A Nd:YVO, laser operating in a pulsed mode at 1.06 µm is placed in a cavity with mirrors of 95% reflectivity at each end of the laser. The scattering losses are determined to be 0.4% per pass. If the laser produces output pulses of 200-µs duration in a beam of diameter 6 mm and if the small-signal gain is measured to be 20% per pass, what would be the energy of the pulses emerging from the laser?

A Nd:YVO, laser operating in a pulsed mode at 1.06 µm is placed in a cavity with mirrors of 95% reflectivity at each end of the laser. The scattering losses are determined to be 0.4% per pass. If the laser produces output pulses of 200-µs duration in a beam of diameter 6 mm and if the small-signal gain is measured to be 20% per pass, what would be the energy of the pulses emerging from the laser?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

3) A GaAs semiconductor is doped n-type ND-3x10¹6 cm ³. Within the band gap of the material are 8x10¹5 cm ³ donor defects located energetically below the Fermi level such that only 75% of those defects are populated with carriers. 3a. Are the minority carriers electrons or holes for this material? 3b. What is the total free carrier concentration of this GaAs material? 3c. Where is the Fermi Level for this material relative to the conduction band? 3d. Where is the donor defect trap located relative to the conduction band? 3e. What wavelength of light would be needed to excite trapped charge from the above mentioned defect site to the conduction band?
What do you mean by EMI shielding? What is the requirement for EMI shielding. Discuss the use of polymeric materials for radiation shielding.
Calculate the maximum velocity of the beam of elec- trons in a CRT having a cathode anode voltage of 1000V. Assume that the electrons to leave the cathode with zero velocity. Charge of electron = -1.6 × 10-¹⁹ C and mass of electron = 9.1 x 10-31 kg
9 Determine the saturation energy of the following lasers: a Nd:YAG at 1.06 µm; b Ti: Al203 at 800 nm; c ruby at 694.3 nm; d Nd:YVO4 at 1.06 µm.
In a four level laser amplifier, the relative energy of states, measured from the ground state E, = 0, are E, = 0.55 eV, E2 = 2.20 eV, and Ez = 2.65 eV. i) Optical pumping is used to achieve the population inversion. What is the maximum wavelength and colour of light used for pumping? ii) What is the wavelength of the light which can be amplified by this system?
10 A Nd:YVO4 laser operating in a pulsed mode at 1.06 µm is placed in a cavity with mirrors of 95% reflectivity at each end of the laser. The scattering losses are determined to be 0.4% per pass. If the laser produces output pulses of 200-us duration in a beam of diameter 6 mm and if the small-signal gain is measured to be 20% per pass, what would be the energy of the pulses emerging from the laser?
i need the answer quickly
Q10) Describe the Float-zone crystal growth process.. Draw the configuration.
3) A typical LED emissions spectrum is shown below: Intensity Exciton Emission E₂ E + KT/2 Energy 3a) At what energy is the intensity maximum located for a GaAs LED operating at room temperature? The band gap of GaAs is 1.42eV. Be sure to include units. 3b) What wavelength does this correspond to? Be sure to include units.