A physics experiment is set up using two pulleys, a string, and a weight as shown below. The larger pulley has a radius of14 centimeters, and the smaller pulley has a radius of 8 centimeters. The distance between the centers of the pulleys is 56centimeters. The string is pulled tightly across both pulleys so that F is a common tangent of the pulleys. Find the lengthof string from A to B to the nearest tenth of a centimeter.AweightO 56.0 cmO 22.0 cmO 55.7 cmO 58.5 cm

Given: The radius of the larger pulley is R = 14 cm The radius of the smaller pulley is r = 8 cm The…

Answered: A physics experiment is set up using…

Similar questions

The spur gear is subjected to the two forces caused by contact with other gears. Determine the resultant of the two forces and express the result as a Cartesian vector. F₂=180 lb 60° 24 135⁰ 25 F₁ = 50 lb
To study torque experimentally, you apply a force to a beam. One end of the beam is attached to a pivot that allows the beam to rotate freely. The pivot is taken as the origin or your coordinate system. You apply a force of F = Fx i + Fy j + Fz k at a point r = rx i + ry j + rz k on the beam. 1. Enter a vector expression for the resulting torque, in terms of the unit vectors i, j, k and the components of F and r. 2. Calculate the magnitude of the torque, in newton meters, when the components of the position and force vectors have the values rx = 3.03 m, ry = 0.035 m, rz = 0.085 m, Fx = 2.8 N, Fy = 4.8 N, Fz = 5.8 N. 3. If the moment of inertia of the beam with respect to the pivot is I = 71 kg˙m2, calculate the magnitude of the angular acceleration of the beam about the pivot, in radians per second squared.
A block of mass 2 kg slides down an inclined plane at an angle of 45° with a massless tether attached to a pulley with mass 3 kg and radius 0.7 m at the top of the incline (see the following figure). The pulley can be approximated as a disk. The coefficient of kinetic friction on the plane is 0.2. What is the acceleration of the block (in m/s²)? (Enter the magnitude.) 3.59 45° x m/s²
A cube with the dimensions bXbXb with mass m lies on the flat horizontal ground. One the side shown in the figure. The thickness normal to the plane of the figure is b. The cube is subject to the earth's gravity and the friction coefficient between the cube abd the ground is mu. Express your answer in terms of the given variables. What is the minimum force required to produce sliding? What is the minumum force required to produce tipping of the cube? Assume the cube is rotating about O. Impulsive horizontal loading L is applied on the edge B such that force F(t) is applied during the very short time delta t: where L= the integral from zero to delta t of F(t)dt. What is the minimum value of the impulse for which the cube tips over and falls on side OA.
Do Chapter 12, Problem 6, with these numbers which I've decided to express in pounds and feet, English units. Sam and Joe carry a beam, walking to the right. Calculate the force that Sam exerts, in pounds. The beam's weight is 109 lb. The beam's length is 21 ft. Sam is 1 ft from the back. Joe is 2 ft from the front.
Please asap
A cat rides a bike 1km. The wheels of the bike have a radius equal to 10cm. What is the total angle the tires rotate through during the cats ride?