnitude of magnetic field (B) =…

Q: The accompanying figure shows a conducting ring at various positions as it moves through a magnetic…

A: When a conducting loop goes through some magnetic field, the emf induced in the loop is proportional…

Q: A simple AC generator consists of 20 coils of wire with an area of 1000 cm² and placed in a region…

Q: The 1200-turns coil in a dc motor has an area of 1.5 ×10–2 m2. The design for the motor specifies…

A: number of turns in coil , N = 1200 turns Area A = 1.5 * 10-2 m2 Maximum Torque τ = 7.2 Nm…

Q: What happens to the generator's output voltage if you increase the rotational frequency of the…

A: The output of the generator voltage is determined by the following formula, that is, ε = NBAω Here N…

Q: In the figure below, a uniform magnetic field decreases at a constant rate dB/dt = –K, where K is a…

A: (a) The charge on the capacitor, when it is fully charged. As the magnetic field is directed into…

Q: A rectangular coil with sides 0.120 m by 0.210 m has 495 turns of wire. It is rotated about its long…

Q: An inductor used in a de power supply has an inductance of 12.0 H and a resistance of 180 ohms. It…

A: Here inductance = L = 12.0 H resistance = R =180 ohms. current = I = 0.50 A. We have to calculate…

Q: Which of the following statements is TRUE when the magnet is dropped inside the solenoid? A. The…

A: When the magnet is dropped inside a solenoid, magnetic flux increases through the solenoid. It keeps…

Q: A coil of 100 turns is in the rectangular shape having two sides of 10.0 cm and 40.0 cm. The coil…

A: Given Length L = 40.0 cm = 40.0 x 10-2 m Breadth b = 10.0 cm = 10.0 x 10-2 m Number of turns N = 100…

Q: A 460-loop circular armature coil with a diameter of 7.0 cm rotates at 170 rev/s in a uniform…

A: The equation for the rms output voltage of an electric generator is given by

Q: An air-cored solenoid with length 30 cm, area of cross-section 25 cm2 and number of turns 500,…

Q: A metal wire of linear mass density of 9.8/gm is stretched with a tension of 10kg wt between two…

A: Option

Q: uniform magnetic field is applied paralle to the axis of a 60-turn circular coil with a radius of…

A: Given,Number of turns of the coil = 60The radius of the coil = 6 cm = 6×10-2 mThe final magnetic…

Q: A voltage generated by moving a magnet in a coil of wire is called "induced voltage." True False

A: Required : True or False.

Q: coil of wire containing 800 circular loops with cross section of 60 cm2 is placed between the poles…

A: Given Number of circular loop is N=800 Area of cross section is A=60×10-4 m2 Rate of magnetic field…

Q: A generator has a 460-turn coil that is 10 cm long and 12 cm wide. The coil rotates at 9.0 rotations…

Q: A magnet which generates 600 Maxwells of flux, is inserted through a coil of 1000 turns. It is then…

A: Given that,Flux generated by magnet, ϕ=600 maxwells=600×10-8 weberNumber of turns in coil,…

Q: 1-Which of the following sensors has a permanent magnet inside? Hall effect sensor thru-beam…

A: Solution: The following is the sensor that has a permanent magnet inside is discussed below:

Q: he transformer on a utility pole steps the voltage down from 10000 V to 220 V for use in a college…

Q: A simple AC generator consists of 20 coils of wire with an area of 1 000 cm2 and placed in a region…

A: Given N =20 Area A = 1000 cm2 = 0.1 m2 Magnetic field B = 0.5 T EMF E = 220 V We have to find out…

Q: An MRI technician moves his hand from a region of very low magnetic field strength into an MRI…

Question

An AC generator consists of a 20.0-cm by 10.0-cm rectangular conducting frame with 300 turns rotating in a uniform magnetic field of strength 6.0 T that is produced by the
pole faces of a magnet. (See the diagram below.) What is the maximum voltage generated in the conducting frame if the frame rotates at 60 Hz?
Magnetic Poles
Magnetic Flux
N
Slip-rings
Wire Loop
(the conductor)
Carbon
Brushes
Axis of
Rotation
O a. 7.60 kvolts
O b.9.60 kvolts
O c. 11.6 kvolts
O d. 13.6 kvolts
O e. 15.6 kvolts

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: State given data

VIEW

Step 2: Calculate the maximum voltage generated

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

(a) What is the speed of a supersonic aircraft with a 17.0-m wingspan, if it experiences a 1.60V Hall voltage between its wing lips when in level flight over the north magnetic pole, where the Earth's field strength is 8.00105T ? (b) Explain why very little current flows as a result of this Hall voltage.
A rectangular copper loop of mass 100 g and resistance 0.2 is in a region of uniform magnetic field that is perpendicular to the area enclosed by the ring and horizontal to Earth's surface (see below). The loop is let go from rest what it is at the edge of the nonzero magnetic field region. (a) Find an expression for the speed when the loop just exits the region of uniform magnetic field. (b) If it was let go at t = 0, what is the tune when it exits the region of magnetic field for the following values, a=25cm,b=50cm,B=3T,g=9.8m/s2 ?Assumethat the magnetic field of the induced current is negligible compared to 3 T.
A conducting sheet lies in a plane perpendicular to a magnetic field B that is below the sheet. If B oscillates at a high frequency and the conductor is made of a material of low resistivity, the region above the sheet is effectively shielded from B . Explain why. Will the conductor shield this region from static magnetic fields?
The square armature coil of an alternating current generator has 200 turns and is 20.0 cm on side. When it rotates at 3600 rpm, its peak output voltage is 120 V. (a) Wliat is the frequency' of the output voltage? (b) What is the strength of the magnetic field in which the coil is turning?
The current through a circular wire loop of radius 10 cm is 5.0 A. (a) Calculate themagnetic dipole moment of the loop. (b) What is the torque on the loop if it is in a uniform 0.20-T magnetic field such that p and B are directed at 300 to each other? (C) For this position, what is the potential energy of the dipole?
A circular loop of wire of radius 10 cm. is mounted on a vertical shaft and rotated at a frequency of 5 cycles per second in a region of uniform magnetic field of 2104T perpendicular to the arcs of rotation, (a) Find an Expression for the time-dependent flux through the ring (b) Determine die time-dependent current through the ring if it has a resistance of 10.
What is the value of the magnetic flux through the coil in Figure 23.56 (b) due to the wire?
A coil of area 0.100 m2 is rotating at 60.0 rev/s with the axis of rotation perpendicular to a 0.200-T magnetic field. (a) If the coil has 1 000 turns, what is the maximum emf generated in it? (b) What is the orientation of the coil with respect to the magnetic field when the maximum induced voltage occurs?
Unreasonable results To construct a non-mechanical water meter, a 0.500-T magnetic field is placed across the supply water pipe to a home and the Hall voltage is recorded, (a) Find the flow rate through a 3.00-cm-diameter pipe if the Hall voltage is 60.0 mV. (b) What would the Hail voltage be for the same flow rate through a 10,0-cm- diameter pipe with tire same field applied?
Is the direction of the magnetic field shown in Figure 24.6 (a) consistent with the right—hand rule for current (RHR-2) in the direction shown in the figure?
Shown below is a conducting rod that slides along metal rails. The apparatus is in a uniform magnetic field of strength 0.25 T, which is directly into the page. The rod is pulled to the right at a constant speed of 5.0 m/s by a force . The only significant resistance in the circuit comes from the 2.0resistor shown. (a) What is the emf induced in the circuit? (b) What is the induced current? Does it circulate clockwise or counter clockwise? (c) What is the magnitude of(d) What are the power output of and the power dissipated in the resistor?
A circular coil with 200 turns Las a radius of 2.0 cm. (a) What current through tire coil results in a magnetic dipole moment of 3.0 Am2? (b) What is the maximum torque that the coil will experience in a uniform field of strength 5.0102 ? (c) If tire angle between and B is 45°, what is the magnitude of tire torque on the coil? (d) What is the magnetic potential energy of coil for this orientation?