A magnetic B field of strength 0.9 T is perpendicular to a loop with an area of 4 m². If the area of the loop isreduced to zero in 0.4 s, then what is the magnitude of the induced emf voltage?VSubmit AnswerTries 0/28The original B field penetrating the loop pointsthe page.8As the loop is pulled as indicated, the magnetic flux O penetrating the loopTherefore, the loop generates an induced B field that pointsthe page.O This induced B field is due to an induced current that flowsin the loop.

Given data The magnitude of the magnetic field is B = 0.9 T The area of the loop initially is A1 = 4…

A magnetic B field of strength 0.9 T is perpendicular to a loop with an area of 4 m². If the area of the loop is reduced to zero in 0.4 s, then what is the magnitude of the induced emf voltage? V Submit Answer Tries 0/2 8 The original B field penetrating the loop points the page. e As the loop is pulled as indicated, the magnetic flux 0 penetrating the loop e Therefore, the loop generates an induced B field that points the page. O This induced B field is due to an induced current that flows in the loop.

A magnetic B field of strength 0.9 T is perpendicular to a loop with an area of 4 m². If the area of the loop is reduced to zero in 0.4 s, then what is the magnitude of the induced emf voltage? V Submit Answer Tries 0/2 8 The original B field penetrating the loop points the page. e As the loop is pulled as indicated, the magnetic flux 0 penetrating the loop e Therefore, the loop generates an induced B field that points the page. O This induced B field is due to an induced current that flows in the loop.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

X X X X x'X The square conducting loop shown in the figure lies in the r-y plane. The loop is in a uniform magnetic field at a particular instant and the field that points into the paper/screen. The magnitude of the magnetic field begins to decrease at a rate of 7.5 T/s. What is the induced electric current (in A) in the loop? Assume the resistance is 66.7 N and the length of each side of the loop is 5.6 m. State your answer correct to 1 decimal point. Use a period (full stop) for the decimal point. Do not include units in your answer. ×区××
A wire coil of 30 turns has a cross-sectional area of 12 cm2. The coil is placed in a uniform field of a large magnet with B = 0.27 T. The coil is suddenly rotated 90 o from an orientation parallel to the field to one perpendicular to the field. The time to flip the coil is 0.57 s. What is the magnitude of the average emf produced? What will be the average current produced if the circuit of the coil is closed and the resistance is 55 ohm?
The figure shows a uniform magnetic field that is normal to the plane of the conducting loop of resistance R. Note: the area of the non- circular portion of the circuit is negligible compared to that of the loop. B 04 Which entry in the table below correctly pairs the change in the system with the direction of the induced current through R? change in the system direction of current through R decrease the area of the loop rotate loop into the paper decrease the magnitude of B increase the area of the loop pull loop to the right from top toward bottom no induced current from bottom toward top from bottom toward top from top toward bottom
A loop is placed in a region where the magnetic field is changing. At t = 0 s the magnetic field is 1 T directed into the page. Over a period of 2 s the field changes uniformly to 1 T directed out of the page. Which of the following describes the direction, clockwise (CW) or counterclockwise (CCW), of the induced EMF in the loop? a. CCW for 1 s, the CW for 1 s. b. CW for 2 s. c. CW for 1 s, then CCW for 1 s. d. CCW for 2 s.
A wire coil of 20 turns has a cross-sectional area of 8 cm2. The coil is placed in a uniform field of a large magnet with B = 0.47 T. The coil is suddenly rotated 90 o from an orientation parallel to the field to one perpendicular to the field. The time to flip the coil is 0.43 s. What is the magnitude of the average emf produced? What will be the average current produced if the circuit of the coil is closed and the resistance is 65 ohm?
A flat loop of wire consisting of a single turn of cross- sectional area 0.01 m^2 is perpendicular to a magnetic field that increases uniformly in magnitude from 2T to 8T in 3s. What is the EMF in the loop?
You have a solenoid with an initial current of 386 A and a turn density of 6088 What is the initial magnetic field through the solenoid? Binitial = 2.95 T The current in the solenoid drops to 51 A over the course of 1.1 ms. What is the final magnetic field through the solenoid? Bfinal = T Inside the solenoid is a coil with 75 loops and a radius of 9.0 cm. The coil is aligned so that the magnetic field from the solenoid passes through the coil perpendicular to the plane of the coil (directly down the center of the coil). What is the magnitude of the induced emf in the 75-turn coil at the center of the solenoid during this change in magnetic field? Enter you answer as a positive number. emf = V The coil has a resistance of 20 2. What is the current through the coil? Icoil A loops m = What is the power dissipated by the coil? Pcoil = W
Question 1: When an external magnetic flux through a conducting loop decreases in magnitude, a current is induced in the loop that creates its own magnetic flux through the loop. How does that induced magnetic flux affect the total magnetic flux through the loop? O It does not affect the total magnetic flux. O It decreases and then increases the total magnetic flux. OIt increases the total magnetic flux. OIt increases and then decreases the total magnetic flux. O It decreases the total magnetic flux. Part (a) Some additional information, which is not included in the video, is that the SI unit of magnetic flux is the weber, denoted Wb. Using that information and the contents of the video, solve this numerical problem: A conducting loop, with a resistance of 2.0 Q2, encloses magnetic flux that is increasing at the rate of 2.0 Wb/s. The magnitude of the current induced in the loop is... (select the best choice) Part (b) 02A 04A 01/2A O1A 01/4 A Imagine a circular conducting loop glued…
Motional EMF Below is a rectangle that is being pulled into a magnetic field as shown. The rectangle has a height of h = 0.400 m and is being pulled to the right with a velocity of v = 188.0 m/s. This magnetic field starts where shown, so the left most side of the rectangle has no magnetic field. There is 1 loop with a total resistance of R = 15.40 Ohms. The magnetic field has a magnitude of B = 34.0 mT. That means as the loop moves to the right, the magnetic flux inside the loop is increasing. Magnetic Field (out of the page) Direction of velocity What is the induced current within the wire in this system? (Use a negative sign for clockwise current) Make sure to give your answer with appropriate significant figures and remember that you are looking for a magnitude. Your Answer: Answer units Height
A conducting rod slides over two horizontal metal bars with a constant speed v to the left. The entire set up is in a region of uniform magnetic field that is perpendicular to the plane of the rod and bars. If the induced current through the resistor is as indicated, what is the direction of the magnetic field? R M out of the page into the page I V*
The magnetic field through a single loop of wire 14.0 cm in radius and of 11.5 Ω resistance changes with time as shown in the figure. Calculate the emf in the loop as a function of time. a)What is the emf at t = 1.0 s? For the sign take the loop in the plane of the paper, and the magnetic field out of the paper. Take clockwise to be positive emf. b)What is the emf at t = 3.0 s? c)What is the emf at t = 5.0 s? d)What is the current at t = 1.0 s?
An MRI technician moves his hand from a region of very low magnetic field strength into an MRI scanner’s 2.00 T field with his fingers pointing in the direction of the field. His wedding ring has a diameter of 2.1 cm and it takes 0.375 s to move it into the field. a) What average current is induced in the ring in A if its resistance is 0.0100 Ω? b) What average power is dissipated in mW? c) What magnetic field is induced at the center of the ring in T?