A piston with a diameter of 15 cm was placed in a cylinder connected to a 1.27 cm inclined tube manometer asshown in the figure. Inside of cylinder and manometer unit weight 9270 N / m3is filled with an oil. When the weight W is placed on the upper part of the cylinder, the liquid height in themanometer rises from (1) to (2). PistonFind the W weight ignoring the change in position15cmPistonOIL30°

Given data Diameter Unit weight Angle Inclined height To find Weight

A piston with a diameter of 15 cm was placed in a cylinder connected to a 1.27 cm inclined tube manom shown in the figure. Inside of cylinder and manometer unit weight 9270 N / m3 s filled with an oil. When the weight W is placed on the upper part of the cylinder, the liquid height in tl nanometer rises from (1) to (2). Piston Find the W weight ignoring the change in position 15cm Piston OIL 300

A piston with a diameter of 15 cm was placed in a cylinder connected to a 1.27 cm inclined tube manom shown in the figure. Inside of cylinder and manometer unit weight 9270 N / m3 s filled with an oil. When the weight W is placed on the upper part of the cylinder, the liquid height in tl nanometer rises from (1) to (2). Piston Find the W weight ignoring the change in position 15cm Piston OIL 300

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

... EX, 7 The device shown in the figure is known as a venturi. In this specific venturi, the differential pressure between locations 1 and 2 is 30 kpa and the diameter ratio is D2/D1 = 0.35. If D2 = 16 cm, find the air flow rate through the frictionless venturi. 12 THR (2) (1)
I need the answer as soon as possible
Solve it correctly please. I will rate accordingly
Read the question carefully and give me right solution according to the question.
3. Figure 3 shows a manometer being used to indicate the difference in pressure between two points in a pipe. Calculate (PA - PB). Oil (sg = 0.90) 0.91 m 0.61 m 1.83 m Water Figure 3 : Manometer
Solve
8. A block of ice float in the sea as shown in the -3 figure below. The density of sea is 1.2 gr cm¯ and density of ice is 0.9 gr c-3. The volume of x ice in sea water = ....... X the volume of ice in the air. Density of sea (Psea) = 1.2 gr -3 cm Gunung es
4
Q2) Figure Q2 shows a 30-kg block is connected to block B through a frictionless pulley. The coefficient of static friction for the contact surfaces is 0.35. (i) (ii) Determine the mass value of block B when the impending motion of block A is down the plane. Determine the mass value of block B when the impending motion of block A is up the plane. 20⁰ А μs=0.35 Figure Q2 B
The closed cylinder shown is filled with water to a depth of 100mm and rest with air. What is the pressure at the bottom of the periphery of the tank? 0.02 0.10 AIR 0.20
I need the answer as soon as possible
The distance Ah is the height of the liquid in the manomoter above the heavier liquid in the tank. D 10 cm Water Ah = ? B C 20 cm S= 3.0