A mixture consisting of only copper(II) chloride (CuCl₂) and calcium chloride (CaCl₂) weighs 1.0052 g. When the mixture is dissolved in water and an excess of silver nitrate is added, all the chloride ions associated with the original mixture are precipitated as insoluble silver chloride (AgCl). The mass of the silver chloride is found to be 2.3492 g. Calculate the mass percentages of copper(II) chloride and calcium chloride in the original mixture. Mass percent CuCl₂ = Mass percent Carl % n

A mixture consisting of only copper(II) chloride (CuCl₂) and calcium chloride (CaCl₂) weighs 1.0052 g. When the mixture is dissolved in water and an excess of silver nitrate is added, all the chloride ions associated with the original mixture are precipitated as insoluble silver chloride (AgCl). The mass of the silver chloride is found to be 2.3492 g. Calculate the mass percentages of copper(II) chloride and calcium chloride in the original mixture. Mass percent CuCl₂ = Mass percent Carl % n

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Some chemical reactants are listed in the table below. Complete the table by filling in the oxidation state of the highlighted atom. oxidation state of highlighted atom 0 0 0 0 species Cl₂(9) H₂O(1) CuCl₂(s) + Ag (aq)
A student was asked to determine the percentage of the components of a binary mixture of KBr, potassium bromide, and Mg (OH)2, magnesium hydroxide. The mass of the mixture used was 6.321 grams. The student extracted the KBr with water since KBr is soluble in water and Mg(OH)2 is not. The magnesium hydroxide remained in the container after the KBr was extracted with water. After evaporation of the filtrate, the KBr residue was dried and weighed. Its dry mass was found to be 2.864g. The insoluble Mg(OH)2 was also dried and had a mass of 3.204 grams. a. Calculate the percent of KBr in the mixture. b. Calculate the percent of Mg(OH)2 in the mixture. c. Calculate the percent of recovery using the total mass of substances recovered. d. Calculate the percent error of this total recovery.
The following chemical reaction takes place in aqueous solution: Mg(NO3)₂(aq) + 2NaOH(aq) → Mg(OH)₂(s) +2 NaNO3(aq) Write the net ionic equation for this reaction. 0 ローロ X 2 On 4
Write the net ionic equation for the precipitation reaction that occurs when aqueous solutions of potassium sulfide and chromium(II) iodide are combined.
Does a reaction occur when aqueous solutions of manganese(II) sulfate and potassium carbonate are combined? If a reaction does occur, write the net ionic equation.
The following chemical reaction takes place in aqueous solution: Fe(NO3)₂(aq) + (NH₁) S(aq) → FeS(s)+2 NHÃNO³(aq) Write the net ionic equation for this reaction. 0 ローロ X 2 4
A solution of NaCl(aq) is added slowly to a solution of lead nitrate, Pb(NO3)₂(aq), until no further precipitation occurs. The precipitate is collected by filtration, dried, and weighed. A total of 18.46 g PbCl₂ (s) is obtained from 200.0 mL of the original solution. Calculate the molarity of the Pb(NO3)₂(aq) solution. concentration: M Question Source: McQuarrie, Rock, And Gallogly 4e - General Chemistry | Publisher: University Science Books
A 3.859 g sample containing impure CuCl2· 2 H20 was heated to constant mass. The sample mass after heating to drive off the water was 3.161 g. What was the mass percent of CuCl2· 2 H2O in the original sample?
References A 3.41 g sample of iron ore is transformed to a solution of iron(II) sulfate, FeSO4. This solution is titrated with 0.160 M K2 Cr2O7 (potassium dichromate). If it requires 42.8 mL of potassium dichromate solution to titrate the iron(II) sulfate solution, what is the percentage of iron in the ore? The reaction is 6FESO, (ag) + K, Cr2O7(ag) + 7H,SO4 (aq) → 3FE2 (SO4)3 (ag) + Cr2 (SO4)3(ag) + 7H2O(1) + K2S04(ag) Percentage = Submit Answer Try Another Version 3 item attempts remaining
A mixture consisting of only chromium(III) bromide (CrBr3) and aluminum bromide (AlBr3) weighs 1.1218 g. When the mixture is dissolved in water and an excess of silver nitrate is added, all the bromide ions associated with the original mixture are precipitated as insoluble silver bromide (AgBr). The mass of the silver bromide is found to be 2.2708 g. Calculate the mass percentages of chromium(III) bromide and aluminum bromide in the original mixture. Mass percent CrBr3 Mass percent AlBr3 = % %
A 1.500-g sample of a mixture of solid Na3PO4 12H2O and BaCl2 2H2O was dissolved in water and formed 0.520 g Ba3(PO4)2 precipitate.If reagent tests demonstrated that Na3PO4 12H2O was the limiting reactant in the precipitation reaction. Calculate the mass percent of each reactant salt in the original sample.
Suppose you took a 3.00 mL sample of HNO3 (aq) of an unknown concentration, and find that you have to add 20.30 mL of 0.106 M NaOH from your buret to neutralize the acid. How many moles of OH- Ions are neutralized in this reaction?