A liquid feed of pure A (1 mole/liter) is treated in two reactors of 2-liter volume each and reacts with a rate of rA=0.05CA2 in mole/L-s. Find what feed rate in liters/minute that will give a final outlet concentration of CA=0.50 mole/liter If two MFRs in series are used.

Q: A liquid reactant solution is pumped through a pre-heater before entering a reaction vessel. The…

A: a) and b) The liquid reactant at a temperature of 25oC is pre-heated before it enters the reactor.…

Q: The design fluid (typically water and antifreeze) flow rate through a solar hotwater heater system…

A: The flow rate of the fluid = 0.025 gpmft2or gallonsmin.ft2 Dimension of each solar panel = 4ft×8ft…

Q: A simple (i.e. single equilibrium stage) batch still is being used to separate benzene from…

A:

Q: The ff rxns occurs in a constant temperature constant volume batch reactor with k₁=0.05/min,…

A: Given data: k1=0.05 min-1k2=0.025 min-1k3=0.015 min-1k4=0.008 min-1CAO=10 mol/litt=30 min

Q: A reversible reaction A + BeR + S was performed in a liquid-phase batch reactor. Several samples…

A: Given Reversible reaction A+B⇌ R+S Liquid phase batch reactor Normality=0.675N Volume of sample…

Q: A liquid phase that is homogeneous as well as irreversible reaction X → Y proceeds where temperature…

A: Given:  Xx  = 70% = 0.7  Cxo  = 10 mol X/ L  vo = 3 L/min k = 0.15  -rx = k Cx1.5  = k [ Cxo - Cxo…

Q: SO2 concentration in the flue gas of a coal burning power station is 1,300 ppm. The molar flow rate…

A: Find -The dewatered sludge mass flow rate Given:Flue gas molar flow rate Flue gas temperature…

Q: (a) Discuss the concept of 'rate of chemical reaction' from the perspectives of reacting and product…

A: Rate of a chemical reactions tells us at what speed the reaction proceeds but it does not tell the…

Q: 2200 kg / hr of propane gas is burned with 5% excess air and the process is to be designed for a 95%…

A: given that, the mass flow rate of propane gas = 2200 kg/hr percentage of excess air = 5% = 0.05…

Q: A Biomass ( CH1.4 O0.6) has a heating value HHV = 16 MJ/Kg is to be converted to green H2 (Heating…

A: Maximum amount of green hydrogen that can be produced from this biomassWrite down all the possible…

Q: In the R&D (research and development plant) the elementary gas-phase reaction of organic compound is…

A: Given: At T1 = 60 oC or 333 K, the rate constant is K = 0.004 min-1 Partial pressure of A i.e. PA =…

Q: A liquid reactant solution is pumped through a pre-heater before entering a reaction vessel. The…

A: a) and b) The liquid reactant at a temperature of 25oC is pre-heated before it enters the reactor.…

Q: 03:0.75 lbm/min of C3H8 is burned at 77 °F with 150 percent excess air that enters the furnace at 40…

A:

Q: 3. A mixture of 10 wt% water and 90 wt% chloroform enters a gravity separator at the flow rate of 20…

A: It is given that a mixture of 10 wt% water and 90 wt% chloroform enters a gravity separator. Given…

Q: All % compositions in the following problem are by mass, unless otherwise noted. The flow-sheet of…

A: Draw the flow diagram for the process as follows:

Q: Determine the number of equilibrium stages and optimal-stage locations for the feed and liquid…

A:

Q: A continuous single effect evaporator concentrate a dilute juice stream entering at 3wt% salt…

A: Concentration of salt entering the evaporator = 3 wt % Salt concentration exiting the evaporator =…

Q: In a continuously operating distillation column, 5000 kg/h equimolar mixture of CCl4 and CS2 will be…

A: Mass flow rate of equimolar mixture of CCl4 and CS2 = 5000 Kg/hRecovery rate = 3CS2 in top product =…

Q: Q1: oil fraction has API of 43 is to be distilled at uniform rate. The temperature of the vapor when…

A: Distillation is the process of separating components of a mixture based on different boiling points.…

Q: A mixture of 10 wt% water and 90 wt% chloroform enters a gravity separator at the flow rate of 20…

A:

Q: A distillation column is separating component A from Component B. Component A is the MVC. The column…

A: The minimum reflux ratio for the distillation process is to be calculated.

Q: Aqueous A at a concentration CA0 = 1 mol/liter is introduced into a batch reactor where it reacts…

A: First, draw the graph of t vs CA to find the value of the rate constant:

Q: A continuously operating distillation column is fed 40% ethanol and 60% propanol by weight at a…

A: A mixture of ethanol and propane is fed to a continuous distillation column, with the following…

Q: A partial oxidation is carried out by bubbling air through a batch of liquid in a pressurized…

A: Partial oxidation -In batch of liquid by bubbling air in a pressurized reactor D=3m and h=5m…

Q: Basis: 1 mol feed. Since the problem statement asks us to calculate the ratio of the volumes of feed…

A: To solve the unknowns in a chemical process, the degree of freedom must be equal to zero. If DOF is…

Q: A mixture containing 60 wt% of acetone and 40 wt% of water is to be separated using a distillation…

A:

Q: In a distillation tower, two-component mixtures A and B are introduced by two streams, one with…

A: Following questions are asked to answer. Flow rates of each components Expression for rectifying…

Q: Using a packed column, ammonia is absorbed from air to water. The incoming gas contains 6% NH3 and…

A:

Q: A Pollution Control Officer is asked to design a system to drain the sugar central's wastewater.…

A: Given Details: for a Pipe, Flow rate through pipe, Q =171.5 kg/s Available head, h =4.57 m of H2O…

Q: A distillation column is separating component A from Component B. Component A is the MVC. The column…

A: Distillation is a process of separation of liquid components from the liquid mixture. Distillation…

Q: Assume we have a bioreactor where the following two reactions are taking place. The bioreactor has…

A: Hi and thanks for the question. Since you have posted a question with multiple subparts, we will…

Q: Q.1A distillation column receives a feed that is 40 mole % n-pentane (Cs) and 60 mole % n-hexane…

A: F=2500 lb/hr xF=0.4 xD=0.97 xB=0.02 Overall material balance equation: F=B+D  2500=B+DD=2500-B…

Q: theoretical number of racks, the actual number of racks, and the location of the

A:

Q: A plug flow reactor operating at 30 °C is to be used for the first order reaction of substance A in…

A: Plug flow reactor T=30℃ First order reaction Liquid phase reaction CA0=2 kmol/m3 FA0=0.07 kmol/s k=…

Q: Q.1 A hydrocarbon gas A is fed continuously to a mixed flow reactor at 450°C and pressure 6 atm,…

A:

Q: 8

A: To find the pressure drop across the catalyst bed in a fixed-bed catalytic reactor, you can use…

Q: benzene -toluene containing 55% benzene is desired to be separated at a pressure of latm in a…

A: A mixture of benzene and toluene is separated in a continuous fractionating column.

Q: a continuous-stirred tank reactor where is receiving a feed of 200 liters per hour and a reactant…

A:

Q: The primary process to currently make hydrogen is Steam Methane Reforming (SMR) of natural gas. This…

A: Given, reactor effluent molar flow rate is 100 kmol per hour. Given, reactor effluent contains 26.1…

Q: Cooling Water ele Distillate = ? Distillation Feed = 10 kg/sec 60% ELOH Column 40% H,0 10% ELOH wt =…

A: Feed rate = 10 kg/sec = 10000 g/s Fraction of ethanol = 0.1 Fraction of water = 0.9  Molar mass of…

Q: flow rate of DI, F2, D2, W2, and the composition of F2.

A: Material balance depends on conversation of mass quantities. This balance is also known as mass…

Q: reacts with a rate of rA=0.05 CA2, mole/liter-sec.

A:

Q: There is a saponifier which has an inflow of 100Kmol / H of Ca (OH) 2, 88.36 Kmol / H with propylene…

A: Draw the diagram for the process as follows:

Q: 1. Volume of water, ml 500 2 Volume of methanol, ml 500 Density of Water at Tr, (Pw, g/cc) 3 1.0000…

A: