A huge marble boulder on a quarry site sits on the ground. This marble is 10 m by 10 m and has a height of 16 m. The boulder is situated on a 6 m thick soil with e = 0.70, S = 65%, and G, = 2.68, then by a 5 m thick clay with e 0.80, G, 2.71 and LL = 48. The water table exists in between the sand-clay interface. The specific gravity of the marble is 2.60. Assuming that the clay is normally consolidated... Q: What is the primary consolidation settlement of the clay layer in mm using approximate method? Round off your answer to the nearest whole number.

A huge marble boulder on a quarry site sits on the ground. This marble is 10 m by 10 m and has a height of 16 m. The boulder is situated on a 6 m thick soil with e = 0.70, S = 65%, and G, = 2.68, then by a 5 m thick clay with e 0.80, G, 2.71 and LL = 48. The water table exists in between the sand-clay interface. The specific gravity of the marble is 2.60. Assuming that the clay is normally consolidated... Q: What is the primary consolidation settlement of the clay layer in mm using approximate method? Round off your answer to the nearest whole number.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Features of soil structure can affect а. soil strength from faults b. stability O C. strength from cementing and bonding d. non of these е. vertical permeability
Solve both,.please.
A container of volume 3 × 10-³ m³ weighs 10 N. Dry sand was poured to fill the container. The container and the sand together weighs 53 N. The porosity of the soil will be (Take G₂ = 2.7, Y = 9.81 kNm/³)
A soil layer consists of 4 meters upper dry sand with a void ratio of 0.45 and a specific gravity of 2.70. The lower 3 meters is clay having a void ratio of 0.9 and a specific gravity of 2.75. The ground water table is 4 meters below ground surface. Compute a) effective stress at 4 meters below ground surfaceb) effectivestress at the bottom of the clay layer c) effective stress at 6 meters below ground surface.
Q1. Stress caused Failure of Soil is known as: a. Internal stress b. deviator stress C. internal and external stress d. none of them
The weight density of a soil is given by y = 15 + 0.75h, where y is in KN/m3, and h is in meters. Determine the pressure, in kPa, at a depth of 4m. SHOW COMPLETE SOLUTION.NEED ASAP. THANK YOU.
I need the answer quickly
The profile at a site consists of 5 m of sand overlying 10 m of compressible clay, which in turn overlies a dense sand. The water table is at the top of the profile. The total unit weight of the top sand is 19 kN/m3, and that of the clay is 18 kN/m3. The cv of the clay is estimated to be 5 x 10-3 cm2/sec. Initially the clay is normally consolidated. It is planned to place a temporary fill that will exert a vertical load of 200 kPa over the entire site. How long must the fill be in place so that, after it is removed, the maximum past pressure at every point in the clay is at least 50 kPa larger than the vertical effective stress that existed before the fill was placed?
Pb-3 A 588 cm³ volume of moist sand weighs 1010 gm. Its dry weight is 918 gm and specific gravity of solids, G is 2.67. Assuming density of water as 1 gm/cm³, the void ratio is
Note: If you don't know the solution please leave it but don't give me wrong solution.
Calculate the saturated density from void ratio 0.8.
None