A jet transport has a weight of 2.14 x 106 N and is at rest on the runway. The two rear wheels are 17.0 m behind the front wheel, and the plane's center of gravity is 10.5 m behind the front wheel. Determine the normal force exerted by the ground on (a) the front wheel and on (b) each of the two rear wheels.

A jet transport has a weight of 2.14 x 106 N and is at rest on the runway. The two rear wheels are 17.0 m behind the front wheel, and the plane's center of gravity is 10.5 m behind the front wheel. Determine the normal force exerted by the ground on (a) the front wheel and on (b) each of the two rear wheels.

Similar questions

If the pole makes an angle of 25° with the horizontal, the distance between the point where the line is attached to the pole and the anglers hand is L = 2.45 m, and the fish pulls on the line such that the tension in the line is T = 166 N at an angle 35.0° below the horizontal, determine the magnitude (in N · m) of the torque exerted by the fish about an axis perpendicular to the page and passing through the angler's hand.
A 7-kg mass (m1) hangs from a cord that runs through a pulley and back down to attach to a 6-kg mass (m2) that is hanging from the other side. The pulley has a mass of 5.00-kg and a diameter of 20-cm. Find: A) the tension in the cord supporting m1 and the tension in the cord supporting m2; B) the tension in the cord supporting the pulley. C) Why is the answer to B) not equal to the sum of tensions in A)? Why is it not equal to the sum of the three weights?
Please help me
It is sometimes important to determine the location of a person’s center of gravity(which coincides with the center of mass because the gravitational force is uniform at the scale of the human body). This can be done with the arrangement shown intheFigure below. A light (negligible mass) plank rests on two scales that read Fg1=380 N and Fg2=320 N. The scales are separated by a distance of 2.00 m. How far from the woman’s feet is her center of gravity?
yo-yo with an inner cylinder of r = 3.5 cm and outer radius of R = 6.50cm is at rest on a theta = 30 degree incline. Itis held in place by friction and the tension in the string that is wrapped around its inner cylinder, as shown in the figure. Assume that the positive x-direction points down the incline. Determine the friction force if the mass of the yo-yo is 420g.
A 1 490-kg automobile has a wheel base (the distance between the axles) of 2.70 m. The automobile's center of mass is on the centerline at a point 1.05 m behind the front axle. Find the force exerted by the ground on each wheel. each front wheel _______kN each rear wheel _______kN
Problem 5: A 2.0 kg block, lying on a smooth table, is connected to another 5.0 kg block by means of a weightless cord passing over, without slipping, a cylindrical pulley of 2.0 kg mass and 10.0 cm radius placed at the edge of the table. The system is released from rest at t = 0. Consider g=9.8 m/s2. (a) In 0.3s the 5.0 kg block will drop by ________ (b) The tension in the part of cord connected horizontally to the 2.0 kg block is ________
A uniform disk with mass m = 8.75 kg and radius R = 1.41 m lies in the x-y plane and centered at the origin. Three forces act in the +y- direction on the disk: 1) a force 315 N at the edge of the disk on the +x-axis, 2) a force 315 N at the edge of the disk on the -y-axis, and 3) a force 315 N acts at the edge of the disk at an angle 0 = 38° above the -x-axis. +y +x F3 IF, F2
A 68 kg man is in the prone position while during pushups. His feet and hands are 95 cm and 42 cm away respectively from his center of mass. What is the normal force exerted by on each (a) hand and (b) foot?
Can you also double check the answer. Thank you in advance
While installing new spark plugs in your car, the manual specifies they be tightened to 74 Nm. If you can only apply a force to the wrench 21 cm from the plug, and only at an angle of 53 degrees, What magnitude force should you apply to the wrench?
A 15.0-kg bucket of water is suspended by a very light rope wrapped around a solid uniform cylinder 0.300 m in diameter with mass 12.0 kg. The cylinder pivots on a frictionless axle through its center. The bucket is released from rest at the top of a well and falls 10.0 m to the water. (a) What is the tension in the rope while the bucket is falling? (b) With what speed does the bucket strike the water? (c) write the kinetic equation as the bucket sink into the water, suppose the resistance force is proportional to the speed, the volume of bucket is V, and draw the free-body diagram.