A liquid feed of pure A (1 mole/liter) is treated in two reactors of 2-liter volume each and reacts with a rate of rA=0.05 CA2, mole/liter-sec. Find what feed rate in liters/min that will give a final outlet concentration of CA=0.50 mole/liter if two CSTRs in series are used.

Q: The design fluid (typically water and antifreeze) flow rate through a solar hotwater heater system…

A: The flow rate of the fluid = 0.025 gpmft2or gallonsmin.ft2 Dimension of each solar panel = 4ft×8ft…

Q: SO2 concentration in the flue gas of a coal burning power station is 1,300 ppm. The molar flow rate…

A: Find -The dewatered sludge mass flow rate Given:Flue gas molar flow rate Flue gas temperature…

Q: is carried out with the feed entering at 300 degrees celsius. The feed contains 90 moles%…

A: Given,

Q: (a) Discuss the concept of 'rate of chemical reaction' from the perspectives of reacting and product…

A: Rate of a chemical reactions tells us at what speed the reaction proceeds but it does not tell the…

Q: (a) If wastewater leaves the plant at ṁ1 the treatment unit (i.e., ṁ5) and to the waste lagoon…

A: Given that: Waste water has Cr =5.15 % = 0.0515 Cr has to be removed = 95%= 0.95   Wastewater leaves…

Q: 03:0.75 lbm/min of C3H8 is burned at 77 °F with 150 percent excess air that enters the furnace at 40…

A:

Q: two distillation columns in series,

A: There are two distillation columns in series. Three components are associated with the process…

Q: 3. A mixture of 10 wt% water and 90 wt% chloroform enters a gravity separator at the flow rate of 20…

A: It is given that a mixture of 10 wt% water and 90 wt% chloroform enters a gravity separator. Given…

Q: All % compositions in the following problem are by mass, unless otherwise noted. The flow-sheet of…

A: Draw the flow diagram for the process as follows:

Q: Determine the number of equilibrium stages and optimal-stage locations for the feed and liquid…

A:

Q: In a continuously operating distillation column, 5000 kg/h equimolar mixture of CCl4 and CS2 will be…

A: Mass flow rate of equimolar mixture of CCl4 and CS2 = 5000 Kg/hRecovery rate = 3CS2 in top product =…

Q: A mixture of 10 wt% water and 90 wt% chloroform enters a gravity separator at the flow rate of 20…

A:

Q: A solution of Acetone in Water is to be extracted using Chloroform as the solvent. The feed is 1000…

A: feed F = 1000 kg/h  Acetone % in feed  xf=35 % =0.35  Pure solvent chloroform  % in feed Ys = 0…

Q: An input stream to a reactor consists of 100 kmol/s total and is made of 30 mol% CH4, 40 mol% C2H4,…

A: Given, The molar flow rate of the steam, F = 100 kmol/s The mole% of the components are 30% CH4, 40%…

Q: required duty of the reactor jacket in units of BTU/hr

A:

Q: A plug flow reactor operating at 30 °C is to be used for the first order reaction of substance A in…

A: Plug flow reactor T=30℃ First order reaction Liquid phase reaction CA0=2 kmol/m3 FA0=0.07 kmol/s k=…

Q: Part of a professor's work in her previous job involved boiling and condensing hydrocarbon mixtures.…

A:

Q: 8

A: To find the pressure drop across the catalyst bed in a fixed-bed catalytic reactor, you can use…

Q: The primary process to currently make hydrogen is Steam Methane Reforming (SMR) of natural gas. This…

A: Given, reactor effluent molar flow rate is 100 kmol per hour. Given, reactor effluent contains 26.1…

Q: Fuel used as the main energy source for incineration contains M% of carbon. The amount of carbon…

A:

Q: 4-25. A complex mixture of aromatic compounds leaves a chemical reactor and is fed to a distillation…

A: Given that  Distillate flow rate ,D = 125 kg/h Bottom flow rate ,w = 76 kg /h And data of…

Q: 4-23. A mixture of ethanol (A) and water (B) is separated in a distillation column. The volumetric…

A: Given data

Q: The gas phase reaction A → 2R + ½S is carried out in a tubular reactor with the following reaction…

A: Given : Tubular reactor dimensions:Power current composition: Global feeding rate Feed current…