A mechanical refrigeration system shown below with R-1234yf is operating under such conditionsthat the evaporator pressure is 150 kPa and the liquid approaching the refrigerant control valve isat a temperature of 40 C. Assume state 1 is saturated vapor and state 3 is saturated liquid. If thesystem has a capacity of 15 kW, determine:a. the refrigerating effect per kilogram of refrigerant circulated [kJ/kg],b. the mass flow rate per refrigeration capacity [kg/s-kW],c. volume flow rate per refrigeration capacity [L/s-kW] at the compressor inlet,d. total mass flow rate [kg/s],e. compressor power [kW] if the isentropic efficiency is 0.8; (Note: If needed, use the closestisobar given in tables),f. COP,g. Condenser heat rejection [kW],h. Massflow [kg/s],i. Compressor discharge temperature [C] (Note: Use the closest isobar given in tables),j. Show the cycle on P-h state diagram, showing/labeling isothermal, isobaric, and isenthalpiclines with given values. Show the states with points and labels.

Note: As per policy we can solve the first three subparts. Please resubmit the remaining parts.

Answered: A mechanical refrigeration system shown…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Steam generators are a type of heat exchanges that are used in power plants to generate steam at desired pressure and temperature (Fig. Q1.b). In a steam generator, saturated liquid water at 30°C enters a 60-mm diameter tube at the volume flow rate of 12 L/s. After exchanging heat with hot gas, the water changes to steam and leaves the generator at a pressure of 9 MPa and a temperature of 400°C. During this process, the diameter of the water/steam tube does not change.(iii) What is the exit velocity of the steam?
Thermodynamics problem
Describe the T-s diagrams accordingly by filling in the blanks. Use the sets of words given below for the correct description. reheat/ closed Ideal / Actual / vapour /cycle /Carnot/ Rankine/ Brayton/Ericsson/Stirling/regenerative/ open/with/a Nino To C @ 4 2. 5. 6. a b с e T f 1 4 In a two-stage gas turbine plant, with reheating after the first stage TA 25 decreases the thermal efficiencies. increases the thermal efficiencies. does not affect thermal efficiencies. Decreases the work ratio. increases the work ratio. does not affect the work ratio. equal. unequal. 2 5 The ideal compressor work and turbine work in a jet-propulsion engine is a b 9in 2/ qout Wpump.in High-pressure turbine 3 Reheating 6 Wturb,out Low-pressure turbine с not related to each other. d unpredictable (a) By writing an energy balance on the heat exchanger of a binary vapour power cycle, obtain a relation for the exit enthalpy regarding the mass flow rates of two fluids in terms of the other enthalpies. Take the…
In the two-pipe system, water flows continuously from the inner pipe and air from the outer pipe (steady-state). ˙The pressure change in both pipes is negligible. In addition, heat interaction with the environment, kinetic and potential energy changes are also neglected. In this system shown in Figure 1, the water flowing from the inlet number 1 is in the state of saturated vapor (gas). In this case, calculate the outlet temperature (T2) for the given system, using the ideal gas approximation for air. (it should be solved iteratively.) (Please solve it on paper and solve it line by line. When you type it, it becomes too complicated to understand. Also please explain your solution and don't write too close. Thank you for your effort)
Thermodynamics
In the two-pipe system, water flows continuously from the inner pipe and air from the outer pipe (steady-state). ˙The pressure change in both pipes is negligible. In addition, heat interaction with the environment, kinetic and potential energy changes are also neglected. In this system shown in Figure 1, the water flowing from the inlet number 1 is in the state of saturated vapor (gas). In this case, calculate the outlet temperature (T2) for the given system, using the ideal gas approximation for air. (Hint: it will be solved iteratively.)
| Part of a refrigeration system operates at steady state with Refrigerant 22 as shown in the figure below. There is no significant heat transfer to or from the heat exchanger, valve, and piping. Kinetic and potential energy effects are negligible. State 1 is a saturated liquid. What temperature is it, in °F? Describe the refrigerant at state 4 as one of the following: compressed liquid, saturated liquid, tyro-phase mixture, saturated vapor, or superheated vapor. Determine the required mass flow for the given operating conditions, in lb/min. Determine the rate of heat transfer between the evaporator and its surroundings, in b. Btu/min. Make sure to clearly state the direction of heat transfer. 1. T=10°F P= 15 Ibf in (AV), = 9.5 ft/min. Pi= 120 Ibf/in.? Heat exchanger Throttling valve Evaporator P 15 lbfin.2 X3 = 1.0 P2= 15 lbf/in.2
3
Write the energy balance for the described control volume
Consider the series of processes shown in the p-V diagram below for a piston-cylinder system. Given the diagram information, determine the net work for the process from State 1 to State 3, in units of [kJ]. Specify whether the net work is into or out of the system, per our convention.
The figure below shows a schematic of a dual-duct system For design purposes, suppose the zones shown are two of five zones, each having identical operating design conditions. The only exhaust is the main system exhaust. The zones are to held at 75 °F db / 50% RH when the total heat gain of each one is 200,000 BTUH and the sensible heat ratio is 0.6. Outside air (OA) is 95 °F db / 40% RH and the system is designed to operate with a mass flow rate of dry air that contains 25% OA & 75% RA (return air). The hot deck provides sensible heating only, and the air exits the heating coil at 105 °F db. The cold deck is designed such that air exits the cooling coil at 50 °F db / 90 % RH. Take the pressure to be one standard atmosphere. a. Accurately sketch and label the state points on an electronic psych chart (in particular make sure that the coil is represented as a collie on the TRANE pscyh chart software you can input a coil process) b. Compute the mass flow rate (lbma/hr) through…
V:03)

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS