Answered: A lightning stroke lasts 0.01 s and…

Science

Physics

A lightning stroke lasts 0.01 s and involves a flow of 199 C. What is the current? A Need Help? Read It Watch t

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 25P: The quantity of charge through a conductor is modeledas Q=4.00Cs4t41.00Cst+6.00mc .What is the...

See similar textbooks

Related questions

Q: During 10 seconds of use, 260 C of charge flow through a microwave oven. Compute the size of the…

Q: 5. Using the circuit symbols (lesson 4), label the circuit diagram. Be sure to classify the circuit…

A: 5. here given circuit is open and closed circuit.

Q: A student performed the experiment of the specific charge of copper ions and found that k = 3.03 x…

A: Current, I= 5 Ampere k= 3.03 x 106 C/Kg

Q: 1.47The energy absorbed by the BOX in Fig. P1.17 is given below. Calculate and sketch the current…

A: Step 1: Step 2: Step 3: Step 4:

Q: The current in a lightning bolt is 4.9 x 10° A. How much charge passes through a cross- sectional…

A: Given, Current flowing through lightning bolt is, i=4.9×105A And Current can be defined in terms…

Q: A large lightning bolt had a 15,300 A current and moved 29.5 C of charge. What was its duration (in…

Q: In the figure below, what is the net resistance of the circuit connected to the battery? Each…

A: Its given that:

Q: A steel wire of length L and radius r₁ has a resistance R. A second steel wire has the same length…

Q: A copper wire has a diameter of 1.422 mm. What magnitude current flows when the drift velocity is…

A: Given data Diameter , d=1.422 mm=1.422×10-3 m Drift velocity, vd=2.34 mm/s=2.34×10-3m/s Density of…

Q: 1. A refrigerator and a rice cooker are connected in parallel to a 220 V line. The current in the…

Q: A radiograph is taken using an 8.4 mAs value and 120 mA current. What was the time in milliseconds?…

A: Given data The magnitude of the charge using radiograph is Q = 8.4 mAs The magnitude of the current…

Q: The amount of charge flowing through a circuit varies with time according to... q(t) = 0.2t2, with…

A: q = 0.2*t2 So, current i = d(q)/dt i = d(0.2*t2)/dt i = 0.2*d(t2)/dt i = 0.2*2*t*d(t)/dt i = 0.4*t

Q: 5. A 250-volt electrical heater is used to warm 3Li/hr of water from 19°C to 98°C. Assume heat…

A: Given: The voltage supplied to the heater: VH=250 V The volume of water to be heated: vw=3 Li…

Q: A change of 401 C charge pass through an imaginary plane during a time interval of 2.0 minutes.…

Q: 10 nC of charge flows through a circuit in 3.0 × 10-s. What is the current -6 during this time?

A: given value --- Charge , Q = 10 nC = 10 * 10-9 C . time , t = 3 * 10-6 s . We have to find---…

Q: An electric current transports 360. µC of charge in 224. milliseconds. Calculate the size of the…

A: Electric current is the flow of electric charge through a conductor or a material. It is a measure…

Q: The compressor on an air conditioner draws 89.1 A when it starts up. The start-up time is about…

A: Given:) current I=89.1 A start up time=0.243 s We know that “current through a cross sectional area…

Concept explainers

Ohm's law

Ohm’s law is a prominent concept in physics and electronics. It gives the relation between the current and the voltage. It is used to analyze and construct electrical circuits. Ohm's law states that the voltage across a conductor is directly proportional to the current flowing through it.

Path of Least Resistance

In a series of alternate pathways, the direction of least resistance is the actual or metaphorical route that offers the least resistance to forwarding motion by a given individual or body.

Question

A lightning stroke lasts 0.01 s and involves a flow of 199 C. What is the current?
A
Need Help?
Read It
Watch t

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Make a sketch of an electric circuit that contains a switch and two lightbulbs connected in such a way that if either bulb burns out the other still functions, but if the switch is turned off, both bulbs go out.
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Saltwater contains an equal number of positive and negative ions. When saltwater is flowing through a pipe, does it constitute an electric current?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Explain what current, resistance, and voltage are.
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . A solid metal cylinder has a certain resistance. It is then heated and carefully stretched to form a longer, thinner cylinder. After it cools, will its resistance be the same as, greater than, or less than what it was before? Explain our choice.
What is the current in milliamperes produced by the solar cells of a pocket calculator through which 4.00 C of charge passes in 4.00 h?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . There are two basic methods for connecting more than one electrical device in a circuit. Name, describe, and give the advantages of each.
A battery with an emf of 24.00 V delivers a constant current of 2.00 mA to an appliance. Haw much work does the battery do in three minutes?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . What is the purpose of having fuses or circuit breakers in electric circuits? How should they be connected in circuits so they will be effective?
What is the current when a typical static charge of 0.250 C moves from your finger to a metal doorknob in 1.00 C?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . If a new material is found that is a superconductor at all temperatures, what parts of some common electric deices would definitely not be made out of it? Explain.
The current of an election beam has a measuredcurrent of I=50.00A with a radius of 1.00 mm2. What is the magnitude of the current density of the beam?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Six resistors, all having the same temperatures and compositions, are each attached to a battery with voltage V to form a simple circuit. The resistors have different lengths, l, but the same diameters. Rank the circuits according to the current that flows through the resistor from smallest to greatest. If two (or more) circuits have the same current flowing, give them the same ranking. Explain the rationale you used to establish your rankings. Circuit 1: l = 2 cm; V = 3 V Circuit 2: l = 2 cm; V = 6 V Circuit 3: l = 1 cm; V = 3 V Circuit 4: l = 1 cm; V = 6 V Circuit 5: l = 3cm; V = 2 V Circuit 6: l = 3cm; V = 6 V