A horizontal curve with spiral curves on either sides is to be designed along a highway. The deflection angle (A) for the road will be 70°, while the spiral length and spiral angle are designed to be 1300 ft and 18“, respectively. (round off the numbers to 2 decimal places) a) Find the radius for the circular curve. b) If the Station for Plc is chosen to be 100+0.00 ft, find the Stations for ST.

A horizontal curve with spiral curves on either sides is to be designed along a highway. The deflection angle (A) for the road will be 70°, while the spiral length and spiral angle are designed to be 1300 ft and 18“, respectively. (round off the numbers to 2 decimal places) a) Find the radius for the circular curve. b) If the Station for Plc is chosen to be 100+0.00 ft, find the Stations for ST.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

answer question 28 only
A highway designer wants to introduce a spiral curve system into a new design that has a V = 100 km/h and n = 4. For a curve system that has R = 1200 m., compute the minimum length of the spiral curves to be used. A 52.083 m B 55.556 m C) 56.250 m D) 57.600 m
It is necessary to lay out a simple curve by deflection angles. The curve is to connect two tangents with an intersection angle of 320 and a radius of 240.00 meters. Compute the deflection angles to each full stations on the curve if the transit is set up at PC which is at Station (5 + 767.20m). Find the station of PT. Illustrate the figure and tabulate the results.
3 Horizontal curves You are asked to design a 5-degree horizontal curve with an intersection angle at the center equals 60°15'. The station of point of curvature is 155 + 26.5 ft. Calculate the following: A. Length of the curve B. Station of the point of tangency (PT) C. For first two whole stations next to PC, calculate the degree of deflection from the PC and chord length from the previous point along the horizontal curve.
answer question 26 only
A horizontal curve with a deflection angle of 60o30' and degree of curvature of 5o as shown in Figure 5 is to be set out at whole station intervals of 100ft. If the point of curvature (PC) is located at a station 121+25.66, determine.i. the length of the curve and the station of PTii. the deflection angles VAp, VAq, VAv and Vas
limit to 3 decimal places
2
need please
the deflection angles of two intermediate points x and y on a simple curve measured from the tangent passing through pc are 6.97° and 12.8°, respectively. the distance along the curve between x and y is 34.72 m. compute the for the degree of curve in degrees. use arc basis.
Survey
answer question 27 only