A horizontal uninsulated steam pipe passes through a large room whose walls and ambient air are at 300 K. The pipe of 125-mm diameter has an emissivity of 0.85 and an outer surface temperature of 373 K. Calculate the rate of heat loss per unit length from the pipe.

A horizontal uninsulated steam pipe passes through a large room whose walls and ambient air are at 300 K. The pipe of 125-mm diameter has an emissivity of 0.85 and an outer surface temperature of 373 K. Calculate the rate of heat loss per unit length from the pipe.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.32P: A long wire 0.7 mm in diameter with an emissivity of 0.9 is placed in a large quiescent air space at...

See similar textbooks

Related questions

Q: After sunset, radiant energy can be sensed by a person standing near a brick wall. Such walls…

A: The radiant thermal flux per square metre from a brick wall at this temperature: 526.75 W/m2

Q: A very long semicylindrical furnace has a radius of 2 m. The curved top surface, whose emissivity is…

Q: The onset of free convection. Plastic shrink wrap can be used to insulate windows by trapping air…

Q: A spherical ball of radius 0.62 m and surface temperature 554 oC is suspended vertically in a'very…

Q: A horizontal steam pipe with an outside diameter of 60.0 mm passes through a large room whose walls…

Q: A vertical, double-pane window(square), which is 1 m on a side and has a 25-mm gap filled with…

Q: sider a shed with an 8-ftx12-ft base and 4-ft height. The temperature of the outer surface of th and…

Q: A long pipe 5 cm in diameter passes through a room and is exposed to air at atmospheric pressure and…

Q: Driving force for the free convection is Shear stress forces Buoyancy forces None of the above…

A: This question is from heat transfer.

Q: wall/window is exterior. Assume the thermal conditions in adjacent spaces (west, south, north, above…

A: Given-Information:- 6 m long, 6 m wide, and 3 m high. 2.5 m x 4 m window Latitude = 40oN Ground…

Q: The vertical rear window of an automobile is of thickness I.= 8 mm and height = 0.5 m and contains…

Q: 2. Consider a vertical, single-pane window of width = height = 1 m. The interior surface is exposed…

A: The temperature of inner surface is The temperature of surrounding is The emissivity of surface is…

Q: Chips of width L _ 15 mm on a side are mounted to a substrate that is installed in an enclosure…

A: GivenTs=85+273=358 kTsur=T∞=298 ka) h=11.7 W/m2Kb) h=250W/m2KL=15 mmε=0.60

Q: Heat transfer problem.The internal surface area is an enclosure is 50 meter square. The surface is…

Q: PROBLEM 1 Consider an adult human standing in the centre of a closed room. The air and room’s…

Q: An overhead 65-m-long, uninsulated industrial steam pipe of 80 mm diameter is routed through a…

A: Given DataTs=200°CT∞=30°Ch=15W/m2Kε=0.6L=65mD=80mm

Q: int-baking consi long, triangular iS at 1200 K and another surface is insulated. Painted panels,…

A: In order to proceed with the problem following assumptions need to be taken into consideration. The…

Q: A masonry cavity wall consists of 100-mm common bricks, 90-mm air space, 100-mm concrete blocks made…

A: Given data: (a) A masonry cavity wall consists of 100-mm common bricks, 90-mm air space, 100-mm…

Q: The nature of surfaces affects the absorption and the reflection of radiation. Assume that you are…

A: The black painted piece of wood will absorb more heat when the given two pieces of the wood used for…

Q: A silicon wafer of diameter D120 mm, and emissivity of 0.6 is at an initial temperature of Ti 325oC…

Q: A long electrical conductor of 10 mm diameter is concentric with a refrigerated cylindrical tube of…

A: Givendiameter of conductor d=10mm=0.01mElectrical conductor has a surface emissivity ε1= 0.6…

Q: A building window pane that is 1.68 m high and 1.12 m wide is separated from the ambient air by a…

A: Assume that both glasses are having uniform temperature with negligible radiation transfer. Refer to…

Question

Problem: Convection related

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A long wire 0.7 mm in diameter with an emissivity of 0.9 is placed in a large quiescent air space at 270 K. If the wire is at 800 K, calculate the net rate of heat loss. Discuss your assumptions.
1.13 If the outer air temperature in Problem is –2°C, calculate the convection heat transfer coefficient between the outer surface of the window and the air, assuming radiation is negligible.
2. A heater is a thin vertical panel 1.0m long and 0.7m high and is used in a warehouse to keep workers warm. The heater has air circulating on each side. Assume the maximum temperature of the panel is 60°C (already above the board line that is safe for human hands to touch briefly without getting hurt). Assume the room air temperature is 18°C but the warehouse wall temperature is 5°C. Model the surface with an emittance of 0.9 and Vair = 1.57x105 m²/s. a. Determine the maximum power rating for the heater. b. Now if you run the heat by standing on its side (it will be 1.0 m high and 0.7 m long), determine the surface temperature. c. Compare case a and b and explain any differences you see.
Please help to my question
2. Consider a vertical, single-pane window of width = height = 1 m. The interior surface is exposed to the air and walls of a room, which are each at 18°C. Under cold ambient conditions for which a thin layer of frost has formed on the inner surface, what is the heat loss through the window? As with most natural convection problems, radiation heat transfer may NOT be neglected. Use Trad =EσA (T-T4) with & = 0.90.
A long pipe 5 cm in diameter passes through a room and is exposed to air at atmospheric pressure and temperature of 20.C. The pipe surface temperature is 93°C Assuming that the emissivity of the pipe is 0.6 calculate the radiation heat loss per meter of length of pipe
A horizontal steam pipe with an outside diameter of 60.0 mm passes through a large room whose walls are at a temperature of 298 K. The outer surface of the pipe wall has a surface temperature of 443 K and an emissivity of 0.8. The air temperature in the room is 303 K. Calculate the rate of heat loss per unit length of the pipe by radiation and natural convection.
3. An electric immersion heater, 10 mm in diameter and 300 mm long, is rated at 550 W. The emissivity of the heater is ε = 0.85. a) If the heater is horizontally positioned in a large tank of water at 20°C, estimate its surface temperature. b) If the heater is accidentally operated in air at 20°C, estimate the surface temperature. Hint: Radiation heat transfer can be neglected in liquids, but not in gases like air.
Calculate the thickness of the magnesia insulation necessary to restrict the heat loss to 5 BTU/hr-ft2 through the walls of a furnace having inside and ambient temperatures of 1500 oF and 150 oF, respectively. The furnace wall is ¼ in, steel plate and 3 in refractory lining. Thermal conductivity in BTU/hr –ft-oF are kref = 0.6, ksteel = 26, kmag=0.03
2. Losses by Natural Convection from diameter and 121.9 mm Cylinder. A vertical cylinder 76.2 mm in high is maintained at 397.1 K at its surface. It loses heat by natural convection to air at 294.3 K. Heat is lost from the cylindrical side and the flat circular end at the top. Calculate the heat loss, neglecting radiation losses. Use the simplified equations of Table 15.5-2 and those equations for the lowest range of NGr Npr. The equivalent L to use for the top flat surface is 0.9 times the diameter. Ans. q 26.0 W a 11
Spacecraft must be cooled via radiative mechanisms, and one means of doing this is by using radiation fins. In many instances, these fins are heated rods that protrude from the spacecraft. Assume that the rod is of length, L; cross-sectional are, Ac; and perimeter, Pā. Its base temperature is T, and the rod has thermal conductivity and emissivity, λ and ɛ, respectively. Set up the differential equation describing the temperature profile within the rod assuming that space is a blackbody at Ts.
Question: a) We want to increase heat transfer by placing fans to provide forced convection to reduce the length of the pipe necessary (Note that the outside surface temperature of the pipe remains the same at 100oC). What is the rate of heat transfer from pipe to the air per meter length if the air speed over the pipe surface is 5m/s? What is the total length of the pipe necessary? Problem: Consider a rectangular warehouse with the dimensions of 40m long x 20m widex10m height. The overall heat transfer coefficient for all sidewalls is Uwall=0.3 W/m2K (Approx. R=20 hr.ft2.oF/Btu) and for the flat roof, it is Uroof= 0.20W/m2K. The floor can be assumed to be insulated and we can ignore the heat transfer through the doors, etc. We want to maintain the inside air temperature at 15oC while the outside temperature is 0oC by using a thin-walled, 5.0cm diameter copper pipe that carries steam. Steam enters the pipe as saturated vapor at 100oC. So, as it starts losing heat to the inside air, it…